Publications associées à Solidification behavior of PLLA/nHA nanocomposites

Publications associées (38)

Effects of physiotherapy and home-based training in parkinsonian syndromes: protocol for a randomised controlled trial (MobilityAPP)

All rights reserved.Introduction Gait and mobility impairment are pivotal signs of parkinsonism, and they are particularly severe in atypical parkinsonian disorders including multiple system atrophy (MSA) and progressive supranuclear palsy (PSP). A pilot s ...

2024

Field-controlled multicritical behavior and emergent universality in fully frustrated quantum magnets

Bruce Normand

Phase transitions in condensed matter are a source of exotic emergent properties. We study the fully frustrated bilayer Heisenberg antiferromagnet to demonstrate that an applied magnetic field creates a previously unknown emergent criticality. The quantum ...

Nature Portfolio2024

Melting pseudosymmetry and thermal expansion in 3-benzoylpropionic acid

Tomasz Poreba

The thermal behavior of 3-benzoylpropionic acid (BPA) was investigated using single-crystal and synchrotron powder X-diffraction, as well as differential scanning calorimetry analysis. The study revealed the existence of two subtly distinct structures of B ...

ROYAL SOC CHEMISTRY2023

Tailor-made Piezoelectric Elastomer Materials

Francis Owusu

Recent advancements in miniature devices with higher computational capabilities and ultralow power consumption have accelerated the development of wearable sensors, actuators, and energy harvesters everywhere. The ultimate aim of such a technological revol ...

EPFL2023

Incorporation of Lignin in Bio-Based Resins for Potential Application in Fiber-Polymer Composites

Mateus De Assunção Hofmann

Bio-based resins, obtained from renewable raw materials, are a more sustainable alternative to oil-based resins for fiber-reinforced polymer (FRP) composites. The incorporation of lignin in those resins has the potential to enhance their performance. This ...

MDPI2023

Characterisation and hydration kinetics of beta-C2S synthesised with K2SO4 as dopant

Karen Scrivener, Franco Alberto Zunino Sommariva

In this study, a protocol for synthesising beta-C2S using K2SO4 as a dopant has been reported. Quantitative X-Ray diffraction was used to characterise synthesised samples. It was observed that it is possible to synthesise beta-C2S with high purity (>96 wt% ...

Pergamon-Elsevier Science Ltd2023

Effects of Electrode Design on the Melt Electrowriting of Sinusoidal Structures

Biranche Tandon

Melt electrowriting is a microscale manufacturing technique that uses polymer-based melts to create fibrous structures. An electric field is used to stabilize a continuous molten jet, which is then written onto a substrate as a microscale fiber. Herein, it ...

WILEY-V C H VERLAG GMBH2023

Hydrogen-sieving zeolitic films by coating zeolite nanosheets on porous polymeric support

Kumar Varoon Agrawal, Luis Francisco Villalobos Vazquez de la Parra, Mostapha Dakhchoune, Xuekui Duan

The synthesis of high-performance gas-sieving zeolitic film is challenging because it involves seeded secondary growth which is complex and difficult to reproduce. Additionally, expensive asymmetric inorganic porous supports are often needed for calcinatio ...

ELSEVIER2023

Detecting whether a stochastic process is finitely expressed in a basis

Victor Panaretos, Neda Mohammadi Jouzdani

Is it possible to detect if the sample paths of a stochastic process almost surely admit a finite expansion with respect to some/any basis? The determination is to be made on the basis of a finite collection of discretely/noisily observed sample paths. We ...

ACADEMIC PRESS INC ELSEVIER SCIENCE2023

Second harmonic scattering of water in a biological context

Tereza Schönfeldová

Water is one of the most abundant molecules in the universe. It forms a hydrogen bond network with unique structure and dynamics. Hydrogen bonding is highly relevant to many biological processes including membrane formation, protein folding, adsorption, an ...

