Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Catégorie

Propulsion

Publications associées (11)

Smart Acoustic Lining for UHBR Technologies Engine Part 1: Design of an Electroacoustic Liner and Experimental Characterization Under Flow in Rectangular Cross-Section Ducts

Hervé Lissek, Maxime Volery

The new generation of Ultra-High-By-Pass-Ratio (UHBR) turbofan engine while considerably reducing fuel consumption, threatens higher noise levels at low frequencies because of its larger diameter, lower number of blades and rotational speed. This is accomp ...

American Institute of Aeronautics and Astronautics2024

The Advection Boundary Law in presence of mean-flow and spinning modes

In the attempt to reduce fuel consumption, a new generation of Ultra-High-By-Pass-Ratio (UHBR) turbofans have been introduced in the aeronautic industry which are structurally noisier especially at lower frequencies, because of their larger diameter, lower ...

SPIE2024

Domain adaptation via alignment of operation profile for Remaining Useful Lifetime prediction

Olga Fink, Ismail Nejjar, Mengjie Zhao

Effective Prognostics and Health Management (PHM) relies on accurate prediction of the Remaining Useful Life (RUL). Data-driven RUL prediction techniques rely heavily on the representativeness of the available time-to-failure trajectories. Therefore, these ...

Elsevier2024

Robust tunable acoustic impedance control on electroacoustic resonators for aircraft noise reduction

Maxime Volery

Air traffic noise emissions are responsible for a significant part of the overall environmental noise, especially in the vicinity of airports. Exposure to environmental noise is known to negatively impact health and to be associated with cardiovascular dis ...

EPFL2023

Real-time optimization of load sharing for gas compressors in the presence of uncertainty

Dominique Bonvin, Timm Faulwasser, Alejandro Gabriel Marchetti, Predrag Milosavljevic

This paper investigates the problem of load-sharing optimization of gas compressors in the presence of uncertainty. The objective is to operate a set of compressor units in an energy-efficient way, while at the same time meeting a varying load demand. The ...

ELSEVIER SCI LTD2020

Scale limitations of gas bearing supported turbocompressors for vapor compression cycles

Jürg Alexander Schiffmann

An analysis of single-stage centrifugal compressors supported on dynamic, gas lubricated bearings for driving vapor compression cycles suggests that the maximum feasible compressor power is limited, primarily by the bearing load capacity, in the range from ...

2020

Theoretical and Experimental Investigation of a 34 Watt Radial-Inflow Steam Turbine with Partial-Admission

Jan Van Herle, Jürg Alexander Schiffmann, Patrick Hubert Wagner

A micro steam turbine with a tip diameter of 15 mm was designed and experimentally characterized. At the nominal mass flow rate and total-to-total pressure ratio of 2.3 kg/h and 2, respectively, the turbine yields a power of 34 W and a total-to-static isen ...

2021

Theoretical and Experimental Investigation of a 34 Watt Radial-Inflow Steam Turbine with Partial-Admission

Jan Van Herle, Jürg Alexander Schiffmann, Patrick Hubert Wagner

A micro steam turbine with a tip diameter of 15mm was designed and experimentally characterized. At the nominal mass flow rate and total-to-total pressure ratio of 2.3 kgh-1 and 2, respectively, the turbine yields a power of 34W and a total-to-static isent ...

2021

Needle-free delivery of fluids from compact laser-based jet injector

Christophe Moser, Paul Delrot, Jan Krizek

Jet injection devices have been studied and developed for transdermal drug delivery to avoid the use of needles. Due to bulky actuation mechanisms, they are limited to body areas that are easy to reach such as skin. Here, we demonstrate a thin and long liq ...

2020

A Morphing Cargo Drone for Safe Flight in Proximity of Humans

Dario Floreano, Przemyslaw Mariusz Kornatowski, William John Stewart

Delivery drones used by logistics companies today are equipped with unshielded propellers, which represent a major hurdle for in-hand parcel delivery. The exposed propeller blades are hazardous to unsuspecting bystanders, pets, and untrained users. One sol ...

2020

Mitigation of tip leakage induced phenomena in a low Reynolds number centrifugal compressor via blade loading distribution

Markus Diehl

Reduced-scale refrigeration compressors supported on gas-lubricated bearings have been identified as a key technology for domestic heat pump applications, in order to improve both the system efficiency and the reliability. Unfortunately, reduced-scale mach ...

EPFL2019