Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Concept

Airbreathing jet engine

Publications associées (25)

Smart Acoustic Lining for UHBR Technologies Engine Part 1: Design of an Electroacoustic Liner and Experimental Characterization Under Flow in Rectangular Cross-Section Ducts

Hervé Lissek, Maxime Volery

The new generation of Ultra-High-By-Pass-Ratio (UHBR) turbofan engine while considerably reducing fuel consumption, threatens higher noise levels at low frequencies because of its larger diameter, lower number of blades and rotational speed. This is accomp ...

American Institute of Aeronautics and Astronautics2024

Domain adaptation via alignment of operation profile for Remaining Useful Lifetime prediction

Olga Fink, Ismail Nejjar, Mengjie Zhao

Effective Prognostics and Health Management (PHM) relies on accurate prediction of the Remaining Useful Life (RUL). Data-driven RUL prediction techniques rely heavily on the representativeness of the available time-to-failure trajectories. Therefore, these ...

Elsevier2024

The Advection Boundary Law in presence of mean-flow and spinning modes

In the attempt to reduce fuel consumption, a new generation of Ultra-High-By-Pass-Ratio (UHBR) turbofans have been introduced in the aeronautic industry which are structurally noisier especially at lower frequencies, because of their larger diameter, lower ...

SPIE2024

Indication of 310-Helix Structure in Gas-Phase Neutral Pentaalanine

Vasyl Yatsyna

We investigate the gas-phase structure of the neutral pentaalanine peptide. The IR spectrum in the 340-1820 cm-1 frequency range is obtained by employing supersonic jet cooling, infrared multiphoton dissociation, and vacuum-ultraviolet action spectroscopy. ...

AMER CHEMICAL SOC2023

Robust tunable acoustic impedance control on electroacoustic resonators for aircraft noise reduction

Maxime Volery

Air traffic noise emissions are responsible for a significant part of the overall environmental noise, especially in the vicinity of airports. Exposure to environmental noise is known to negatively impact health and to be associated with cardiovascular dis ...

EPFL2023

uKharon: A Membership Service for Microsecond Applications

Rachid Guerraoui, Javier Picorel Obando, Athanasios Xygkis, Antoine Murat

Modern data center fabrics open the possibility of microsecond distributed applications, such as data stores and message queues. A challenging aspect of their development is to ensure that, besides being fast in the common case, these applications react fa ...

USENIX Association2023

Uncertainty quantification in machine learning for engineering design and health prognostics: A tutorial

Olga Fink, Luca Biggio

On top of machine learning (ML) models, uncertainty quantification (UQ) functions as an essential layer of safety assurance that could lead to more principled decision making by enabling sound risk assessment and management. The safety and reliability impr ...

2023

Search for medium effects using jets from bottom quarks in PbPb collisions at √sNN = 5.02 TeV

Jian Wang, Matthias Finger, Qian Wang, Yiming Li, João Miguel das Neves Duarte, Matthias Wolf, Varun Sharma, Yi Zhang, Lei Zhang, Tian Cheng, Yixing Chen, Alexis Kalogeropoulos, Ioannis Papadopoulos, Hua Zhang, Siyuan Wang, Xin Chen, Michele Bianco, Sebastiana Gianì, Sun Hee Kim, Davide Di Croce, Jian Zhao, Rakesh Chawla, Jan Steggemann, Konstantin Androsov, Anna Mascellani, Federica Legger, Matteo Galli, Gabriele Grosso

The first study of the shapes of jets arising from bottom (b) quarks in heavy ion collisions is presented. Jet shapes are studied using charged hadron constituents as a function of their radial distance from the jet axis. Lead-lead (PbPb) collision data at ...

Elsevier2023

Measurement of the top quark pole mass using t(t)over-bar+jet events in the dilepton final state in proton-proton collisions at √s=13 TeV

A measurement of the top quark pole mass m(t)(pole) in events where a top quarkantiquark pair (t (t) over bar) is produced in association with at least one additional jet ( t (t) over bar +jet) is presented. This analysis is performed using proton-proton c ...

