Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Concept

Shielded cable

Publications associées (27)

Electromagnetic time reversal for online partial discharge location in power cables: Influence of interfering reflections from grid components

Farhad Rachidi-Haeri, Marcos Rubinstein

In online single-sided partial discharge (PD) location, the measured PD reflection patterns are affected by the characteristics of all the components of the associated power network. This paper analyses the performance of a PD location method based on elec ...

2024

Performance Comparison of Cables With Partial Transposition

Pierluigi Bruzzone, Kamil Sedlák, Chiara Frittitta, Federica Demattè

The need of full transposition of the current carrying elements (strands) in large cables is frequently retained as top design criterion for conductors operating in pulsed mode. However, when the transposition error, i.e., the inductance difference among t ...

IEEE Institute of Electrical and Electronics Engineers2024

Assessment of the transmission line theory in the modeling of multiconductor underground cable systems for transient analysis using a full-wave FDTD method

Farhad Rachidi-Haeri, Rafael Silva Alipio, Naiara Figueiredo Duarte

In this paper, a rigorous and independent validation of two different approaches for calculating the ground-return impedance and admittance of multiconductor underground cable systems using the transmission line theory is carried out. Furthermore, analyses ...

Elsevier2023

A Method for the Improvement of the Stability in FDTD-Based Numerical Codes Evaluating Lightning-Induced Voltage

Farhad Rachidi-Haeri

Dealing with realistic networks, the solution of lightning electromagnetic field coupling to transmission lines is generally obtained through a Finite-Difference Time-Domain (FDTD) algorithm interfaced with an electromagnetic simulator. As well known, the ...

2021

Design Study of a 50-kA React-and-Wind Bi-2212 Cable for Fusion Magnet

Davide Uglietti

In the last few years, the current density of Bi-2212 wires has been greatly improved by filament densify technologies. One further step toward applications in fusion magnets is to design a high current cable, which must overcome the drawbacks of Bi-2212 w ...

IEEE Institute of Electrical and Electronics Engineers2020

Locating lightning strikes and flashovers along overhead power transmission lines using electromagnetic time reversal

Mario Paolone, Gianluca Antonini, Reza Razzaghi, Keyhan Sheshyekani

The paper presents a method to identify the location of direct lightning strikes to overhead transmission lines and potential subsequent flashover(s). The method is based on the electromagnetic time reversal theory and relies on the use of a single measure ...

Elsevier2018

A dynamic-relaxation formulation for analysis of cable structures with sliding-induced friction

Ian Smith, Nizar Bel Hadj Ali, Ann Christine Sychterz

In many cable structures, special types of joints are designed to allow cables to slide freely along the joints. Thus, a number of discrete cable elements are substituted by a single continuous cable that slides over multiple nodes. Continuous cables are e ...

Elsevier2017

A wire shaped coaxial photovoltaic solar cell

Michael Graetzel, Mohammad Khaja Nazeeruddin, Mohammad Ibrahim Dar

A wire shaped coaxial photovoltaic solar cell comprising: a conductive core wire shaped support (401), a nanostructured semiconductor scaffold layer (402), one or more successive perovskite layers (403), an optionally provided hole transporting material la ...

2017

Experimental Characterization of the Response of an Electrical and Communication Raceway to IEMI

Farhad Rachidi-Haeri, Marcos Rubinstein, Nicolas Mora Parra

This paper reports the results of two experimental campaigns aimed at studying the high-frequency response of a raceway containing low voltage power, telephone, and Ethernet cables, to external electromagnetic field illumination. The raceway was tested aga ...

Institute of Electrical and Electronics Engineers2016

Low EMI signaling for parallel conductor interfaces

Mohammad Amin Shokrollahi, Nicolae Chiurtu

Methods are disclosed for creation of vector signaling codes having reduced or minimized electromagnetic emissions when transmitted over multiple conductor communications media such as microstrip channels. Particular code formulation constraints are shown ...

