Publications related to Punching shear tests on compact footings with uniform soil pressure

Related publications (32)

Insights from an extensive triaxial testing campaign on a shale for comparative site characterization of a deep geological repository

Lyesse Laloui, Alessio Ferrari, Eleonora Crisci

Several boreholes were drilled for site comparison of a deep geological repository (DGR) in Northern Switzerland. The main target of the exploration program was the >100m thick Opalinus Clay, the designated host rock encountered at approximately 450 to 100 ...

Elsevier2024

Shear and steel-fibre reinforcement for the punching resistance of flat slabs at internal and edge columns

Diego Hernández Fraile

Reinforced concrete flat slabs consist of a continuous, thin concrete plate that rests on a grid of columns. The supporting surface of the columns is very small compared to the floor plan dimensions, leading to concentrations of shear forces near the colum ...

EPFL2024

Drained Clay-Pipe Interface Resistance at Low Normal Stresses and Elevated Temperatures

Roba Houhou

Offshore pipelines that transport hydrocarbons under high pressure and high temperature are usually thermally insulated to maintain an elevated temperature and prevent any heat loss to the surroundings. However, the temperatures at the outer-wall of the pi ...

AMER SOC CIVIL ENGINEERS2023

Mechanics, Modeling, and Upscaling of Biocemented Soils: A Review of Breakthroughs and Challenges

Lyesse Laloui, Dimitrios Terzis, Ray Harran

Biogeotechnical research has inspired revolutionary ideas to claim the status of a distinctive branch of geotechnical engineering. Most notably, underground carbonate mineralization, most commonly referred to as microbially induced carbonate precipitation ...

ASCE-AMER SOC CIVIL ENGINEERS2023

Hydro-mechanichal characterisation of bentonite/steel interfaces

Alessio Ferrari, Eleni Stavropoulou

The hydromechanical response of a Wyoming-type bentonite (MX-80) and its interface with steel was studied in terms of shear resistance under different hydration levels. A series of shear tests under constant normal stress were performed in total suction co ...

2023

Shear strength and shear stiffness analysis of compacted Wyoming-type bentonite

Alessio Ferrari

Wyoming-type bentonite is one of the materials to be used as part of the Engineered Barrier System (EBS) in deep geological disposal facilities for the safe disposal of spent nuclear fuel.In the KBS-3 type repository, the canisters containing the spent fue ...

ELSEVIER2023

Modeling the mechanics and rheology of porous and granular media: an elastoplastic continuum approach

Lars Kristoffer Uhlen Blatny

The complex mechanics of porous and granular media play a significant role in various industrial processes and natural phenomena. As an example, understanding the mechanics of how failure occurs, localizes and propagates in porous brittle solids under vari ...

EPFL2023

Single-Well Pore Pressure Preconditioning for Enhanced Geothermal System Stimulation

Marie Estelle Solange Violay, Barnaby Padraig Fryer, Mathias Alexandre David Lebihain

The stress state is an important parameter in terms of both earthquake nucleation and rupture. Here, a new stimulation technique is proposed for Enhanced Geothermal Systems (EGSs), which have previously been burdened with a number of high-profile incidence ...

2023

Incorporation of Lignin in Bio-Based Resins for Potential Application in Fiber-Polymer Composites

Mateus De Assunção Hofmann

Bio-based resins, obtained from renewable raw materials, are a more sustainable alternative to oil-based resins for fiber-reinforced polymer (FRP) composites. The incorporation of lignin in those resins has the potential to enhance their performance. This ...

MDPI2023

The effects of a spur dike location in a 90° sharp channel bend on flow field: Focus on anisotropy degree and anisotropy nature

Anton Schleiss

In this research, the flow features around a spur dike located in a 90˚ sharp channel bend have been studied experimentally in detail. Results showed that the effects of the spur dike on upstream sections increased by increasing α (spur dike location from ...

2023

Shearing and opening of a pre-existing discontinuity in response to fluid injection

Ankit Gupta, Brice Tanguy Alphonse Lecampion, Alexis Alejandro Sáez Uribe, Ankit Gupta

We investigate the fluid-driven growth of a shear crack along a frictional discontinuity and its transition to hydraulic fracturing (sometimes referred to as hydraulic jacking) under plane-strain conditions. We focus on the case of a constant friction coef ...

2023

Pore-pressure coefficients for unsaturated soils: generalized effective stress approach

Lyesse Laloui, Alessio Ferrari, Angelica Tuttolomondo

Geotechnical problems with total stress changes occurring rapidly relative to the soil consolidation time can be conveniently addressed using an effective stress-based approach. For saturated states, analytical formulations of pore-pressure coefficients ad ...

CANADIAN SCIENCE PUBLISHING2023

Exploring the potential of the critical shear crack theory for reinforced and post-tensioned glass beams: Initial analysis and experiments

Alain Nussbaumer, Pieter Christian Louter, Jagoda Cupac

In the evolution of structural glass beam elements, the requirements for post-fracture load bearing capacity and safe failure behaviour have led to the development of reinforced and post-tensioned beams. Maximum bending capacity in the post-fracture state ...

2023

Data-driven 1D wave propagation for site response analysis

Jean-François Molinari, Antonio Joaquin Garcia Suarez, Sacha Zenon Wattel

Prediction of ground motion triggered by earthquakes is a prime concern for both the seismology community and geotechnical earthquake engineering one. The subfield occupied with such a problem is termed site response analysis (SRA), its one-dimensional fla ...

WILEY2023

Energy dissipation in fiber-polymer composites adhesive joints under cyclic loading

Ghazaleh Eslami

Sustainable development has emerged as a paramount consideration in various fields of industry, including construction, to preserve the environment and its finite resources. Lightweight structures, such as fiber-polymer composite structures, address both s ...

EPFL2023

Characterization of shear deformations in reinforced concrete members without shear reinforcement

Aurelio Muttoni, Miguel Fernández Ruiz, Raffaele Cantone, Andri Setiawan

The load-carrying capacity of many reinforced concrete structures is governed by shear failures, occurring before reaching the flexural capacity of the member. For redundant systems, such as slabs subjected to concentrated loads, local shear failures (typi ...

2022

Failure mechanism of fine-grained soil-structure interface for energy piles

Lyesse Laloui, Elena Ravera

The response of the soil-structure interface can significantly affect the performance of any geotechnical structure. Thermal cycles are a new factor that influence the response to all structures that have an energy function in addition to the structural on ...

2022

Deformation capacity evaluation for flat slab seismic design

Aurelio Muttoni, Lorenzo Martinelli, Andri Setiawan

In flat-slab frames, which are typically designed as secondary seismic structures, the shear failure of the slab around the column (punching failure) is typically the governing failure mode which limits the deformation capacity and can potentially lead to ...

SPRINGER2022

Experimental quantification of 3D deformations in sensitive clay during stress-probing

Edward Carlo Giorgio Andò

Unique four-dimensional (4D) deformation data are collected during drained triaxial tests on intact specimens of a natural sensitive clay. This requires the development of a miniature triaxial cell for advanced stress path testing, specifically designed fo ...

ICE PUBLISHING2022

Life cycle environmental assessment of retaining walls in unsaturated soils

Alessio Ferrari, Gianluca Speranza

Retaining structures above groundwater level support soils that are usually in a state of partial saturation and subject to the actions of atmospheric agents. The current design approach considers the possible extremes of soil conditions - either totally d ...

ELSEVIER2022