Springer Nature2023

Plunging Circular Jets: Experimental Characterization of Dynamic Pressures Near the Stagnation Zone

Giovanni De Cesare, Pedro Filipe De Almeida Manso, Gregoire Aurelien Marie Jamet

Spillways are a requirement for dams’ safety, mainly preventing overtopping during floods. A common spillway solution involves plunging jets, which dissipate a considerable flow energy in the plunge pool. Energy dissipation has to occur in a controlled man ...

2022

Real-time model calibration with deep reinforcement learning

Olga Fink

The real-time, and accurate inference of model parameters is of great importance in many scientific and engineering disciplines that use computational models (such as a digital twin) for the analysis and prediction of complex physical processes. However, f ...

2022

Ion temperature spectroscopic measurements in high rotation discharges by means of X-ray diagnostic at JET

Henri Weisen

Measurement of the X-ray spectra of the He-like Ni ions (Ni26+) and their dielectronic satellites (Ni25+, Ni24+, and Ni23+) plays a crucial role in determination of electronic and ion temperature of plasma in the JET device. Because n >= 3 satellites of Ni ...

2022

Degradation study on molecules released from laser-based jet injector

Christophe Moser, Barbora Lavickova, Jan Krizek

Development of needle-free methods to administer injectable therapeutics has been researched for a few decades. We focused our attention on a laser-based jet injection technique where the liquid-jet actuation mechanism is based on optical cavitation. This ...

2021

Ion cyclotron resonance heating with shifted separatrix

Jonathan Graves, Hamish William Patten

Ion cyclotron resonance heating, which we refer to as ICRH-SS, with the quasilinear (QL) separatrix (i.e., the separatrix in the space of QL routes of ion acceleration) located in the region of passing particles is studied. The aim of ICRH-SS is to minimiz ...

IOP Publishing Ltd2021

Scale limitations of gas bearing supported turbocompressors for vapor compression cycles

Jürg Alexander Schiffmann

An analysis of single-stage centrifugal compressors supported on dynamic, gas lubricated bearings for driving vapor compression cycles suggests that the maximum feasible compressor power is limited, primarily by the bearing load capacity, in the range from ...

2020

Needle-free delivery of fluids from compact laser-based jet injector

Christophe Moser, Paul Delrot, Jan Krizek

Jet injection devices have been studied and developed for transdermal drug delivery to avoid the use of needles. Due to bulky actuation mechanisms, they are limited to body areas that are easy to reach such as skin. Here, we demonstrate a thin and long liq ...

2020

A Morphing Cargo Drone for Safe Flight in Proximity of Humans

Dario Floreano, Przemyslaw Mariusz Kornatowski, William John Stewart

Delivery drones used by logistics companies today are equipped with unshielded propellers, which represent a major hurdle for in-hand parcel delivery. The exposed propeller blades are hazardous to unsuspecting bystanders, pets, and untrained users. One sol ...

2020

Cavitation induction by projectile impacting on a water jet

Mohamed Farhat

The present paper focuses on the simulation of the high-velocity impact of a projectile impacting on a water-jet, causing the onset, development and collapse of cavitation. The simulation of the fluid motion is carried out using an explicit, compressible, ...

PERGAMON-ELSEVIER SCIENCE LTD2019

In Situ Liquid SAXS Studies on the Early Stage of Calcium Carbonate Formation

Andrea Testino, Agnese Carino, Mohammad Reza Andalibi

Calcium carbonate is a model system to investigate the mechanism of solid formation by precipitation from solutions, and it is often considered in the debated classical and nonclassical nucleation mechanism. Despite the great scientific relevance of calciu ...

2019

High-speed imaging of high pressures produced by cavitation bubbles

Mohamed Farhat, Danail Obreschkow, Outi Supponen

Cavitation bubbles, when correctly tuned, may provide interesting mechanical and chemical effects to their surroundings owing to their violent collapse. Such an event may produce high-speed liquid jetting, extreme heating, as well as pressures of thousands ...

SPIE-INT SOC OPTICAL ENGINEERING2019