New Approaches for Carbon Nanotubes-Based Biosensors and Their Application to Cell Culture Monitoring

À propos
Confidentialité
Mentions légales

Graph Chatbot

Publications associées (29)

Electron imaging of gas diffusion electrodes for proton exchange membrane fuel cells

Michele Bozzetti

The current energy crisis demands the development of new sustainable energy sources and devices with low environmental impact, including in the field of electrochemical cells. Mass transport limitations can reduce the overall performance of the device by l ...

EPFL2023

Electrode Impact on the Electrical Breakdown of Dielectric Elastomer Thin Films

Herbert Shea, Fabio Beco Albuquerque

Dielectric Elastomer Actuators (DEAs) enable the realization of energy-efficient and compact actuator systems. DEAs operate at the kilovolt range with typically microampere-level currents and hence minimize thermal losses in comparison to low voltage/high ...

MDPI2023

Local electrochemical and thermal investigation of a segmented reversible solid oxide fuel cell and electrolyzer

Stefan Diethelm, Jan Van Herle, Zacharie Wuillemin, Audrey Désirée Wesoly, Hamza Moussaoui

A novel setup has been designed and mounted to investigate the local electrochemical and thermal behavior of a cell from a 4-cell short stack under reversible operation solid oxide fuel cell/solid oxide electrolyzer (SOFC/SOE). It consists in the partition ...

Pergamon-Elsevier Science Ltd2023

Development of new volcano-shaped microelectrodes for single cell electrochemistry, electrophysiology and impedance studies

Nicolas Grégoire Maïno

Micro- nano-electrodes have demonstrated superior performances in measuring attenuated intracellular action potentials from electrogenic cell cultures compared to traditional multi-electrode arrays. Yet, the understanding of the critical electrode features ...

EPFL2023

Multiphysics model for assessing photoelectrochemical phenomena under concentrated irradiation

Sophia Haussener, Isaac Thomas Holmes-Gentle, Franky Esteban Bedoya Lora

A multiphysics model was developed for a photoelectrochemical (PEC) cell at the device level to simulate water splitting operating under concentrated irradiation (between 50 to 600 kW m−2). The 2D model couples charge, heat, mass, photon, and momentum tran ...

2023

Effects of Electrode Design on the Melt Electrowriting of Sinusoidal Structures

Biranche Tandon

Melt electrowriting is a microscale manufacturing technique that uses polymer-based melts to create fibrous structures. An electric field is used to stabilize a continuous molten jet, which is then written onto a substrate as a microscale fiber. Herein, it ...

WILEY-V C H VERLAG GMBH2023

Tungsten oxide-based photoanodes: biomass valorization and the effects of oxygen vacancies

Nukorn Plainpan

Tungsten oxide-based materials have unique and intriguing properties as photoanode materials for solar energy conversion. The first part of the thesis focuses on the use of WO3 photoanodes for the oxidation of 5-(hydroxymethyl)furfural (HMF). Chapter one l ...

EPFL2023

Highly Efficient and Air-Stable Inorganic Perovskite Solar Cells Enabled by Polylactic Acid Modification

Feng Liu, Yong Ding

Inorganic perovskite solar cells (PSCs) suffer from serious carrier recombination and open-circuit voltage loss because of surface defects and unfavorable energy level alignment. Herein, a polylactic acid (PLA) modification approach to improve the performa ...

WILEY-V C H VERLAG GMBH2023

Fluoride-Rich, Organic-Inorganic Gradient Interphase Enabled by Sacrificial Solvation Shells for Reversible Zinc Metal Batteries

Jun Lu, Lei Zhang, Kangning Zhao, Xu Zhang

Zinc metal batteries are strongly hindered by water corrosion, as solvated zinc ions would bring the active water molecules to the electrode/electrolyte interface constantly. Herein, we report a sacrificial solvation shell to repel active water molecules f ...

Amer Chemical Soc2023

Page 2 sur 2