Publications associées à Effect of transverse load on the critical current of a coated conductor Roebel cable

Publications associées (32)

Instabilities in Elastic and Magneto-Elastic Beams and Shells: from Shell Buckling to the Design of a Programmable Braille Reader

In this thesis, we conduct a comprehensive investigation into structural instabilities of both elastic and magneto-elastic beams and shells, resulting in a creative proposal to design a programmable braille reader. Methodologically, we combine numerical si ...

EPFL2024

DC Power Distribution Networks with Direct Current Transformers

Renan Pillon Barcelos

The shift towards DC power distribution networks, enabled by power electronics technologies, is changing the nature of electrical power systems. Nowadays, DC power distribution networks can effectively support the high penetration of distributed energy res ...

EPFL2024

Static and Dynamic Voltage Balancing for an IGCT-Based Resonant DC Transformer

Drazen Dujic, Renan Pillon Barcelos, Nikolina Djekanovic

This paper focuses on the operational characteristics of a medium voltage resonant DC transformer based on a split capacitor IGCT 3L-NPC leg. The study delves into both the dynamic and static balancing aspects of the 3L-NPC when operating in a two-level, 5 ...

2024

Polarization-enhanced GaN Schottky barrier diodes: Ultra-thin InGaN for high breakdown voltage and low Ron

Elison de Nazareth Matioli, Alessandro Floriduz, Zheng Hao

In this work, we present a concept that leverages the strong piezoelectric polarization field in InGaN, which counteracts the external electric field at reverse bias. We show that despite the smaller InGaN band-gap and lower critical electric field, its st ...

2024

Performance Comparison of Cables With Partial Transposition

Pierluigi Bruzzone, Kamil Sedlák, Chiara Frittitta, Federica Demattè

The need of full transposition of the current carrying elements (strands) in large cables is frequently retained as top design criterion for conductors operating in pulsed mode. However, when the transposition error, i.e., the inductance difference among t ...

IEEE Institute of Electrical and Electronics Engineers2024

Modeling, Optimization and Design of High Power Medium Frequency Transformers

Nikolina Djekanovic

Nowadays, direct current (DC) technology is increasing its presence in alternating current (AC) power systems. This trend is enabled by the progress in energy conversion through semiconductor devices and power electronics. Therefore, it is possible to imag ...

EPFL2023

Dynamics analysis for DC transformers integration in hybrid AC‐DC power distribution networks

Drazen Dujic, Andrea Cervone, Renan Pillon Barcelos, Jules Christian Georges Macé, Max Dupont

In AC/DC power distributions networks, power converters are interfacing buses to ensure DC voltage regulation and power distribution. Active front ends are used between AC and DC buses and two typical control schemes that can be implemented are voltage reg ...

2023

A 0.21-ps FOM Capacitor-Less Analog LDO with Dual-Range Load Current for Biomedical Applications

Yasemin Engür, Mahsa Shoaran

This paper presents an output capacitor-less low-dropout regulator (LDO) with a bias switching scheme for biomedical applications with dual-range load currents. Power optimization is crucial for systems with multiple activation modes such as neural interfa ...

ArXiv2023

Electromechanical investigations and quench experiments on sub-size HTS cables for high field EU-DEMO Central Solenoid

Ortensia Dicuonzo

The aim of this thesis is to investigate the mechanical and thermal behaviour of HTS coated conductor cables for EUROfusion DEMO magnets. One of the issue in large HTS magnets is the safety against a quench. A quench is a sudden thermal runway in which the ...

EPFL2022

Design Optimization of a MW-level Medium Frequency Transformer

Drazen Dujic, Nikolina Djekanovic

Nowadays, with the increased interest in applications dealing with high-power medium-voltage conversion, there is a strong need to master the design of medium-frequency transformers, which are one of the key components of modern DC transformers. The paper ...

