Publication

Outcome evaluation in shoulder surgery using 3D kinematics sensors

Related publications (29)

Evaluation and robotic simulation of the glenohumeral joint

The shoulder is the joint with the largest range of motion in the human body. It is composed of three articulations, the glenohumeral articulation providing about two thirds of its mobility which is, also the most complex and fragile of the three. For this ...

EPFL2020

Deep learning for the rapid automatic quantification and characterization of rotator cuff muscle degeneration from shoulder CT datasets

Alexandre Terrier, Philippe Büchler, Alain Farron, Elham Taghizadeh

Objectives This study aimed at developing a convolutional neural network (CNN) able to automatically quantify and characterize the level of degeneration of rotator cuff (RC) muscles from shoulder CT images including muscle atrophy and fatty infiltration. M ...

SPRINGER2021

Feasibility of an alternative method to estimate glenohumeral joint center from videogrammetry measurements and CT/MRI of patients

Dominique Pioletti, Philippe Müllhaupt, Alexandre Terrier, Alain Farron, Matteo Mancuso, Ehsan Sarshari

Videogrammetry is commonly used to record upper limb motions. However, it cannot track the glenohumeral joint center (GH). GH is required to reconstruct upper limb motions. Therefore, it is often estimated by separately measuring scapular motions using sca ...

2021

Flexure-based mecano-optical multi-degree-of-freedom transducers dedicated to medical force sensing instruments

Sebastian Krzysztof Fifanski

This thesis develops novel multi-degrees-of-freedom flexure-based force sensors by exploiting white light interferometry. Fabry-Pérot interferometry measurement has nanometric accuracy which yields sub milli-Newton force sensing accuracy. Such force sensin ...

EPFL2020

Explicit dynamic approach for unbounded domains in frictional contact with Rate and State laws

Jean-François Molinari, Roozbeh Rezakhani

The paper explores the ability of an explicit time integration procedure to simulate the dynamics of shear rupture between unbounded elastic blocks on frictional interface, modeled with the finite element method. The behaviour of the interface is governed ...

ELSEVIER2020

On design strategies for binary dielectric metasurfaces based on the Fourier modal method

Kévin Müller

Binary dielectric metasurfaces are arrays of sub-wavelength structures that act as a thin layer of artificial material. They are generally lossless and relatively simple to fabricate since only a single structuring step is required. By carefully designing ...

EPFL2020

A Minimal Stabilization Procedure for Isogeometric Methods on Trimmed Geometries

Annalisa Buffa, Riccardo Puppi, Rafael Vazquez Hernandez

Trimming is a common operation in computer aided design and, in its simplest formulation, consists in removing superfluous parts from a geometric entity described via splines (a spline patch). After trimming, the geometric description of the patch remains ...

2020

Fully 3D Printed Mechanical Pressure Sensors: A Comparison of Sensing Mechanisms

Danick Briand, Rubaiyet Iftekharul Haque, Julien Gaëtan Berger, Ryan Mitchell van Dommelen

Recent advances in 3D printing techniques are allowing for new ways to manufacture sensors with materials and geometries previously not exploited. In this work we present a fabrication approach for fully 3D printed soft mechanical pressure sensors, as well ...

IEEE2020

Reduction of scapulohumeral subluxation with posterior augmented glenoid implants in anatomic total shoulder arthroplasty: Short-term 3D comparison between pre- and post-operative CT

Alexandre Terrier, Alain Farron, Patrick Goetti

Background: Failure rates in anatomic total shoulder arthroplasty (aTSA) are higher in case of asymmetric glenoid bone loss secondary to posterior wear, and in persistent static posterior subluxation of the humeral head (PSH). ...

ELSEVIER MASSON, CORP OFF2020