Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Concept

Soudage MIG-MAG

Publications associées (27)

On the Prediction of Hot Tearing in Al-to-Steel Welding by Friction Melt Bonding

Jean-Marie Drezet

Aluminum alloy AA6061 was welded to dual-phase steel 980 (DP980) by the friction melt bonding (FMB) process. Hot tears have been suppressed by controlling the thermomechanical cycle. In particular, the welding speed and the thermal conductivity of the back ...

2018

Fatigue Strength Upgrading of Cover Plate Ends by Welded Extensions in Existing Steel Bridge Girders

Alain Nussbaumer, Dimitrios Lignos, Vasileios Grigoriou

This paper investigates the fatigue upgrading of typical cover plate joint connections in existing steel bridge girders through cover plate extension. The upgraded detail is created by removing the existing transverse end weld, then welding the extension t ...

2018

Interface microstructure formation of dissimilar Fe/Fe-Mn-C steel RSW joints

Léa Deillon

An experiment was developed to simulate the interface between liquid high manganese carbon steel and solid ultra-low alloyed steel in a thermal gradient, corresponding to the nugget/sheet interface of resistance spot welds. Despite the large difference in ...

Elsevier Science Sa2018

Shear loaded friction-welded crosswise arranged timber boards

Yves Weinand, Till Vallée, Benjamin Hahn

Friction welding of wood is a bonding technology that can be used for joining timber elements, and in which the adhesive is formed from thermally modified cell wall material within the substrate during the welding process. In this paper, this principle is ...

2017

Studies on fluid dynamics of the flow field and gas transfer in orbitally shaken tubes

Florian Maria Wurm, David Hacker, Xiao Shen, Dominique Terry Monteil Jr

Orbitally shaken cylindrical bioreactors [OrbShake bioreactors (OSRs)] without an impeller or sparger are increasingly being used for the suspension cultivation of mammalian cells. Among small volume OSRs, 50-mL tubes with a ventilated cap (OSR50), origina ...

American Chemical Society2017

Stability of extended beam-to-girder shear tab connections under gravity induced shear force

Dimitrios Lignos

Extended shear tab connections are widely used to connect beams to the webs of girders. In the full-depth configuration of extended beam-to-girder shear tabs, the shear plate is typically fillet welded to the web, as well as to the top and bottom flanges o ...

Structural Stability Research Council2017

New parametric equations to estimate notch stress concentration factors at butt welded joints modeling the weld profile with splines

Anton Schleiss, Pedro Filipe De Almeida Manso, Alexandre Jean Pachoud

For fatigue life estimation as well as for fatigue testing analysis of welded structures by local stresses approaches, the stress concentration factor (SCF) at the weld must be known. Full penetration butt welded joints are extensively used in steel struct ...

Elsevier2016