Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Concept

Oxyde de zinc

Publications associées (31)

Ultrafast carrier dynamics and insights in defect mechanism of p-type colloidal ZnO QDs

Jacques-Edouard Moser, Andrea Cannizzo, Etienne Christophe Socie, Camila Bacellar Cases Da Silveira, Victoria Kabanova

In this study, we place a strong emphasis on understanding the ultrafast dynamics of carrier recombination pathways in p-type ZnO, especially in the midgap region. Synthesizing and controlling the properties of p-type ZnO remains a pivotal yet challenging ...

SPIE2024

Tailoring p-Type Behavior in ZnO Quantum Dots through Enhanced Sol–Gel Synthesis: Mechanistic Insights into Zinc Vacancies

Jacques-Edouard Moser, Andrea Cannizzo, Etienne Christophe Socie, Camila Bacellar Cases Da Silveira, Victoria Kabanova

The synthesis and control of properties of p-type ZnO is crucial for a variety of optoelectronic and spintronic applications; however, it remains challenging due to the control of intrinsic midgap (defect) states. In this study, we demonstrate a synthetic ...

2024

HASPIDE: a project for the development of hydrogenated amorphous silicon radiation sensors on a flexible substrate

Giovanni De Cesare, Sylvain Dunand, Luca Massimiliano Antognini, Jonathan Emanuel Thomet

Hydrogenated amorphous silicon (a-Si:H) is a material with a very good radiation hardness and with the possibility of deposition on flexible substrates like Polyimide (PI). Exploiting these properties, the HASPIDE (Hydrogenated Amorphous Silicon PIxels DEt ...

Iop Publishing Ltd2024

Nanostructure and Optical Property Tailoring of Zinc Tin Nitride Thin Films through Phenomenological Decoupling: A Pathway to Enhanced Control

Aïcha Hessler-Wyser, Johann Michler, Caroline Hain, Daniele Casari

This work addresses the need for precise control of thin film sputtering processes to enable thin film material tailoring on the example of zinc tin nitride (ZTN) thin films deposited via microwave plasma-assisted high power reactive magnetron sputtering ( ...

Amer Chemical Soc2024

Colloidal Atomic Layer Deposition on Nanocrystals Using Ligand-Modified Precursors

Raffaella Buonsanti, Anna Loiudice, Petru Pasquale Albertini, Ona Segura Lecina, Philippe Benjamin Green, Jari Leemans, Mark Adrian Newton, Coline Marie Agathe Boulanger, Krishna Kumar

Atomic layer deposition (ALD) is a method to grow thin metal oxide layers on a variety of materials for applications spanning from electronics to catalysis. Extending ALD to colloidally stable nanocrystals promises to combine the benefits of thin metal oxi ...

Amer Chemical Soc2024

Artificial Hydrophilic Organic and Dendrite-Suppressed Inorganic Hybrid Solid Electrolyte Interface Layer for Highly Stable Zinc Anodes

Lei Zhang, Kangning Zhao

Aqueous zinc-ion batteries (AZIBs) have gained significant attentions for their inherent safety and cost-effectiveness. However, challenges, such as dendrite growth and anodic corrosion at the Zn anode, hinder their commercial viability. In this paper, an ...

Amer Chemical Soc2024

Growth and Doping Mechanisms of III-V Nanostructures by Selective Area Epitaxy

Didem Dede

Selective area epitaxy (SAE), applied to semiconductor growth, allows tailored fabrication of intricate structures at the nanoscale with enhanced properties and functionalities. In the field of nanowires (NWs), it adds scalability by enabling the fabricati ...

EPFL2024

Electrochemical Hydrophobic Tri-layer Interface Rendered Mechanically Graded Solid Electrolyte Interface for Stable Zinc Metal Anode

Lei Zhang, Kangning Zhao

The aqueous zinc-ion battery is promising as grid scale energy storage device, but hindered by the instable electrode/electrolyte interface. Herein, we report the lean-water ionic liquid electrolyte for aqueous zinc metal batteries. The lean-water ionic li ...

Wiley-VCH Verlag GmbH2024

Study of growth-induced point defects and their impact on InGaN-based optoelectronic devices

Yao Chen

GaN exhibits a decomposition tendency for temperatures far below its melting point and common growth temperatures used in metal-organic vapour phase epitaxy (MOVPE).This characteristic is known to be a major obstacle for realising GaN bulk substrate. There ...

EPFL2024

Continuous Supercritical Water Impregnation Method for the Preparation of Metal Oxide on Activated Carbon Composite Materials

Christian Ludwig

Metal oxide (MexOy) nanomaterials are used as catalysts and/or sorbents in processes taking place in supercritical water (scH2O), which is the “green” solvent needed to obtain energy-relevant products. Their properties are significantly influenced by the s ...