2022

Inductive Power Transfer System for Auxiliary Power Supply in Medium Voltage Converters

Drazen Dujic, Chengmin Li, Xiaotong Du

Inductive power transfer technology is an attractive solution for medium voltage applications by eliminating the need for high voltage cables or wired connections in general. This paper introduces an inductive power transfer system which has multiple indep ...

2022

Preliminary Design of a High Current R&W TF Coil Conductor for the EU DEMO

Pierluigi Bruzzone, Kamil Sedlák, Federica Demattè

Paschen failures in ITER, W7-X and JT60 superconducting coils at the acceptance tests have shown that it is highly desirable to lower the coil discharge voltage (U-d) of the DEMO Toroidal Field (TF) coils. Another benefit of lowering the U-d might be the r ...

IEEE Institute of Electrical and Electronics Engineers2022

Nonlinear electro-mechanical coupling and thermally stimulated currents in relaxor ferroelectrics

Lukas Riemer

In this work, the emergence of polarization and electro-mechanical coupling in Pb(Mg1/3Nb2/3)O3 and Pb(Mg1/3Nb2/3)O3 â PbTiO3 was investigated by means of thermally stimulated current, and nonlinear dielectric and electro-mechanical measurements. The pre ...

EPFL2022

High frequency IGCT operation for DC transformer

Gabriele Ulissi

In spite of the dominance of ac technology for the vast majority of power transmission and distribution since the late 19th century, the past decades have seen an increase in use of dc electrical power. In particular, this has been the case both in high vo ...

EPFL2022

Shoot-Through Protection for an IGCT-Based ZVS Resonant DC Transformer

Drazen Dujic, Jakub Kucka

IGCTs have successfully demonstrated to be well-suited devices for an application in medium-voltage dc transformers based on LLC resonant converter topology. This application enables unusually high switching frequencies in kHz range thanks to the zero-volt ...

2022

Persistence of variant selection in red gold alloys

Roland Logé, Cyril Cayron, Margaux Nathalie Dominique Larcher

Recently, a new thermally activated distortion with amplification (TADA) effect has been reported in red gold alloys caused by the A1 -> L1(0) phase transformation. The macroscopic amplification is due to the persistence of variant selection nucleated unde ...

ELSEVIER SCIENCE SA2022

PUS3-related disorder: Report of a novel patient and delineation of the phenotypic spectrum

Alessandro Borghesi

PUS3 encodes the pseudouridylate synthase 3, an enzyme catalyzing the formation of tRNA pseudouridine, which plays a critical role in tRNA structure, function, and stability. Biallelic pathogenic variants of PUS3 have been previously associated with severe ...

WILEY2022

The influence of the kinematics of rough surface engagement on the transfer of forces in cracked concrete

Miguel Fernández Ruiz

One of the most instrumental aspects governing the response of structural concrete at ultimate limit state refers to the possibility of developing smeared cracking patterns within a member (associated normally to the presence of sufficient reinforcement fo ...

2021

Defect engineered nanostructured LaFeO3 photoanodes for improved activity in solar water oxidation

Xavier Pereira Da Costa, Kevin Sivula, Liang Yao, Mounir Driss Mensi, Nestor Guijarro Carratala, Yongpeng Liu

LaFeO3 (LFO) is recognized as a candidate material for solar water oxidation, but its photoelectrochemical response remains modest and stagnant. With the aim of advancing LFO photoanodes for the oxygen evolution reaction (OER), here, a nanorod array-type e ...

Royal Society of Chemistry2021

Impact of Embedded Liquid Cooling on the Electrical Characteristics of GaN-on-Si Power Transistors

Elison de Nazareth Matioli, Luca Nela, Remco Franciscus Peter van Erp, Armin Jafari, Palliyage Srilak Nirmana Perera, Catherine Erine

Wide-Band-Gap semiconductors have enabled considerable miniaturization of power devices, which requires, however, new thermal management solutions to handle the resulting high heat fluxes. Recently, embedded liquid cooling in GaN-on-Si devices was demonstr ...

Institute of Electrical and Electronics Engineers2021