Publications associées à Recent progress in research on tungsten materials for nuclear fusion applications in Europe

Experimental study and interpretative modelling of the Power Exhaust in Configurations with Multiple X-Points in TCV

Nuclear fusion presents a promising clean energy source to mitigate future energy crises, with magnetic confinement fusion well-positioned to provide a baseload scenario to power future reactors. The unmitigated power exhaust of such reactors threatens its ...

EPFL2024

Innovative thermophysical characterization of an ATF composite cladding: the case of silicon carbide

Andrea Cavaliere

Nuclear power is a powerful technology that plays an important role in the fight against climate change, and research is continuously engaged in studies that could further improve its safety. After the Fukushima accident, Accident Tolerant Fuels research h ...

EPFL2024

Demonstration of a sparse sensor placement technique to the limited diagnostic set in a fusion power plant

Lorenzo Martinelli, Artur Perek

DEMO will have a limited diagnostic set for optimization of reactor performance, and limited diagnostic coverage due to challenging reactor conditions. This poses challenges for control, especially for detachment control which is planned to be performed wi ...

Elsevier Science Sa2024

Gamma noise to non-invasively monitor nuclear research reactors

Pavel Frajtag, Andreas Pautz, Oskari Ville Pakari, Vincent Pierre Lamirand, Tom Mager

Autonomous nuclear reactor monitoring is a key aspect of the International Atomic Energy Agency’s strategy to ensure nonproliferation treaty compliance. From the rise of small modular reactor technology, decentralized nuclear reactor fleets may strain the ...

Nature Research2024

Neutron-Gamma Noise Measurements in a Zero-Power Reactor Using Organic Scintillators

Andreas Pautz, Oskari Ville Pakari, Vincent Pierre Lamirand

Noise measurements in light water reactor systems aid in generating validation data for integral point kinetic parameter predictions and generating monitoring parameters for reactor safety and safeguards. The CROCUS zero-power reactor has been used to supp ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Gamma-ray Spectroscopy in Low-Power Nuclear Research Reactors

Andreas Pautz, Oskari Ville Pakari, Vincent Pierre Lamirand

Gamma-ray spectroscopy is an effective technique for radioactive material characterization, routine inventory verification, nuclear safeguards, health physics, and source search scenarios. Gamma-ray spectrometers typically cannot be operated in the immedia ...

MDPI2024

Plasmoid drift and first wall heat deposition during ITER H-mode dual-SPIs in JOREK simulations

Mengdi Kong

The heat flux mitigation during the thermal quench (TQ) by the shattered pellet injection (SPI) is one of the major elements of disruption mitigation strategy for ITER. It's efficiency greatly depends on the SPI and the target plasma parameters, and is ult ...

IOP Publishing Ltd2024

Models implemented in the methodological approach to design the initial STEP first wall contour

Kevin Henricus Annemarie Verhaegh, Dario Vaccaro, Filippo Bagnato, Davide Galassi

The official Spherical Tokamak for Energy Production mission aims to demonstrate the ability to generate net electricity from fusion with the STEP Prototype Power plant. One of the key technological and engineering challenges in fusion power plants is mana ...

Elsevier Science Sa2024

Full-discharge simulation and optimization with the RAPTOR code, from present tokamaks to ITER and DEMO

Simon Van Mulders

Tokamak devices aim to magnetically confine a hydrogen plasma at sufficiently high pressure to achieve net energy production from nuclear fusion of light isotopes. Predictive modeling and optimization is crucial for reliable operation of tokamak reactors, ...

EPFL2023

Integrated modelling of neon impact on JET H-mode core plasmas

Yann Camenen, Michele Marin

Nuclear fusion reactor plasmas will need to exhaust a significant proportion of energy flux through radiative processes, to enable acceptable divertor loads. This can be obtained by line radiation from impurities, injected from the plasma edge. There are h ...

