Publications associées à Electromechanically induced absorption in a circuit nano-electromechanical system

Publications associées (31)

A 0.14-nJ/b 200-Mb/s 2.7-3.5-GHz Quasi-Balanced FSK Transceiver With PLL-Based Modulation and Sideband Energy Detection

This paper describes a balanced frequency shift keying (FSK) modulation, namely quasi-balanced FSK (QB-FSK), for energy-efficient high-data-rate communication. Not suffering from data-pattern dependency, the proposed modulation method enables frequency mod ...

2024

Stability Analysis of Input-Series/Output-Parallel Solid-State Transformers Equipped with Second-Order Harmonic Active Power Filters

Drazen Dujic, Andrea Cervone, Tianyu Wei

Solid-State Transformers with Input-Series/Output-Parallel configuration offer a convenient solution for AC/DC conversion due to their scalability and modularity. In this configuration, each module experiences a second-order harmonic ripple caused by local ...

2024

Three-wave-mixing quantum-limited kinetic inductance parametric amplifier operating at 6 T near 1 K

Camille René Charles Roy, Pasquale Scarlino, Simone Frasca, Guillaume Beaulieu

Parametric amplifiers play a crucial role in modern quantum technology by enabling the enhancement of weak signals with minimal added noise. Traditionally, Josephson junctions have been the primary choice for constructing parametric amplifiers. Nevertheles ...

American Physical Society (APS)2024

Biomaterial devices on Arecanut palm leaf for microwave applications

Anja Skrivervik, Sujith Raman

This paper presents an investigation on the possibility of arecanut palm leaf as a biomaterial substrate for various microwave devices such as transmission lines, antenna, filter and a radio frequency identification device (RFID). The dielectric properties ...

IEEE2023

Intelligent RF System for Ultra Low Power Spectrum Sensing with Machine Learning

Naci Pekçokgüler

The crowdedness of the RF spectrum constitutes problems in communication, however it also accommodates large amount of useful information. This information can be used to determine existing signals and operating contexts. However, spectrum condition varies ...

EPFL2024

Toward Band n78 Shear Bulk Acoustic Resonators Using Crystalline Y-Cut Lithium Niobate Films With Spurious Suppression

Luis Guillermo Villanueva Torrijo, Soumya Yandrapalli

This work presents the study of suspended Y-cut Lithium Niobate shear bulk acoustic resonators for wide band filter applications in the frequency range of 3.5-4.5GHz. The resonators consist of a Lithium Niobate film with Aluminum top interdigitated electro ...

Institute of Electrical and Electronics Engineers2023

Transparent structured conductive coating for applications in smart windows

Jérémy Jacques Antonin Fleury

Solar radiation reaching the surface of the earth for a period of one hour contains more energy than that consumed by mankind over an entire year. Some of this solar energy is already collected by photovoltaic cells to cover the electricity needs of buildi ...

EPFL2023

Numerical and experimental investigations of a microwave interferometer for the negative ion source SPIDER

Ivo Furno, Rémy Jacquier, Riccardo Agnello

The electron density close to the extraction grids and the co-extracted electrons represent a crucial issue when operating negative ion sources for fusion reactors. An excessive electron density in the plasma expansion region can indeed inhibit the negativ ...

IOP Publishing Ltd2023

Beam homogeneity of caesium seeded SPIDER using a direct beamlet current measurement

Basile Marie Jacques Pouradier Duteil

The ITER Heating Neutral Beam (HNB) source prototype SPIDER (Source for the Production of Ions of Deuterium Extracted from a Radio frequency plasma), hosted at the Neutral Beam Test Facility (NBTF) in Padova, Italy, has recently started operating with evap ...

ELSEVIER SCIENCE SA2023

Single Chip Dynamic Nuclear Polarization Microsystems

Nergiz Sahin Solmaz

Nuclear magnetic resonance (NMR) methods are powerful tools employed in many fields, including physics, chemistry, material science, biology, and medicine. The use of NMR methodologies in an even wider range of applications is often hindered by the relativ ...

