Publications related to Double-diffusive interfaces in Lake Kivu reproduced by direct numerical simulations

Plasmoid drift and first wall heat deposition during ITER H-mode dual-SPIs in JOREK simulations

The heat flux mitigation during the thermal quench (TQ) by the shattered pellet injection (SPI) is one of the major elements of disruption mitigation strategy for ITER. It's efficiency greatly depends on the SPI and the target plasma parameters, and is ult ...

IOP Publishing Ltd2024

Turbulence and Heat exchange in the Near-Surface Boundary Layer over Patchy Snow

Michael Haugeneder

The atmospheric layer adjacent to the earth's surface is of crucial importance for weather models due to the exchange of energy between the surface and the atmosphere. This exchange is dependent on the various surface properties and influences the state of ...

EPFL2024

A cut-cell method for the numerical simulation of 3D multiphase flows with strong interfacial effects

Alexandre Caboussat, Alexandre Masserey, Marco Picasso, Julien Hess

We present a numerical model for the approximation of multiphase flows with free surfaces and strong interfacial effects. The model relies on the multiphase incompressible Navier-Stokes equations, and includes surface tension effects on the interfaces betw ...

Academic Press Inc Elsevier Science2024

Gyrokinetic turbulence modeling of a high performance scenario in JT-60SA

Stephan Brunner, Stefano Coda, Aylwin Iantchenko

Local gyrokinetic simulations are used to model turbulent transport for the first time in a representative high-performance plasma discharge projected for the new JT-60SA tokamak. The discharge features a double-null separatrix, 41 MW of combined neutral b ...

IOP Publishing Ltd2024

Heat transfer of uncoated and nanostructure coated commercially micro-enhanced refrigeration tubes under pool boiling conditions

John Richard Thome

The heat transfer performance of commercially produced micro-enhanced tubes with and without a nanocoating was investigated under pool boiling of saturated refrigerant. These multiscale enhancements were on the outside of 19 mm horizontal copper tubes heat ...

Pergamon-Elsevier Science Ltd2023

Experimental study of the hydrodynamic and thermal performances of ventilated wall structures

Mohammad Rahiminejad, Dolaana Khovalyg

The presence of a ventilated air gap behind the external cladding in a building envelope is known to have a tangible contribution to the overall performance of the wall assembly. In the present study, the hydrodynamic and thermal performances of ventilated ...

2023

Multiscale enhancement of refrigerant falling film boiling by combining commercially enhanced tubes with nanostructures

John Richard Thome

Multiscale surface structures offer the opportunity to combine the heat transfer enhancement provided by microscale structures with the dryout benefits provided by some nanostructures, which is particularly attractive for falling film evaporators, who have ...

Pergamon-Elsevier Science Ltd2023

Evaluation of 30 urban land surface models in the Urban-PLUMBER project: Phase 1 results

Matthias Roth, Gabriele Manoli

Accurately predicting weather and climate in cities is critical for safeguarding human health and strengthening urban resilience. Multimodel evaluations can lead to model improvements; however, there have been no major intercomparisons of urban-focussed la ...

Wiley2023

Beam radiation penetration in particle b e ds for heat transfer modeling of a centrifugal solar particle receiver

Serdar Hiçdurmaz, Evan Fair Johnson

This article describes a study of beam radiation striking particle beds of randomly packed, spherical par-ticles. The current study is focused on concentrating solar power receivers which use solid particles as a heat transfer medium, but results are appli ...

PERGAMON-ELSEVIER SCIENCE LTD2023

Heat recovery potential from ventilated passive and active facades

Mohammad Rahiminejad, Dolaana Khovalyg

A ventilated air-space behind external claddings can potentially affect the thermal performance of the entire building structure. In particular, in the Building Integrated Photovoltaic (BIPV) facades, ventilated cavities are typically present between the P ...

