Publications associées à The effect of bias in gas temperature measurements on the control of a Solid Oxide Fuel Cells system

Publications associées (36)

Print-light-synthesis of electrocatalytically active gas diffusion electrodes for fuel cell applications

Hubert Girault, Kumar Varoon Agrawal, Luc Sébastien Bondaz

The present work reports a simple approach to manufacture electrocatalytically active gas diffusion electrodes (GDEs) in two steps: (i) inkjet printing and (ii) flash light irradiation from a xenon flash lamp, a process called Print-light-synthesis (PLS). ...

Royal Society of Chemistry2025

Absolute Temperature Sensing in the 67-350 K Range Using Brillouin Scattering in Gases

Luc Thévenaz, Yuting Yang

This paper proposes a novel temperature sensing method using stimulated Brillouin scattering in a hollow-core fiber filled with gas. Compared to classical Brillouin sensors, the Brillouin response of gases shows a higher sensitivity at cryogenic temperatur ...

SPIE2025

Heat transfer in the entrance region of annular laminar flow with constant and different heat flux on two walls

Yasemen Kuddusi

Heat transfer differs in the regions where the flow is developed and developing thermally. These regions can be differentiated by using the thermal entry length. Many researchers have presented correlations to determine the thermal entry length for natural ...

WILEY-V C H VERLAG GMBH2025

Electrochemical devices and computer science: water/thermal management of proton exchange membrane fuel cells and electrolyzers in different scales

Hossein Pourrahmani

The current restrictions on the registration of combustion engines in different countries and the harmful impacts of fossil fuels on the environment and human health have motivated decision-makers to use batteries and/or fuel cells as alternatives for comb ...

EPFL2023

Reversible photo-electrochemical device for solar hydrogen and power generation

Sophia Haussener, Saurabh Yuvraj Tembhurne, Alexandre Dominique M. Cattry, Matthieu Jonin, Mahendra Patel

A reversible photo-electrochemical device operating under concentrated irradiation could offer a stand-alone solution for producing solar fuel (in photo-driven electrolysis mode) and power (in fuel cell mode). This strategy would present the advantage of h ...

2024

Design and assessment of an evaporating water-cooled methanation reactor for a SOE-based power-to-methane system

Philippe Aubin

The transition towards clean renewable energy sources, where wind and solar are prone to variation, requires adequate energy storage. Power-to-methane (PtM) systems can be part of the solution. Specifically, solid-oxide-electrolyser (SOE) based PtM systems ...

EPFL2024

Room-temperature quantum optomechanics using an ultralow noise cavity

Tobias Kippenberg, Guanhao Huang, Nils Johan Engelsen, Alberto Beccari

At room temperature, mechanical motion driven by the quantum backaction of light has been observed only in pioneering experiments in which an optical restoring force controls the oscillator stiffness1,2. For solid-state mechanical resonators in which oscil ...

Nature Portfolio2024

Spinel Protective Coatings for Solid Oxide Cell (SOC) Interconnects (ICs)

Samaneh Daviran

Abstract The degradation of metal interconnects (ICs) in Solid Oxide Cells (SOCs) primarily results from chromium (Cr) oxide scale growth on stainless-steel substrates, causing ohmic loss and air-side electrode poisoning by Cr. This thesis addresses these ...

EPFL2024

Computational fluid dynamics simulations of the heat transfer properties of graphene-based nanolubricants and application to hydrodynamic lubrication

Roberto Guarino

In this paper, we consider experimental data available for graphene-based nanolubricants to evaluate their convective heat transfer performance by means of computational fluid dynamics (CFD) simulations. Single-phase models with temperature-dependent prope ...

