Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Concept

Pince ampèremétrique

Publications associées (30)

Performance of ITER Correction Busbar Conductor Samples CBCN2 and CBCN3

Pierluigi Bruzzone, Kamil Sedlák, Boris Stepanov, Yu Wu, Fang Liu

The correction busbar (CB) conductors for the ITER project are being produced in China. The second China CB conductor sample (CBCN2, Phase II of conductor testing) and the third CB conductor sample (CBCN3, Phase III testing) were made of the WST NbTi stran ...

IEEE Institute of Electrical and Electronics Engineers2016

Coreless Open-Loop Current Transducers Based On Hall Effect Sensor Csa-1V

Radivoje Popovic

The paper provides an overview of coreless open-loop current transducers based on Hall effect sensor CSA-1V. Depending on the implementation method and current range, the presented transducers are divided in the four groups. The transducers are capable to ...

Univ Nis2016

Neuroprosthetic System Restoring Upper Limb Function Through Coordinated Electrical Stimulation

Andrea Biasiucci, Andrea Maesani

Neuroprosthetic device for restoring daily-life action movements of upper limbs in patients suffering from motor impairments. The neuroprosthetic device comprises several non-invasive electrodes adapted to be fixed on a patient body, in a way as to stimula ...

2016

AC and Mechanical Loss Analysis of the ITER PF RF SULTAN Samples

Pierluigi Bruzzone, Boris Stepanov

Analysis of the AC and mechanical losses of PF RF ITER SULTAN sample test results has been performed. Measurements were provided by the gas flow colorimetric method before and after cyclic mechanical loads. The mechanical loss investigation was carried out ...

IEEE Institute of Electrical and Electronics Engineers2016

Locating Faults on Untransposed, Meshed Transmission Networks Using a Limited Number of Synchrophasor Measurements

Mario Paolone, Sadegh Azizi

The method of symmetrical components is not effective for fault location in the case of untransposed lines, due to potential couplings between the sequence circuits. This paper proposes a non-iterative algorithm in the phase-coordinates for wide-area fault ...

IEEE Institute of Electrical and Electronics Engineers2016

Hybrid phase-change — Tunnel FET (PC-TFET) switch with subthreshold swing < 10mV/decade and sub-0.1 body factor: Digital and analog benchmarking

Mihai Adrian Ionescu, Josef Andreas Schuler, Wolfgang Amadeus Vitale, Cem Alper, Anna Krammer, Arnab Biswas, Emanuele Andrea Casu, Teodor Rosca, Nicolò Oliva

In this paper we report the first hybrid Phase-Change - Tunnel FET (PC-TFET) device configurations for achieving a deep sub-thermionic steep subthreshold swing at room temperature and subthreshold power savings. The proposed hybrid device feedbacks the ste ...

IEEE2016

Development of the ITER Continuous External Rogowski: From conceptual design to final design

Duccio Testa, Christian Schlatter, Matthieu Toussaint, Jonathan Bryan Lister, Philippe Marmillod

In ITER, an accurate measurement of plasma current, with high reliability, is mandatory as this parameter is used to demonstrate licensing compliance with regulatory limits. For that purpose, several independent measurements based on magnetic diagnostics h ...

Elsevier Science Sa2015

Electro-thermal virtual prototyping of a Rogowski Coil sensor system

Alain Vachoux, Juan Sebastian Rodriguez Estupinan

An electro-thermal model of a Rogowski Coil sensor system is here described. A co-design methodology between VHDL-AMS and Finite Element Analysis (FEA) has been used for modeling the entire system. The proposed modeling strategy uses geometrical FEA to com ...

IEEE2015

Conductor Performance of TFCN4 and TFCN5 Samples for ITER TF Coils

Pierluigi Bruzzone, Kamil Sedlák, Boris Stepanov, Yu Wu, Fang Liu

The fourth China TF conductor sample (TFCN4) for Phase II, the left leg of the fifth China TF conductor sample (TFCN5) for Phase III, as well as the right leg of the TFCN5 conductor for Phase IV, were made of the WST strands, cabled by Baosheng, jacketed a ...

IEEE Institute of Electrical and Electronics Engineers2014

Sub-mW Reconfigurable Interface IC for Electrochemical Sensing

Giovanni De Micheli, Sandro Carrara, Camilla Baj-Rossi, Seyedeh Sara Ghoreishizadeh, Cristina Boero

The IronIC project has the aim of developing a fully implantable and remotely powered platform for the real- time monitoring of human metabolites. In this paper we present a mixed-signal interface IC for the electrochemical sensing data acquisition chain. ...

IEEE2014