EPFL2022

Effect of chromium content on microstructural evolution of CoNiAlW superalloy

Cyril Cayron

Effects of chromium (Cr) content on types and morphologies of various phases of a newly developed Co-Ni-Al-W superalloy (Co-30Ni-6W-9Al-3Ti-1Ta) have been investigated in this study. Microstructural examinations were carried out by field-emission scanning ...

SPRINGER HEIDELBERG2022

Effects of Ball Milling and TiF3 Addition on the Dehydrogenation Temperature of Ca(BH4)2 Polymorphs

Andreas Züttel

The changes introduced by both ball milling and the addition of small amounts of TiF3 in the kinetics of the hydrogen desorption of three different Ca(BH4)2 polymorphs (α, β and γ) have been systematically investigated. The samples with different polymorph ...

2020

Reusability of filtering facepiece respirators after decontamination through drying and germicidal UV irradiation

Véronique Michaud, Guillaume Suarez, David Vernez

Introduction During pandemics, such as the SARS-CoV-2, filtering facepiece respirators plays an essential role in protecting healthcare personnel. The recycling of respirators is possible in case of critical shortage, but it raises the question of the effe ...

2020

Structural properties of organometalic halide perovskite and their application in photodetectors

Anastasiia Glushkova

Hybrid organometallic halide perovskites have been intensively investigated in the past years as highly efficient light harvesters for various optoelectronic applications for both sensing and emitting light. However, many open questions remain regarding th ...

EPFL2020

Visualizing the importance of oxide-metal phase transitions in the production of synthesis gas over Ni catalysts

Stéphane François Jean Poitel

Synthesis gas, composed of H-2 and CO, is an important fuel which serves as feedstock for industrially relevant processes, such as methanol or ammonia synthesis. The efficiency of these reactions depends on the H-2 : CO ratio, which can be controlled by a ...

2020

Coupled segregation mechanisms of Sc, Zr and Mn at theta ' interfaces enhances the strength and thermal stability of Al-Cu alloys

Baptiste Thomas Jean Rouxel

The refinement and thermal stability of intermediate theta-prime (theta') precipitates are critical in the development of new high strength 2xxx series aluminium-copper (Al-Cu) alloys for high temperature applications. In this work, we use trace additions ...

PERGAMON-ELSEVIER SCIENCE LTD2021

Effect of surface modification of colloidal silica nanoparticles on the rigid amorphous fraction and mechanical properties of amorphous polyurethane-urea-silica nanocomposites

John Christopher Plummer, Nicolas Candau, Oguzhan Oguz

Colloidal silica nanoparticles (NPs) modified with eight different silane coupling agents were incorporated into an amorphous poly(tetramethylene oxide)-based polyurethane-urea copolymer matrix at a concentration of 10 wt % (4.4 vol %) in order to investig ...

2019

One-dimensional facile growth of MAPbI(3) perovskite micro-rods

Mohammad Khaja Nazeeruddin

One-dimensional microrods (4-5 mm) of PbI2 and CH3NH3PbI3 (MAPbI(3)) with unique structural and morphological properties have been grown at room temperature. X-ray diffraction (XRD) patterns of both types of micro-rods exhibit a hexagonal system (P3m1(164) ...

2019

Promoting Persistent Superionic Conductivity in Sodium Monocarba-closo-dodecaborate NaCB11H12 via Confinement within Nanoporous Silica

Mirjana Dimitrievska

Superionic phases of bulk anhydrous salts based on large cluster-like polyhedral (carba)borate anions are generally stable only well above room temperature, rendering them unsuitable as solid-state electrolytes in energy-storage devices that typically oper ...

AMER CHEMICAL SOC2021

Evaluation of the Effect of Backsheet Properties on PV Encapsulant Degradation under Ultraviolet-Damp-Heat Conditions

Djamel Eddine Mansour

The reliability of photovoltaic (PV) modules is highly determined by the durability of the polymeric components (backsheet and encapsulant). The power degradation and failure of PV modules can be caused by changes in the physical, chemical, and mechanical ...

EPFL2021