Publications related to Internal kink mode stabilization and the properties of auxiliary heated ions

Progress in the development of the ITER baseline scenario in TCV

Olivier Sauter, Stefano Coda, Alexander Karpushov, Yann Camenen, Benoît Labit, Antoine Pierre Emmanuel Alexis Merle, Olivier Claude Martin Février, Simon Van Mulders, Filippo Bagnato, Alessandro Pau, Matteo Vallar, Cassandre Ekta Contré, Stefano Marchioni, Oleg Krutkin, Reinart Andreas J. Coosemans

Under the auspices of EUROfusion, the ITER baseline (IBL) scenario has been jointly investigated on AUG and TCV in the past years and this paper reports on the developments on TCV. It is found that the performance of TCV IBL is mainly limited by (neoclassi ...

2024

Gyrokinetic simulations of turbulence in magnetic fusion plasmas using a delta-f PIC scheme with evolving background

Moahan Murugappan

Using the GKEngine code which simulates an electrostatic plasma with adiabatic electron response under a sheared-slab geometry, an attempt at developing a hybrid approach between the delta-f and full-f schemes to describe plasma profiles exhibiting high fl ...

EPFL2024

Nonlinear simulation of plasma turbulence using a gyrokinetic moment-based approach

Antoine Cyril David Hoffmann

Plasma turbulence plays a fundamental role in determining the performances of magnetic confinement fusion devices, such as tokamaks. Advances in computer science, combined with the development of efficient physical models, have significantly improved our u ...

EPFL2024

Full-F turbulent simulation in a linear plasma device using a gyro-moment approach

Paolo Ricci, Baptiste Jimmy Frei

Simulations of plasma turbulence in a linear plasma device configuration are presented. These simulations are based on a simplified version of the gyrokinetic (GK) model proposed by Frei et al. [J. Plasma Phys. 86, 905860205 (2020)], where the full-F distr ...

Aip Publishing2024

Study of impurity C transport and plasma rotation in negative triangularity on the TCV tokamak

Basil Duval, Olivier Sauter, Stefano Coda, Alexander Karpushov, Laurie Porte, Benoît Labit, Antoine Pierre Emmanuel Alexis Merle, Justin Richard Ball, Filippo Bagnato, Alessandro Pau, Dmytry Mykytchuk

Carbon impurity transport is studied in the TCV tokamak using a charge exchange recombination diagnostic. TCVs flexible shaping capabilities were exploited to extend previous impurity transport studies to negative triangularity (delta < 0). A practical way ...

Iop Publishing Ltd2024

Towards practical reinforcement learning for tokamak magnetic control

Jonas Buchli, Federico Alberto Alfredo Felici, Cristian Galperti, Brendan Tracey

Reinforcement learning (RL) has shown promising results for real-time control systems, including the domain of plasma magnetic control. However, there are still significant drawbacks compared to traditional feedback control approaches for magnetic confinem ...

Elsevier Science Sa2024

Scenario optimization for the tokamak ramp-down phase in RAPTOR. Part B: safe termination of DEMO plasmas

Olivier Sauter, Emiliano Fable, Federico Alberto Alfredo Felici, Anna Teplukhina, Simon Van Mulders, Cassandre Ekta Contré

An optimized plasma current ramp-down strategy is critical for safe and fast termination of plasma discharges in a tokamak demonstration fusion reactor (DEMO), both in planned and emergency scenarios, avoiding plasma disruptions and excessive heat loads to ...

Iop Publishing Ltd2024

Global fluid simulations of plasma turbulence in stellarators

António João Caeiro Heitor Coelho

In order to cope with the decarbonization challenge faced by many countries, fusion is one of the few alternatives to fossil fuels for the production of electricity. Two devices invented in the middle of the previous century have emerged as the most promis ...

EPFL2024

Global fluid simulation of plasma turbulence in stellarators with the GBS code

Joaquim Loizu Cisquella, Paolo Ricci, António João Caeiro Heitor Coelho

The implementation of three-dimensional magnetic fields, such as the ones of stellarators, in the GBS code (Ricci et al 2012 Plasma Phys. Control. Fusion54 124047; Giacomin et al 2022 J. Comput. Phys.464 111294) is presented, and simulation results are dis ...