IOP Publishing Ltd2023

A holistic investigation of photocatalytic hydrogen generation

Sangram Ashok Savant

Photocatalytic (PC) solar hydrogen production is a promising way to provide green hydrogen using only sunlight and abundant reactants such as water. PC approaches use catalytically active semiconductor particles suspended in liquid electrolytes. The partic ...

EPFL2023

Extension of GeN-Foam to departure from nucleate boiling prediction and validation against the OECD/NRC PSBT benchmark

Alessandro Scolaro, Carlo Fiorina, Hao Qin, Yuhang Niu

The prediction of departure from nucleate boiling (DNB) has always been a crucial aspect of thermal-hydraulic codes for the analysis of Light Water Reactors. In this paper, GeN-Foam, a multi-physics code developed based on OpenFOAM, has been enhanced to in ...

Elsevier Science Sa2023

Design and operational guidelines of solar-driven catalytic conversion of CO2 and H2 to fuels

Sophia Haussener, Sha Li

Sunlight-powered catalytic conversion of CO2 and (green) H2 into fuels and chemicals via Sabatier and reverse water gas shift (RWGS) processes offers a promising solution to reduce greenhouse gas emissions and increase renewable energy utilization. The suc ...

ELSEVIER SCI LTD2023

Monte Carlo analysis of BWR geometries using a cycle check-up methodology

Abdelhamid Dokhane, Hakim Ferroukhi, Alexander Vasiliev, Mathieu Hursin, Dimitri Rochman

Recent fuel anomalies at a Swiss power plant have motivated the development at PSI of the "Cycle Check-Up" (CHUP) methodology which consists in performing Monte Carlo transport calculations using nuclide compositions and thermal-hydraulic boundary conditio ...

Pergamon-Elsevier Science Ltd2023

3D Characterisation of Turbulent Plasma Filaments Using Gas Puff Imaging in the Tokamak à Configuration Variable

Nicola Offeddu

A key challenge for the development of fusion reactors based on magnetic confinement, such as tokamaks and stellarators, is the control of the turbulent processes. The most prominent feature of turbulence in the Scrape-Off Layer (SOL), the volume between t ...

EPFL2023

Exploration of the parameter space for the excitation and saturation of Edge Harmonic Oscillations

Guillermo Bustos Ramirez

This thesis presents advancements in the understanding of the plasma conditions leading to the excitation and saturation of the Edge Harmonic Oscillations (EHOs) observed during QH-mode operation in tokamak plasmas. Such operations represent a safer altern ...

EPFL2023

First developments towards producing inductive magnetic sensors using state-of-the-art photolithography techniques

Duccio Testa, Ambrine Douhane, Marcus Cemes

Inductive magnetic sensors are needed for tokamak operation to provide the low-frequency (LF) measurements leading to the equilibrium reconstruction and to monitor the higher frequency (HF) instabilities; the HF magnetic sensors are often also used as a ba ...

2023

Validation of D-T fusion power prediction capability against 2021 JET D-T experiments

Mikhail Maslov, Javier García Hernández, Michele Marin

JET experiments using the fuel mixture envisaged for fusion power plants, deuterium and tritium (D-T), provide a unique opportunity to validate existing D-T fusion power prediction capabilities in support of future device design and operation preparation. ...

IOP Publishing Ltd2023

On the development of multi-physics tools for nuclear reactor analysis based on OpenFOAM (R): state of the art, lessons learned and perspectives

Carlo Fiorina

In the last two decades, the use of OpenFOAM as a multi-physics library for nuclear applications has grown from a sporadic use for exploratory studies to a widespread application for the analysis of innovative reactor concepts and highly complex problems. ...

ELSEVIER SCIENCE SA2022

Advanced methodologies for modeling and assessment of SFR safety functions

Janos Bodi

The present doctoral work was performed to contribute to the conceptual design development and safety assessment of a Generation IV Sodium Fast Reactor (SFR) in the frame of the European Sodium Fast Reactor Safety Measures Assessment and Research Tools (ES ...

EPFL2022