2016

Active control for mid-span connection of a deployable tensegrity footbridge

Ian Smith, Nicolas Willy Veuve, Seif Dalil Safaei

Tensegrity structures are spatial self-stressed pin jointed structures where compression components (struts) are surrounded by tension elements. This paper describes a near full-scale deployable tensegrity footbridge that deploys from both sides and connec ...

2016

Design Optimization of Round Strands Made by Twisted Stacks of HTS Tapes

Pierluigi Bruzzone, Davide Uglietti, Rainer Wesche

Atwisted stack of high-temperature superconducting (HTS) tapes soldered into copper profiles was used as a strand in the fabrication of the 60-kA/ 12-T HTS cable prototype at the Center for Research in Plasma Physics (CRPP). Considering the strand in gener ...

IEEE Institute of Electrical and Electronics Engineers2016

An Improved Formula for the Transfer Impedance of Two-Layer Braided Cable Shields

Farhad Rachidi-Haeri, Nicolas Mora Parra

In this letter, we propose a formula for evaluating the transfer impedance of two-layer braided cable shields. The proposed formula results from the combination of the model proposed by Vance for the evaluation of the equivalent transfer impedance of a two ...

Ieee-Inst Electrical Electronics Engineers Inc2015

Numerical Simulation of the Overall Transfer Impedance of Shielded Spacecraft Harness Cable Assemblies

Farhad Rachidi-Haeri, Nicolas Mora Parra

In this paper, we present general considerations for the application of the multiconductor transmission-line theory for simulating shielded spacecraft harness cable assemblies. Some of the practical issues that occur in the modeling process of various comp ...

Institute of Electrical and Electronics Engineers2015

Toward development of a biomimetic tensegrity footbridge

Ian Smith, Nicolas Willy Veuve, Seif Dalil Safaei

Biomimetic structures interact with their environment, change their properties, learn and self-repair, thereby providing properties that are similar to living organisms. Interactions with the environment involve unique challenges in the field of computatio ...

International Center for Numerical Methods in Engineering (CIMNE)2014

Efficient Analysis of Shielding Effectiveness of Metallic Rectangular Enclosures Using Unconditionally Stable Time-Domain Integral Equations

Juan Ramon Mosig, Michael Mattes, Hamidreza Karami

This paper proposes an efficient modeling technique for transient electromagnetic analysis of a rectangular metallic enclosure with multiple apertures, using the surface equivalent principle (SEP) and integral equations. The SEP is used to replace the aper ...

2014

Testing of RF 100 m TF Qualification Conductor in the SULTAN Test Facility

Pierluigi Bruzzone, Boris Stepanov

A conductor for ITER toroidal field (TF) coils is the cable-in-conduit conductor (CICC) type, which is made of Nb3Sn superconducting strands encased in a stainless steel tubular jacket. A 120-m-long prototype has been designed in accordance with ITER requi ...

IEEE Institute of Electrical and Electronics Engineers2013

Heat transfer through cable insulation of Nb-Ti superconducting magnets operating in He II

Pier Paolo Granieri

The operation of Nb–Ti superconducting magnets in He II relies on superfluidity to overcome the severe thermal barrier represented by the cable electrical insulation. In wrapped cable insulations, like those used for the main magnets of the Large Hadron Co ...

Elsevier2013

High current superconductors for DEMO

Pierluigi Bruzzone, Kamil Sedlák, Boris Stepanov

In the assumption that DEMO will be an inductively driven tokamak, the number of load cycles will be in the range of several hundred thousands. The requirements for a new generation of Nb3Sn based high current conductors for DEMO are drafted starting from ...

Elsevier Science Sa2013

Design Aspects of a Deployable Tensegrity-Hollow-rope Footbridge

Ian Smith, Nizar Bel Hadj Ali, Landolf-Giosef-Anastasios Rhode-Barbarigos, René Motro

Tensegrity structures are composed of cables and struts in a prestressed self-equilibrium. Although tensegrity first appeared in the 1950s, it is seldom used in civil engineering. This paper focuses on the design aspects of a deployable tensegrity-hollow-r ...

2012