Aip Publishing2024

Sensitivity Analysis of the Lumped Thermal Model of the EU 170 GHz Gyrotron Magnetron Injection Gun

Jean-Philippe Hogge, Francisco Sanchez

The ITER Electron Cyclotron Resonance Heating and Current Drive (ECRH&CD) system relies on 1 MW 170 GHz Gyrotrons to provide the mm-wave power needed for plasma heating, current drive, and magneto-hydrodynamic control. The design and modeling of the contro ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Membrane electrode assembly simulation of anion exchange membrane water electrolysis

Zoé Mury, Jan Van Herle, Suhas Nuggehalli Sampathkumar, Khaled Lawand

Anion exchange membrane water electrolysis (AEMWE) offers a green hydrogen production method that eliminates the need for platinum group metals (PGM) as electrocatalysts. This study employs a COMSOL (R) 6.0 model to simulate a 1x1 cm(2) Ni fibre - Raney (R ...

Elsevier2024

Turbulence and Heat exchange in the Near-Surface Boundary Layer over Patchy Snow

Michael Haugeneder

The atmospheric layer adjacent to the earth's surface is of crucial importance for weather models due to the exchange of energy between the surface and the atmosphere. This exchange is dependent on the various surface properties and influences the state of ...

EPFL2024

Thermal conductivity of Li 3 PS 4 solid electrolytes with ab initio accuracy

Michele Ceriotti, Federico Grasselli, Davide Tisi, Lorenzo Gigli

The vast amount of computational studies on electrical conduction in solid-state electrolytes is not mirrored by comparable efforts addressing thermal conduction, which has been scarcely investigated despite its relevance to thermal management and (over)he ...

Amer Physical Soc2024

Unearthing the foundational role of anharmonicity in heat transport in glasses

Paolo Pegolo

The time-honored Allen -Feldman theory of heat transport in glasses is generally assumed to predict a finite value for the thermal conductivity, even if it neglects the anharmonic broadening of vibrational normal modes. We demonstrate that the harmonic app ...

Amer Physical Soc2024

Quantifying mass transport limitations in a microfluidic CO2 electrolyzer with a gas diffusion cathode

Sophia Haussener, Venu Gopal Agarwal

A gas diffusion electrode (GDE) based CO2 electrolyzer shows enhanced CO2 transport to the catalyst surface, significantly increasing current density compared to traditional planar immersed electrodes. A two-dimensional model for the cathode side of a micr ...

2024

In Situ Synthesis of CuxO/N Doped Graphdiyne with Pyridine N Configuration for Ammonia Production via Nitrate Reduction

Sophia Haussener, Jian Li, Roberto Valenza

Electroreduction of nitrate to ammonia provides an interesting pathway for wastewater treatment and valorization. Cu-based catalysts are active for the conversion of NO3− to NO2− but suffer from an inefficient hydrogenation process of NO2−. Herein, CuxO/N- ...

2024

Innovative thermophysical characterization of an ATF composite cladding: the case of silicon carbide

Andrea Cavaliere

Nuclear power is a powerful technology that plays an important role in the fight against climate change, and research is continuously engaged in studies that could further improve its safety. After the Fukushima accident, Accident Tolerant Fuels research h ...

EPFL2024

Plasmoid drift and first wall heat deposition during ITER H-mode dual-SPIs in JOREK simulations

Mengdi Kong

The heat flux mitigation during the thermal quench (TQ) by the shattered pellet injection (SPI) is one of the major elements of disruption mitigation strategy for ITER. It's efficiency greatly depends on the SPI and the target plasma parameters, and is ult ...

IOP Publishing Ltd2024

Magneto-Thermoelectric Transport in Graphene Quantum Dot with Strong Correlations

Oleksandr Kriuchkov

Disorder at etched edges of graphene quantum dots (GQD) enables random all-to-all interactions between localized charges in partially filled Landau levels, providing a potential platform to realize the Sachdev-Ye-Kitaev (SYK) model. We use quantum Hall edg ...

2024

Performance of energy piles foundation in hot-dominated climate: A case study in Dubai

Lyesse Laloui, Elena Ravera, Sofie Elaine ten Bosch

Energy piles represent an innovative technology that can help provide sustainable geothermal heating or cooling energy for thermal conditioning purposes. In hot-dominated climates, the interest is to inject heat in the ground and extract energy for space-c ...

Pergamon-Elsevier Science Ltd2024