TU Delft OPEN2022

Flow Boiling of Carbon Dioxide at Different Channel Orientations for the Thermal Management of Future Detector Technologies at the High-Luminosity Large Hadron Collider at CERN

David Schmid

The global warming potential (GWP) of working fluids in thermodynamic cycles and their environmental impact have been gaining considerable attention within the recent years. The global objectives on climate protection are becoming increasingly ambitious, w ...

EPFL2022

Heat transfer of flow boiling carbon dioxide in vertical upward direction

Jürg Alexander Schiffmann, Rémi Revellin, David Schmid

Heat transfer measurements of flow boiling Carbon Dioxide (CO2) in vertical upward direction have been carried out with a dedicated test facility at the European Organization for Nuclear Research (CERN). The experiments have been conducted in a vertical up ...

2022

Near-junction microfluidic cooling for high power-density GaN-on-Si electronics: A wafer, device, packaging, and system-level investigation

Remco Franciscus Peter van Erp

Electrification of the energy section, from generation to end-use, plays an essential role in reducing global CO2 emission. Innovations in power electronics are required to increase conversion efficiency and power density. Gallium nitride (GaN) transistors ...

EPFL2022

Multi-Scale Study of High-Temperature Latent Heat Storage With Metallic Phase Change Materials

Nithin Mallya

Energy storage is a central issue in the green economy with half the global end energy usage being heat. Latent heat thermal energy storage (LHTES) provides an energy dense heat storage solution with a well-defined discharge temperature. Utilizing low-cost ...

EPFL2022

Conductive Heat Transfer in Partially Saturated Gas Diffusion Layers with Evaporative Cooling

Sophia Haussener, Mirco Magnini, Felix N. Büchi

Heat transport is an important, though often neglected function of gas diffusion layers (GDLs) of polymer electrolyte membrane fuel cells. Thermal conductivity is a key property, especially in partially water saturated GDLs and when the phase change of wat ...

2022

A parametric study on pool boiling heat transfer and critical heat flux on structured surfaces with artificial cavities

Luis Guillermo Villanueva Torrijo, Ahmad Reza Motezakker

Emerging applications in new generation electronic devices require effective heat removal and thermal man-agement. In this regard, boiling is a phase change phenomenon capable of dissipating a large amount of heat compared to the sensible heat. In this stu ...

PERGAMON-ELSEVIER SCIENCE LTD2022

Fundamental study on microlayer dynamics in nucleate boiling

Lubomír Bures

Dynamics of nucleate boiling are strongly affected by the formation and behaviour of the microlayer, a layer of liquid underneath growing bubbles. As a result of its minute thickness, very high heat fluxes occur within the microlayer and its evaporation co ...

EPFL2021

Simulation and experimental validation of pulsating heat pipes

John Richard Thome, Jackson Braz Marcinichen, Filippo Cataldo, Philippe Aubin

The one-dimensional transient numerical code of JJ Cooling Innovation has been significantly improved to simulate the thermal/hydraulic performance of pulsating heat pipes (PHPs). Using a mechanistic approach, the liquid slug and vapor plug flows and their ...

PERGAMON-ELSEVIER SCIENCE LTD2021

Flow boiling heat transfer and two-phase flow phenomena of CO2 in macro-and micro-channel evaporators: Fundamentals, applications and engineering design

John Richard Thome

The paper presents a comprehensive review of fundamentals and engineering applications of CO2 flow boiling heat transfer, flow patterns and two-phase pressure drops in macro- and micro-channel evaporators. First, distinctions of macro- and micro-channels a ...

PERGAMON-ELSEVIER SCIENCE LTD2021

Performance of lightweight and heavyweight building walls with naturally ventilated passive and active facades

Mohammad Rahiminejad, Dolaana Khovalyg

Well-designed ventilated air-spaces behind external claddings in the building envelope can potentially reduce thermal energy flow in the entire wall structure. In this study, the impact of the dynamic thermo-hydraulic behavior of the flow in the naturally ...

2021