Publications associées à Poly-Phased Matrix Converter - A 27 input phases to 3 output phases experimental set-up running with hard and soft commutations

Publications associées (31)

DC Power Distribution Networks with Direct Current Transformers

The shift towards DC power distribution networks, enabled by power electronics technologies, is changing the nature of electrical power systems. Nowadays, DC power distribution networks can effectively support the high penetration of distributed energy res ...

EPFL2024

Static and Dynamic Voltage Balancing for an IGCT-Based Resonant DC Transformer

Drazen Dujic, Renan Pillon Barcelos, Nikolina Djekanovic

This paper focuses on the operational characteristics of a medium voltage resonant DC transformer based on a split capacitor IGCT 3L-NPC leg. The study delves into both the dynamic and static balancing aspects of the 3L-NPC when operating in a two-level, 5 ...

2024

Ripple Voltage and Loss Reduction of Single-Phase ISOP SST by Eliminating the Second Harmonic Current in LLC Converters

Drazen Dujic, Andrea Cervone, Tianyu Wei

In two-stage solid-state transformers with input-series output-parallel structure, the LLC converter operating at a fixed switching frequency is a common choice for the isolated DC/DC conversion stage because it can provide a high efficiency and a fixed vo ...

2024

Modeling and optimization of PCB coils for inductive power transfer systems

Xiaotong Du

The auxiliary power supply for medium voltage converters requires high insulation capability between the source and the load. Inductive power transfer technology, with an air gap between the primary and secondary coil, offers such high insulation capabilit ...

EPFL2024

Stability Analysis of Second-Order Harmonic Active Filters for Input-Series/Output- Parallel Solid State Transformers

Drazen Dujic, Andrea Cervone, Tianyu Wei

Solid-State Transformers with Input-Series/Output- Parallel configuration offer a convenient solution for AC/DC power conversion, thanks to their modularity, scalability and flexibility. However, as known, they are affected by a second-order harmonic rippl ...

2024

Active Power Decoupling for Single-Phase Input-Series-Output-Parallel Solid-State Transformers

Drazen Dujic, Andrea Cervone, Tianyu Wei

Solid-state transformers with input-series outputparallel structures are being considered for a variety of applications requiring MVAC to LVDC conversion. Due to the singlephase AC/DC conversion at the input side, all floating cells of the solid-state tran ...

2024

Phase Shift Angle Segmentation Modulation for Soft-Switching Medium-Voltage DAB Converter With Series-Connected SiC MOSFETs

Chengmin Li

The medium-voltage (MV) dual active bridge (DAB) converter with series-connected SiC (S-SiC) MOSFETs is a promising solution for high-power-density isolated dc/dc converter. To improve the voltage sharing and reliability of S-SiC, relatively large snubber ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Stability Analysis of Input-Series/Output-Parallel Solid-State Transformers Equipped with Second-Order Harmonic Active Power Filters

Drazen Dujic, Andrea Cervone, Tianyu Wei

Solid-State Transformers with Input-Series/Output-Parallel configuration offer a convenient solution for AC/DC conversion due to their scalability and modularity. In this configuration, each module experiences a second-order harmonic ripple caused by local ...

2024

High energy-density electrostatic actuators for soft robotics

Sylvain Thomas Schaller

This thesis reports high energy-density electrostatic actuators for use in soft robotics. This thesis has two main parts: a) a detailed study of electro-adhesion using microfabricated electrodes, and b) a flexi-ble fiber-shaped linear motor. Electro-adhesi ...

EPFL2024

Minkowski Distance Based Pilot Protection for Tie Lines Between Offshore Wind Farms and MMC

Wenlong Liao

Offshore wind farms (OWFs) with modular multilevel converter high-voltage dc (MMC-HVdc) have become an important form of renewable energy utilization. However, if a fault occurs at the tie line between the MMC and the OWF, the fault steady-state current at ...