2024

Phase-stable indium sulfide achieves an energy conversion efficiency of 14.3% for solar-assisted carbon dioxide reduction to formate

Michael Graetzel, Jingshan Luo, Jing Gao, Jun Li

Tremendous efforts have been made in developing highly selective catalysts for electrochemical CO 2 conversion to formate. However, the rapid deactivation resulting from structural reconstruction and phase transition poses considerable challenges to the sy ...

Cell Press2024

Strain engineering and strain measurement by spring tethers on suspended epitaxial GaN-on-Si photonic crystal devices

Romuald Houdré, Jun Wang

Suspended epitaxial gallium nitride (GaN) on silicon (Si) photonic crystal devices suffer from large residual tensile strain, especially for long waveguides, because fine structures tend to crack due to large stress. By introducing spring-like tethers, des ...

Iop Publishing Ltd2024

Magnetism of Single Surface Adsorbed Atoms Studied with Radio-Frequency STM

Clément Marie Soulard

This thesis investigates the magnetic properties of single atoms and molecules adsorbed on thin magnesium oxide decoupling layers, grown on a silver single crystal. To address these systems experimentally, we use a low temperature scanning tunneling micros ...

EPFL2024

Spinel Protective Coatings for Solid Oxide Cell (SOC) Interconnects (ICs)

Samaneh Daviran

Abstract The degradation of metal interconnects (ICs) in Solid Oxide Cells (SOCs) primarily results from chromium (Cr) oxide scale growth on stainless-steel substrates, causing ohmic loss and air-side electrode poisoning by Cr. This thesis addresses these ...

EPFL2024

Voltage-driven Reactivity of Liquid Ga and CuGa Nanoparticles for Electrocatalytic CO2 Reduction and Synthesis

Valery Okatenko

The rising atmospheric level of carbon dioxide, CO2, contributes to climate change and poses urgent need to find scalable solutions both to decrease its emissions and to be able to recycle it, if the goals of Paris Agreement to limit the temperature rise a ...

EPFL2023

Zinc hybrid sintering for printed transient sensors and wireless electronics

Danick Briand, Nicolas Francis Fumeaux

Transient electronics offer a promising solution for reducing electronic waste and for use in implantable bioelectronics, yet their fabrication remains challenging. We report on a scalable method that synergistically combines chemical and photonic mechanis ...

2023

Understanding the growth mechanism of BaZrS3 chalcogenide perovskite thin films from sulfurized oxide precursors

Anna Fontcuberta i Morral, Mirjana Dimitrievska, Elias Zsolt Stutz, Santhanu Panikar Ramanandan, Andrea Giunto

Barium zirconium sulfide (BaZrS3) is an earth-abundant and environmentally friendly chalcogenide perovskite with promising properties for various energy conversion applications. Recently, sulfurization of oxide precursors has been suggested as a viable sol ...

IOP Publishing Ltd2023

Enhanced Leaching of Zinc Ferrite by the Formation of a Solid Solution With Magnetite in Hydrochloric Acid Solution

Marian Nida Sagarino Lumongsod-Thompson

The high zinc and iron contents of electric arc furnace (EAF) dust in the forms of zinc ferrite (ZnFe2O4) and magnetite (Fe3O4) make it a valuable secondary source of these metals. ZnFe2O4 and Fe3O4 are known to form a solid solution at all compositions, a ...

SPRINGER2023

Understanding and mitigating resistive losses in fired passivating contacts: role of the interfaces and optimization of the thermal budget

Christophe Ballif, Franz-Josef Haug, Aïcha Hessler-Wyser, Luca Massimiliano Antognini, Sofia Libraro, Audrey Marie Isabelle Morisset, Julien Hurni, Ezgi Genç

This work presents a study of p-type passivating contacts based on SiCx formed via a rapid thermal processing (RTP) step, using conditions compatible with the firing used to sinter screen-printed metallization pastes in industry. The contributions of the t ...

Elsevier2023

Investigating the Effect of Crystal Morphology on Optoelectronic Properties of Zinc Phosphide Thin Films via Optical-pump Terahertz Probe Spectroscopy

Jean-Baptiste Leran, Mahdi Zamani, Simon Robert Escobar Steinvall, Elias Zsolt Stutz, Rajrupa Paul, Mirjana Dimitrievska, Léa Buswell

Zinc phosphide ( Zn3P2) is a promising earth-abundant material for solar cell applications but calls for the further understanding of its optoelectronic properties. In this work, we perform contact-free and noninvasive optical-pump terahertz probe (OPTP) s ...

IEEE2023