EPFL2023

Biodegradable materials as sensitive coatings for humidity sensing in S-band microwave frequencies

Leticia de Sousa, Danick Briand, Nicolas Francis Fumeaux, James Alec Pierce Bourely

Worldwide, electronic waste represents the fastest-growing stream of waste. With an increasing number of connected devices, passive and eco-friendly environmental sensing solutions need to be developed. Wireless passive devices for RFID and sensing exist, ...

2023

Fully reconfigurable MEMS-based second-order coupled-resonator optical waveguide (CROW) with ultra-low tuning energy

Niels Quack, Alain Yuji Takabayashi

Integrated microring resonators are well suited for wavelength-filtering applications in optical signal processing, and cascaded microring resonators allow flexible filter design in coupledresonator optical waveguide (CROW) configurations. However, the imp ...

Optica Publishing Group2023

Nanomechanical resonators with low dissipation for quantum optomechanics

Alberto Beccari

Fields of technology as diverse as microwave filter construction, characterization of material interfaces with atomic precision, and detection of gravitational waves from astronomical sources employ mechanical resonators at their core. The utility of mecha ...

EPFL2023

Measuring electro-adhesion pressure before and after contact

Herbert Shea, Sylvain Thomas Schaller

Electro-adhesion (EA) is a low-power, tunable, fast and reversible electrically-controlled adhesion method, effective on both conducting and insulating objects. Typically, only the electro-adhesive detachment force, i.e., the force required to separate an ...

Nature Portfolio2023

Exploring the effectiveness of using internal CNC system signals for chatter detection in milling process

Dimitrios Kyritsis, Xiaochen Zheng

Chatter is a harmful self-excited vibration that commonly occurs during milling processes. Data -driven chatter detection and prediction is critical to achieve high surface quality and process efficiency. Most existing chatter detection approaches are base ...

ACADEMIC PRESS LTD- ELSEVIER SCIENCE LTD2023

Analysis of the influence of errors in DNA-based image coding

Touradj Ebrahimi, Michela Testolina, Davi Nachtigall Lazzarotto

In the last decade, DNA has been increasingly investigated as an alternative medium for cold data storage, presenting several advantages over standard hard drives such as a higher density, longer lifespan and lower energy consumption. However, such coding ...

2023

Investigation of the interplay between Electron-Cyclotron waves, suprathermal electrons and turbulence in tokamak plasmas

Jean Arthur Cazabonne

Electron-Cyclotron waves are routinely used in tokamaks to heat the plasma and to drive current through the electron channel. Their unique ability to drive very localized current renders them the main foreseen tool for neoclassical tearing mode mitigation ...

EPFL2023

Unsupervised Voice Activity Detection by Modeling Source and System Information using Zero Frequency Filtering

Mathew Magimai Doss, Eklavya Sarkar

Voice activity detection (VAD) is an important pre-processing step for speech technology applications. The task consists of deriving segment boundaries of audio signals which contain voicing information. In recent years, it has been shown that voice source ...

ISCA2022

Ultra-Small Bent Meta-Waveguide Filters

Romain Christophe Rémy Fleury, Maliheh Khatibi Moghaddam

This paper demonstrates the capability of locally resonant metamaterials (LRMs) for creating compact metallic waveguide E- and H-bends, which are simultaneously working as bandpass filters. For creating these bent meta-filters, we use composite pin-pipe wa ...

IEEE2022

Applicability of the landscape evolution model in the absence of rills

David Andrew Barry, Andrea Rinaldo, Paolo Perona, Seifeddine Jomaa, Andrea Cimatoribus, Mohsen Cheraghi

Despite numerous applications of physically-based models for incised landscapes, their applicability for overland flow on unchanneled surfaces is not known. This work challenges a widely used landscape evolution model for the case of non-uniform rainfall a ...

2022