On the formulation of anisotropic-polyaxial failure criteria: a comparative study

À propos
Confidentialité
Mentions légales

Graph Chatbot

Publications associées (29)

Micro-addition of Fe in highly alloyed Cu-Ti alloys to improve both formability and strength

Cyril Cayron, Roland Logé, Baptiste Thomas Jean Rouxel

Cu-Be alloys provide excellent electrical and mechanical properties, but present serious health hazards during manufacturing. Among alternative alloys, the Cu-Ti system has the highest yield strength; however, Ti cannot be easily solutionized at concentrat ...

ELSEVIER SCI LTD2022

Prediction of crack nucleation and propagation in porous ceramics using the phase-field approach

Arata Nakajo

The relevance of the phase-field approach to simulate the fracture in porous ceramics has been investigated. For this purpose, the conditions for the crack initiation using the phase-field model have been compared to the theoretical predictions of the coup ...

ELSEVIER2022

Understanding the mechanisms of adhesive wear for heterogeneous materials through atomistic simulations

Jean-François Molinari, Sacha Zenon Wattel, Antonio Joaquin Garcia Suarez

When two rough surfaces slide against each other, two main behaviors can be observed at the asperity level: A ductile behavior where the asperities tend to smooth out or a brittle behavior where the asperities detach and form debris. Recently, a critical l ...

2022

The influence of the kinematics of rough surface engagement on the transfer of forces in cracked concrete

Miguel Fernández Ruiz

One of the most instrumental aspects governing the response of structural concrete at ultimate limit state refers to the possibility of developing smeared cracking patterns within a member (associated normally to the presence of sufficient reinforcement fo ...

2021

Origami-inspired carbon fiber-reinforced composite sandwich materials - Fabrication and mechanical behavior

Thomas Keller, Yuntong Du

A folding fabrication method inspired by origami for carbon fiber-reinforced composites to fabricate three-dimensional structures is presented. PMI foams serve as substrates, making it possible to manufacture this kind of origami-inspired composite sandwic ...

ELSEVIER SCI LTD2021

Multiaxial fatigue behavior and strengthening of riveted double-angle connections in steel bridges using prestressed CFRP rods

Hossein Heydarinouri

A large number of aging road and railway riveted metallic bridges suffer from fatigue problems. Stringer-to-floor-beam double-angle bridge connections are among the most fatigue-prone details due to the many cyclic distortion-induced stresses from axle loa ...

EPFL2021

Onset of sliding across scales: How the contact topography impacts frictional strength

Jean-François Molinari, Fabian Barras, Ramin Aghababaei

When two solids start rubbing together, frictional sliding initiates in the wake of slip fronts propagating along their surfaces in contact. This macroscopic rupture dynamics can be successfully mapped on the elastodynamics of a moving shear crack. However ...

AMER PHYSICAL SOC2021

Effect of water on sandstone's fracture toughness and frictional parameters: Brittle strength constraints

Marie Estelle Solange Violay, Corentin Jean-Marie Rémi Noël

Water presence causes a dramatic reduction of sandstone strength. Under compressive stress conditions, the strength of a rock sample is controlled by frictional parameters and the fracture toughness of the material. Here, we report fracture toughness, fric ...

2021

Shear Response of Wet Weak Carbonate Rock/Grout Interfaces Under Cyclic Loading

Eleni Stavropoulou

The development and construction of offshore wind farms requires the correct estimation of the friction that can be mobilised at the rock/grout interface. In conventional studies, the shear behaviour of a joint is usually investigated with laboratory tests ...

2021

Page 2 sur 2