Andy BushbyEnseignement et PhD Cours CCMX Advanced Course - Instrumented Nanoindentation MSE-656
Nicholas X. RandallEnseignement et PhD Cours CCMX Advanced Course - Instrumented Nanoindentation MSE-656
Jean-Marie Drezet1992-1996: travail de thèse au Laboratoire de Métallurgie Physique sous la direction du Prof. Michel Rappaz, http://library.epfl.ch/theses/?display=detail&nr=1509 1997-2000: projet EMPACT (European Modelling Programme for Aluminium Casting Technologies) 2001-2004: projet VIRCAST (European Virtual Casting) 2005-2006: projet Etude du sciage des barres à laminer (Alcan Fonds) 2005-2006: projet WelAIR (Welding of Airframes, EADS) 2005-2008: soudage faisceau d'électrons des Cu-Cr-Zr (CEA, France) 2006-2008: soudage laser des Al-Li (EADS, France) 2008-2011: co-direction avec le Prof. A. Nussbaumer de la thèse de C. Acevedo sur l'influence des contraintes residuelles sur le desgin en fatigue des joints tubulaires soudés, http://library.epfl.ch/theses/?nr=5056 2007-2011: co-direction avec le Prof. J.-F. Molinari de la thèse de K. Shahim sur la dilatation ventriculaire dans l'hydrocéphalie à pression normale (S. Momjian, HU-Genève et R. Sinkus, ESPCI-Paris), http://library.epfl.ch/theses/?nr=5191 2008-2012: co-direction avec le Prof. M. Rappaz de la thèse de M. Sistaninia sur la simulation de la fissuration par modèles granulaires (Projet CCMX-MERU) 2010-2014: direction avec le Prof. M. Rappaz de la thèse de N. Chobaut sur la simulation des contraintes lors de la trempe de pièces épaisses en alliage d'aluminium à durcissement structural (Projet CCMX-MERU) 2011-2015: direction avec le Prof. H. Van Swygenhoven-Moens de la thèse de P. Schloth sur l'étude de la précipitation lors de la trempe de pièces épaisses en alliage d'aluminium à durcissement structural (Projet CCMX-MERU) Andrzej KulikExpertise
Experimental Biophysics,nanomechanics,nanomanipulation in 2D and 3D,nanotribology,Atomic Force Microscopy,Optical Tweezers,Photonic Force Microscopy,nano Infrared Spectroscopy (nanoIR),Acoustics,Ultrasound,
Expertise
Experimental Biophysics,nanomechanics,nanomanipulation in 2D and 3D,nanotribology,Atomic Force Microscopy,Optical Tweezers,Photonic Force Microscopy,nano Infrared Spectroscopy (nanoIR),Acoustics,Ultrasound,
Stefano MischlerStefano Mischler obtained the diploma in materials science in 1983 at the Swiss Federal Institute of Technology ETHZ in Zurich. He accomplished his PhD thesis in the field of surface analysis and corrosion at the Materials department of the Swiss Federal Institute of Technology EPFL in Lausanne in 1988. In the years 1989-1990 he held a postdoctoral position at the United Kingdom Atomic Energy Establishment in Harwell (Oxfordshire) where he developed novel quantification procedures for Auger Electron Spectroscopy and high lateral resolution surface analytical methods for fiber reinforced ceramics. In 1991 he joined the newly created Tribology group at the Laboratory for Metallurgical Chemistry of the EPFL where he developed research activities in the field of wear-corrosion interactions (tribocorrosion) and of tribological coatings. He is currently head of the tribology group and is developing a reserach and training activity devoted to modern aspects of tribology and surface science and technology, including surface chemical effects in tribology, biotribology and biocorrosion, tribology in microfabrication processes and wear protection methods. In 2006 he spent a sabbatical leave of 3 months at the Tokyo Medical and Dental University, Institute of Biomaterials.