2024

Power performance of a model floating wind turbine subjected to cyclic pitch motion: A wind tunnel study

Fernando Porté Agel, Guiyue Duan, Daniele Gattari

Wind tunnel experiments were performed with a miniature floating wind turbine model to study the effects of cyclic pitch motion on its power performance. The cyclic pitch motion was prescribed by two key parameters: pitch frequency and amplitude. The power ...

IOPscience2024

Dc-Link Ripple Suppression of Cascaded H-Bridge Based MV Grid Emulator Apparatus for Analysis and Testing of Grid-Tied Converters in Distribution System

Drazen Dujic, Chengmin Li

The medium-voltage grid emulator is gaining popularity for testing grid-code compliance of large-capacity converters for renewable energy resources. The cascaded H-bridge converter based on active-front-ends is a promising candidate for high-power grid emu ...

2023

DC Transformer Impact on Voltage Dynamics in Hybrid AC-DC Power Distribution Networks

Drazen Dujic, Andrea Cervone, Renan Pillon Barcelos, Jules Christian Georges Macé, Max Dupont

AC/DC power distribution networks use various types of power converters to interconnect their buses, active front ends between AC and DC buses, and DC transformers between DC buses. Different active front end control methods, like voltage or power regulati ...

VDE Verlag2023

Modeling, Optimization and Design of High Power Medium Frequency Transformers

Nikolina Djekanovic

Nowadays, direct current (DC) technology is increasing its presence in alternating current (AC) power systems. This trend is enabled by the progress in energy conversion through semiconductor devices and power electronics. Therefore, it is possible to imag ...

EPFL2023

Computational design and additive manufacturing of electromagnetic coils

Adrien Jean-Michel Thabuis

The modern world is heavily reliant on electromagnetic devices to convert mechanical energy into electrical energy and vice versa. These devices are fundamental to powering our society, and the growing need for automated production lines and electrified tr ...

EPFL2023

On Energy Control of Modular Multilevel Converters

Milan Utvic

Owing to the advancements in the area of power electronics, efficient and flexible ac to dc conversion is made possible, bringing back into focus the idea of the dc power transmission at various voltage levels. Several technical and economical factors advo ...

EPFL2023

A review of the modeling approaches of the lightning M-component with special attention to their current and electric field characteristics

Farhad Rachidi-Haeri, Marcos Rubinstein, Mohammad Azadifar, Carlo Alberto Nucci

In this paper, we present the characteristics of current, electric fields and modeling approaches of lightning M-component mode of charge transfer. We consider both the classical M-components (occurring after return strokes) and M-component-type ICC (Initi ...

Elsevier2023

Control upgrade for the TCV coils power supplies

Damien Fasel, Ugo Siravo, Jérémie Dubray, Nicolas Cherix

The Tokamak a` Configuration Variable (TCV) coil converters are fed, during the plasma pulse, by a flywheel generator (FG) providing the AC voltages few seconds before the plasma pulse. The synchronization with the 120 Hz frequency delivered by the FG, var ...

ELSEVIER SCIENCE SA2023

Harmonic Power-Flow Study of Hybrid AC/DC Grids with Converter-Interfaced Distributed Energy Resources

Mario Paolone, Andreas Martin Kettner, Yihui Zuo, Johanna Kristin Maria Becker

As the share of Converter-Interfaced Distributed Energy Resources (CIDERs) in power distribution systems increases, hybrid AC/DC distribution systems are drawing more interest. Indeed, CIDERs usually rely on DC power and hybrid AC/DC grids with few Network ...

IEEE2023

Dynamics analysis for DC transformers integration in hybrid AC‐DC power distribution networks

Drazen Dujic, Andrea Cervone, Renan Pillon Barcelos, Jules Christian Georges Macé, Max Dupont

In AC/DC power distributions networks, power converters are interfacing buses to ensure DC voltage regulation and power distribution. Active front ends are used between AC and DC buses and two typical control schemes that can be implemented are voltage reg ...

2023