IOP Publishing Ltd2024

Re-design of EU DEMO with a low aspect ratio

Hartmut Zohm

The design point that had been chosen for EU DEMO in 2016 is reviewed here and a modification is proposed with a lower aspect ratio. Previously the same aspect ratio, A, was chosen for EU DEMO as in major tokamak experiments including ITER (A = 3.1), and, ...

2024

Benign termination of runaway electron beams on ASDEX Upgrade and TCV

Basil Duval, Stefano Coda, Joan Decker, Umar Sheikh, Jean Arthur Cazabonne, Claudia Colandrea, Luke Simons, Gergely Papp, Bernhard Sieglin

This paper discusses the development of a benign termination scenario for runaway electron (RE) beams on ASDEX Upgrade and TCV. A systematic study revealed that a low electron density (n e) companion plasma was required to achieve a large MHD instability, ...

Iop Publishing Ltd2024

Present design of the Steering Mirror Assembly (SMA) for ITER ECHUL

René Chavan, Timothy Goodman, Anastasia Xydou

In the ITER Tokamak, four Electron Cyclotron Heating Upper Launchers (ECHUL) are needed to control plasma instabilities at the rational surfaces, most importantly the q = 3/2 and q = 2/1 neoclassical tearing modes (NTMs). Each ECHUL is equipped with a set ...

2023

Effect of triangularity on plasma turbulence and the SOL-width scaling in L-mode diverted tokamak configurations

Paolo Ricci, Louis Nicolas Stenger, Maurizio Giacomin, Davide Mancini

The effect of triangularity on tokamak boundary plasma turbulence is investigated using global, flux-driven, three-dimensional, two-fluid simulations. The simulations show that negative triangularity (NT) stabilizes boundary plasma turbulence, and linear i ...

IOP Publishing Ltd2023

Full-discharge simulation and optimization with the RAPTOR code, from present tokamaks to ITER and DEMO

Simon Van Mulders

Tokamak devices aim to magnetically confine a hydrogen plasma at sufficiently high pressure to achieve net energy production from nuclear fusion of light isotopes. Predictive modeling and optimization is crucial for reliable operation of tokamak reactors, ...

EPFL2023

A Gyrokinetic Moment Model of the Plasma Boundary in Fusion Devices

Baptiste Jimmy Frei

The overall performance of fusion devices, such as tokamaks, is strongly correlated to the phenomena that occur in the boundary region, the outer plasma region that faces the wall of the device. The boundary plays a crucial role in regulating the heat and ...

EPFL2023

An experimental and computational study of tokamak plasma turbulence

Aylwin Iantchenko

Turbulence driven by small-scale instabilities results in strong heat and particle transport, which significantly shortens the confinement time and prevents the formation of a self-sustained plasma reaction in magnetic confinement devices. Control and poss ...

EPFL2023

Predictive modeling of Alfvén eigenmode stability in inductive scenarios in JT-60SA

Javier García Hernández, Antonio José Pereira de Figueiredo, Matteo Vallar

The JT-60SA device offers unique conditions before ITER for the study of the interaction of energetic particles with plasma waves. With similar dimensions to JET, e.g., a major radius but with a slightly more elongated plasma volume, JT-60SA is used as a h ...

Frontiers Media Sa2023

How accurate are flux-tube (local) gyrokinetic codes in modeling energetic particle effects on core turbulence?

Olivier Sauter, Alberto Bottino, Emanuele Poli

Flux-tube (local) gyrokinetic codes are widely used to simulate drift-wave turbulence in magnetic confinement devices. While a large number of studies show that flux-tube codes provide an excellent approximation for turbulent transport in medium-large devi ...

IOP Publishing Ltd2023

Shafranov shift correction to the Furth-Yoshikawa scaling of tokamak adiabatic compression

Olivier Sauter

In 1970, Furth and Yoshikawa (1970 Phys. Fluids 13 2593-6) introduced the scalings of adiabatic plasma compression. Basically, if the shape of the external plasma boundary and the aspect ratio are preserved during the compression, then the density, kinetic ...

2023

Numerical tools for burning plasmas

Laurent Villard, Alberto Bottino, Jonathan Graves, Ben McMillan, Emmanuel Lanti, Emanuele Poli, Xiao Wang, Baruch Rofman

The software stack under development within a European coordinated effort on tools for burning plasma modelling is presented. The project is organised as a Task (TSVV Task 10) under the new E-TASC initiative (Litaudon et al 2022 Plasma Phys. Control. Fusio ...

IOP Publishing Ltd2023