Harald BruneOriginaire de Münich en Allemagne, né en 1961, Harald Brune obtient son diplôme en physique de l'Université Ludwig Maximilians en 1989. Après une thèse en chimie physique à l'Institut Fritz-Haber de la Société Max-Planck à Berlin il obtient son titre de docteur ès sciences en 1992. Dès cela, il rejoint le groupe du Prof. K. Kern à l'Institut de physique expérimentale à l'EPFL. En 1995 il est chercheur invité à Copenhague travaillant en modélisation chez le Prof. J. Nørskov. De retour à l'EPFL, il se voit décerné le prix Latsis EPFL 1996 pour ses études par microscopie à effet tunnel de processus atomiques déterminants la croissance cristalline de couches minces. En 1998 il obtient son habilitation (venia legendi) en Physique et est nommé Maître d'enseignement et de recherche (MER) en nanophysique à l'EPFL. La même année il recoit une offre de Professeur Ordinaire (C4) de l'Université Philipps de Marburg. Début 1999 il réfuse cette offre et accepte un poste de Professeur Extraordinaire à l'EPFL et s'installe au sein de l'Institut de la Physique des Nanostructures. Il est nommé Professeur Ordinaire en 2005. Sa recherche porte sur les propriétés physiques (en particulier le magnétisme et la structure électronique) de nouvelles formes de la matière condensée comme des nanostructures et des couches ultra-minces. Il s'intéresse également à la catalyse hétérogène sur des systèmes inspirés dans leur composition et taille par celle des sites actives dans les enzymes en biologie. Il enseigne la Physique Générale pour ingénieurs, la Physique des matériaux solides pour physiciens, les méthodes expérimentales pour physiciens, ainsi que la Physique des surfaces, interfaces et nanostrcutures à l'école doctorale.
Andreas MortensenAndreas Mortensen is currently Professor and Director of the Institute of Materials at the Swiss Federal Institute of Technology in Lausanne (EPFL), where he heads the Laboratory for Mechanical Metallurgy. He joined the faculty of EPFL 1997 after ten years, from 1986 to 1996, as a member of the faculty of the Department of Materials Science and Engineering at the Massachusetts Institute of Technology, where he held the successive titles of ALCOA Assistant Professor, Associate Professor, and Professor. His research is focussed on the processing, microstructural development and mechanical behavior of advanced metallic materials with particular focus on metal matrix composites and metal foams, on infiltration processing and capillarity, and on damage and fracture in metallic materials. He is author or co-author of two monographs, around one hundred and eighty scientific or technical publications and twelve patents. Born in San Francisco in 1957, of dual (Danish and US) nationality, Andreas Mortensen graduated in 1980 from the Ecole Nationale Supérieure des Mines de Paris with a Diplôme dIngénieur Civil, and earned his Ph.D. in the Department of Materials Science and Engineering at MIT in 1986. Besides his academic employment, he was a postdoctoral researcher at Nippon Steel during part of 1986, and was invited professor at the Ecole des Mines in Paris during the academic year 1995 to 1996. He is a member of the editorial committee of International Materials Reviews and has co-edited four books. He is a Fellow of ASM, a recipient of the Howe Medal and the Grossman Award of the American Society of Metals, was awarded the Péchiney Prize by the French Academy of Sciences and the Res Metallica Chair from the Katholieke Universiteit Leuven, received three EPFL teaching awards, is one of ISIs Highly Cited authors for Materials Science since 2002 and was awarded an ERC advanced grant in 2012.
David Hernandez EscobarExpertise
Physical metallurgy, ceramics, micro-mechanical testing
Education Ph.D. Materials Science and Engineering | 2016 – 2021 Michigan State University B.S. Materials Engineering | 2012 – 2016 Universidad Politécnica de Madrid
Yves LeterrierYves Leterrier joined EPFL in 1993 and is a faculty member of the Materials Institute. He is a senior scientist and lecturer in the Laboratory for Processing of Advanced Composites (LPAC, previously Laboratory of Composite and Polymer Technology, LTC). Activities
2000-2005: Foundation and Chair of the Korea-Switzerland joint symposia on materials and micro-technologies2004-2008: Board member of FLEXIDIS (the European flexible display consortium) 2004-2009: Group leader on lightweight materials for Solar ImpulseSince 2008: Board member of the French Adhesion SocietySince 2000: President of the EPFL Materials Science Library commissionSince 2012: Editorial board member, Applied Surface ScienceSince 2014: Associate Editor, Frontiers in MaterialsSince 2021: Coordinator of the EPFL Minor on 'Engineering for Sustainability'
Background
1987: MS in materials science and solid state physics (INPL, France) 1991: PhD in materials science (Ecole des Mines, INPL, France) 1992: Research Associate, National Institute of Standards and Technology (NIST, USA)
