La diffusion Brillouin dans les fibres optiques : étude et application aux capteurs distribués

Among all non-linear optical effects observed in single-mode optical fibres, stimulated Brillouin scattering (SBS) is of particular importance since it has numerous practical implications. SBS occurs when laser waves are scattered through the interaction of light with hypersonic acoustic waves in the medium. It manifests through the generation of a backscattered Stokes wave that carries most of the input optical power once a definite intensity level is reached within the fibre core. It limits the maximum optical power that can be transmitted through an optical fibre and therefore can cause a severe penality for fibre optics telecommunications. The backscattered Stokes wave is down shifted in frequency with respect to the incident lightwave frequency. This frequency shift – often called the Brillouin frequency shift – depends on the fibre parameters and on the wavelength of the incident light. It is directly proportional to the acoustic velocity and ranges from 12 to 13 GHz for silica fibres at a 1.3 µm wavelength. The Brillouin frequency shift is also very sensitive to environmental quantities changing the acoustic velocity such as temperature and strain. This feature makes SBS very interesting for temperature and strain monitoring in optical fibres and has been used in the design of fibre optics sensors. In the present work, a novel method to measure SBS characteristics in single-mode optical fibres has been developed. It is based on the so-called pump and probe technique using two counterpropagating optical waves within the test fibre. It basically presents the originality to require only one laser source and relies on an electro-optic modulator to generate the probe signal by microwave modulation of the pump light. The inherent high stability of the experimental set-up has made possible the characterisation of different fibres in terms of SBS parameters with a higher accuracy than the traditional two lasers set-up. The influence of dopant concentration in silica fibres on the SBS properties has been fully characterised. Furthermore it has been determined that the presence of core dopants decreases the acoustic velocity resulting in a smaller Brillouin frequency shift. The temperature and strain effects on the SBS characteristics have been extensively investigated. The problem of the evolution of the polarisation of the interacting lightwaves has been studied and a model clarified the so far unexplained behaviour in low birefringence fibres. A new measurement procedure has been defined to achieve polarisation-independent Brillouin gain determination. The second facet of the present thesis deals with the concept of distributed fibre optics sensors based on SBS. The determination of the Brillouin frequency shift gives access to the temperature or strain experienced by the fibre, while a modified OTDR technique provides the information on the position. Here again the use of a single laser source together with an electro-optic modulator brings seve