Publications associées à Effect of a second layer on the time to failure of compressed riprap as mountain riverbank protection

Publications associées (30)

Capsizing due to friction-induced twist in the failure of stopper knots

Pedro Miguel Nunes Pereira de Almeida Reis, Paul Johanns

We investigate the failure mechanism of stopper knots, with a particular focus on the figure -8 knot as a representative example. Stopper knots are widely used in climbing, sailing, racket stringing, and sewing to maintain tension in ropes, strings, or thr ...

Elsevier2024

Reliability analysis and partial safety format calibration considering the characteristics of the resistance of reinforced concrete structures

Qianhui Yu

Every engineering calculation is an approximation of reality, with inevitable uncertainties involved. This fact implies that a reliability verification accounting for the uncertainties is a necessary step in the design and assessment of structures. Nowaday ...

EPFL2023

Reliable Microsecond-Scale Distributed Computing

Athanasios Xygkis

The landscape of computing is changing, thanks to the advent of modern networking equipment that allows machines to exchange information in as little as one microsecond. Such advancement has enabled microsecond-scale distributed computing, where entire dis ...

EPFL2023

Fatigue behavior and life prediction of wind turbine blade composite materials

Anastasios Vassilopoulos

Fatigue life prediction of wind turbine rotor blades is a very challenging task, as their failure is led by different failure types that act synergistically. Inherent defects like wrinkles, fiber misalignments, and voids that can be introduced during fabri ...

Woodhead Publishing (Elsevier)2023

Effect of fiber architecture on tension-tension fatigue behavior of bolted basalt composite joints

Thomas Keller, Lulu Liu

The effect of fiber architecture, i.e., unidirectional (UD) vs. multi-directional (MD), on the tension-tension fa-tigue behavior of bolted double-lap basalt composite joints was experimentally investigated. The fatigue load-life (F -N) curves of MD and UD ...

ELSEVIER SCI LTD2023

A Data-Knowledge Hybrid Driven Method for Gas Turbine Gas Path Diagnosis

Dimitrios Kyritsis, Jinzhi Lu

Gas path fault diagnosis of a gas turbine is a complex task involving field data analysis and knowledge-based reasoning. In this paper, a data-knowledge hybrid driven method for gas path fault diagnosis is proposed by integrating a physical model-based gas ...

MDPI2022

Review of degradation and failure phenomena in photovoltaic modules

Sameh Ahmad Kantoush

The degradation of photovoltaic (PV) systems is one of the key factors to address in order to reduce the cost of the electricity produced by increasing the operational lifetime of PV systems. To reduce the degradation, it is imperative to know the degradat ...

PERGAMON-ELSEVIER SCIENCE LTD2022

Efficient Bootstrapping for Approximate Homomorphic Encryption with Non-sparse Keys

Jean-Pierre Hubaux, Juan Ramón Troncoso-Pastoriza, Jean-Philippe Léonard Bossuat, Christian Vincent Mouchet

We present a bootstrapping procedure for the full-RNS variant of the approximate homomorphic-encryption scheme of Cheon et al., CKKS (Asiacrypt 17, SAC 18). Compared to the previously proposed procedures (Eurocrypt 18 & 19, CT-RSA 20), our bootstrapping pr ...

SPRINGER INTERNATIONAL PUBLISHING AG2021

Soil-structure interaction of surface footings

Lyesse Laloui, Cristiano Garbellini

Limit-state analysis of soil-structure interacting systems is a classical problem in theoretical and applied soil mechanics. Usually, the capacities of both components are evaluated separately. However, it is well known that soil-structure interaction play ...

2021

Study on Mechanical Performance of Prestressed UHPFRC U-Beam Bridges

Eugen Brühwiler

The forms of U-shaped UHPFRC beams have not been investigated for the highway footbridge. Compared with the traditional section forms, the U-shaped UHPFRC beams can reduce the material consumption under the condition of providing the same bearing capacity. ...

2021

Onset of sliding across scales: How the contact topography impacts frictional strength

Jean-François Molinari, Ramin Aghababaei, Fabian Barras

When two solids start rubbing together, frictional sliding initiates in the wake of slip fronts propagating along their surfaces in contact. This macroscopic rupture dynamics can be successfully mapped on the elastodynamics of a moving shear crack. However ...

AMER PHYSICAL SOC2021

Optimization of multi-directional fiber architecture for resistance and ductility of bolted FRP profile joints

Thomas Keller, Lulu Liu

In view of the low structural efficiency of bolted joints in pultruded fiber-reinforced polymer (FRP) profiles with mainly unidirectional (UD) fiber architecture, off-axis plies were considered as an effective way to improve bolted joint performance. An ex ...

ELSEVIER SCI LTD2020

Variational phase-field continuum model uncovers adhesive wear mechanisms in asperity junctions

Jean-François Molinari, Sylvain Collet

Wear is well known for causing material loss in a sliding interface. Available macroscopic approaches are bound to empirical fitting parameters, which range several orders of magnitude. Major advances in tribology have recently been achieved via Molecular ...

2020

Statistical Fatigue Investigation and Failure Prediction of a Healable Composite System

Nathan Klaus Hostettler, Véronique Michaud, Amaël Maximilien Cohades

Fiber reinforced polymers are massively used as an alternative to metals in structural applications. The brittle nature of their matrix, however, makes them more susceptible to crack formation and propagation resulting in costly repair operations and incre ...

2020

Can automotive MEMS be reliably used in space applications? An assessment method under sequential bi-parameter testing

Volker Gass, Olha Sereda, Maxime Auchlin

Commercial Off-The-Shelf (COTS) automotive inertial measurement units were subjected to severe accumulative stress conditions: thermal shocks (high temperature gradients), temperature cycling (low gradients) and mechanical vibration are combined in an A-th ...

PERGAMON-ELSEVIER SCIENCE LTD2020

Stability of flexible thin-film metallization stimulation electrodes: analysis of explants after first-in-human study and improvement ofin vivoperformance

Silvestro Micera, Stanisa Raspopovic, Francesco Maria Petrini

Objective.Micro-fabricated neural interfaces based on polyimide (PI) are achieving increasing importance in translational research. The ability to produce well-defined micro-structures with properties that include chemical inertness, mechanical flexibility ...

2020

Joining of Oxide Dispersion-Strengthened Steel Using Spark Plasma Sintering

Cyril Cayron

Difficulties with joining oxide dispersion-strengthened (ODS) steels using classical welding processes have led to the development of alternative joining techniques such as spark plasma sintering (SPS). SPS, which is classically employed for performing sin ...

2020

Numerical investigation of the mixed-mode failure of snow

Johan Alexandre Philippe Gaume

The failure of a weak snow layer underlying a cohesive slab is the primary step in the release process of a dry snow slab avalanche. The complex and heterogeneous microstructure of snow limits our understanding of failure initiation inside the weak layer, ...

2019

Model-based real-time plasma electron density profile estimation and control on ASDEX Upgrade and TCV

Federico Alberto Alfredo Felici, Cristian Galperti

Real-time plasma electron density profile estimation and control are essential in the operation of future tokamaks. In particular, the robustness against diagnostics failure and disturbances is important for long pulse operation. ...

ELSEVIER SCIENCE SA2019

Experiment and Machine Protection from Fast Losses caused by Crab Cavities in the High Luminosity LHC

Andrea Santamaría García

The High Luminosity Large Hadron Collider (HL-LHC) upgrade aims for a tenfold increase in integrated luminosity compared to the nominal Large Hadron Collider (LHC), and for operation at a leveled luminosity five times higher than the nominal LHC peak lumin ...

EPFL2018