Jean-François MolinariProfessor J.F. Molinari is the director of the Computational Solid Mechanics Laboratory (http://lsms.epfl.ch) at EPFL, Switzerland. He holds an appointment in the Civil Engineering institute, which he directed from 2013 to 2017, and a joint appointment in the Materials Science institute. He started his tenure at EPFL in 2007, and was promoted to Full Professor in 2012. He is currently an elected member of the Research Council of the Swiss National Science Foundation in Division 2 (Mathematics, Natural and Engineering Sciences), and co editor in chief of the journal Mechanics of Materials. J.F. Molinari graduated from Caltech, USA, in 2001, with a M.S. and Ph.D. in Aeronautics. He held professorships in several countries besides Switzerland, including the United States with a position in Mechanical Engineering at the Johns Hopkins University (2000-2006), and France at Ecole Normale Supérieure Cachan in Mechanics (2005-2007), as well as a Teaching Associate position at the Ecole Polytechnique de Paris (2006-2009). The work conducted by Prof. Molinari and his collaborators takes place at the frontier between traditional disciplines and covers several length scales from atomistic to macroscopic scales. Over the years, Professor Molinari and his group have been developing novel multiscale approaches for a seamless coupling across scales. The activities of the laboratory span the domains of damage mechanics of materials and structures, nano- and microstructural mechanical properties, and tribology. Nadine BalucEnseignement et PhD A dirigé les thèses EPFL de Emmanuelle Giacometti, Raluca Schibli, Gang Yu, Bin Long, Lyubomira Veleva
Jürgen BruggerI am a Professor of Microengineering and co-affiliated to Materials Science. Before joining EPFL I was at the MESA Research Institute of Nanotechnology at the University of Twente in the Netherlands, at the IBM Zurich Research Laboratory, and at the Hitachi Central Research Laboratory, in Tokyo, Japan. I received a Master in Physical-Electronics and a PhD degree from Neuchâtel University, Switzerland. Research in my laboratory focuses on various aspects of MEMS and Nanotechnology. My group contributes to the field at the fundamental level as well as in technological development, as demonstrated by the start-ups that spun off from the lab. In our research, key competences are in micro/nanofabrication, additive micro-manufacturing, new materials for MEMS, increasingly for wearable and biomedical applications. Together with my students and colleagues we published over 200 peer-refereed papers and I had the pleasure to supervise over 25 PhD students. Former students and postdocs have been successful in receiving awards and starting their own scientific careers. I am honoured for the appointment in 2016 as Fellow of the IEEE “For contributions to micro and nano manufacturing technology”. In 2017 my lab was awarded an ERC AdvG in the field of advanced micro-manufacturing.
Alexandre TerrierEnseignement et PhD Doctorant·es actuel·les Mi-Lane Bouchez, Léa Pistorius A co-dirigé les thèses EPFL de Miguel Gortchacow, Adeliya Latypova, Christoph Anselm Engelhardt, Valérie Malfroy Camine, Yasmine Boulanaache, Pezhman Eghbalishamsabadi Cours Engineering of musculoskeletal system and rehabilitation BIO-687 Numerical methods in biomechanics ME-484 Les étudiants comprennent et appliquent les méthodes numériques (MEF) pour répondre à une question de recherche en biomécan
Eugen BrühwilerExpertise
structural and material engineering of existing civil structures in particular bridges of high cultural value; fatigue, dynamics and structural behaviour of bridges; Ultra-high performance fiber reinforced cementitious composites and composite UHPFRC - RC structures.
Expertise
structural and material engineering of existing civil structures in particular bridges of high cultural value; fatigue, dynamics and structural behaviour of bridges; Ultra-high performance fiber reinforced cementitious compo
Friedrich EisenbrandEnseignement et PhD Doctorant·es actuel·les Ruben Manuel Skorupinski, Neta Singer, Lukas Vogl, Jiaye Wei A dirigé les thèses EPFL de Thomas Rothvoss, Nicolai Hähnle, Martin Niemeier, Adrian Aloysius Bock, Carsten Moldenhauer, Alfonso Bolívar Cevallos Manzano, Manuel Francesco Aprile, Igor Malinovic, Christoph Hunkenschröder, Moritz Andreas Venzin, Jana Tabea Cslovjecsek A co-dirigé les thèses EPFL de Puck van Gerwen Cours Algèbre linéaire avancée II - diagonalisation MATH-115(a) L'objectif
Karen ScrivenerDe nationalité anglaise, Karen Scrivener est née en 1958. Au cours de sa carrière, ses travaux et sa recherche traitaient des domaines suivants: Identification du développement microstucturale pendant l'hydratation du ciment. Elaboration d'une approche multitechnique pour étudier la microstucture des ciments et bétons, avec accent sur la quantification par analyse des images d'électrons retrodiffusés. Caractérisation de l'auréole de transition de la pâte de ciment autour des granulats. Compréhension des processus de dégardation des bétons, en particulier le gonflement lié à la formation de l'éttringite retardée dans les bétons étuvés.
