Publications related to Numerical Simulations of Pulsating Heat Pipes, Part 1: Modeling

Related publications (32)

Parameterizing Snow Sublimation in Conditions of Drifting and Blowing Snow

Michael Lehning, Christophe Moser, Armin Sigmund

Snow transport favors strong sublimation and may therefore have an important effect on the surface mass balance of polar and high‐mountain regions. Recently, small‐scale models such as large‐eddy simulation (LES) with Lagrangian snow particles have improve ...

American Geophysical Union (AGU)2025

Design and assessment of an evaporating water-cooled methanation reactor for a SOE-based power-to-methane system

Philippe Aubin

The transition towards clean renewable energy sources, where wind and solar are prone to variation, requires adequate energy storage. Power-to-methane (PtM) systems can be part of the solution. Specifically, solid-oxide-electrolyser (SOE) based PtM systems ...

EPFL2024

Plasmoid drift and first wall heat deposition during ITER H-mode dual-SPIs in JOREK simulations

Mengdi Kong

The heat flux mitigation during the thermal quench (TQ) by the shattered pellet injection (SPI) is one of the major elements of disruption mitigation strategy for ITER. It's efficiency greatly depends on the SPI and the target plasma parameters, and is ult ...

IOP Publishing Ltd2024

Computational fluid dynamics simulations of the heat transfer properties of graphene-based nanolubricants and application to hydrodynamic lubrication

Roberto Guarino

In this paper, we consider experimental data available for graphene-based nanolubricants to evaluate their convective heat transfer performance by means of computational fluid dynamics (CFD) simulations. Single-phase models with temperature-dependent prope ...

Aip Publishing2024

Innovative thermophysical characterization of an ATF composite cladding: the case of silicon carbide

Andrea Cavaliere

Nuclear power is a powerful technology that plays an important role in the fight against climate change, and research is continuously engaged in studies that could further improve its safety. After the Fukushima accident, Accident Tolerant Fuels research h ...

EPFL2024

Thermal conductivity of Li 3 PS 4 solid electrolytes with ab initio accuracy

Michele Ceriotti, Federico Grasselli, Davide Tisi, Lorenzo Gigli

The vast amount of computational studies on electrical conduction in solid-state electrolytes is not mirrored by comparable efforts addressing thermal conduction, which has been scarcely investigated despite its relevance to thermal management and (over)he ...

Amer Physical Soc2024

Decomposition method to evaluate district heating/cooling network potential at urban scale

Ana Catarina Gouveia Braz, François Maréchal, Luc Girardin, Bingqian Liu

In this work, a tool to design district heating networks (DHN) is presented and applied to the city of Lausanne as a case study. The evaluation of the buildings’ heat/cooling demand is performed using a Geographic Information System (GIS) database, built f ...

Associazione Italiana Di Ingegneria Chimica2024

Unearthing the foundational role of anharmonicity in heat transport in glasses

Paolo Pegolo

The time-honored Allen -Feldman theory of heat transport in glasses is generally assumed to predict a finite value for the thermal conductivity, even if it neglects the anharmonic broadening of vibrational normal modes. We demonstrate that the harmonic app ...

Amer Physical Soc2024

Performance of energy piles foundation in hot-dominated climate: A case study in Dubai

Lyesse Laloui, Elena Ravera, Sofie Elaine ten Bosch

Energy piles represent an innovative technology that can help provide sustainable geothermal heating or cooling energy for thermal conditioning purposes. In hot-dominated climates, the interest is to inject heat in the ground and extract energy for space-c ...

Pergamon-Elsevier Science Ltd2024

Inter-discharge optimization for fast, reliable access to ASDEX Upgrade advanced tokamak scenario

Olivier Sauter, Federico Alberto Alfredo Felici, Simon Van Mulders, Cassandre Ekta Contré

Rapid inter-discharge simulation and optimization using the RAPTOR code have allowed the development of a reliable and reproducible early heating strategy for an advanced tokamak (AT) scenario on ASDEX Upgrade. Solving for electron heat and current diffusi ...

IOP Publishing Ltd2024

Flash Melting Amorphous Ice

Marcel Drabbels, Ulrich Lorenz, Gabriele Bongiovanni, Constantin Richard Krüger, Nathan Junior Mowry

Water can be vitrified if it is cooled at high rates, which makes it possible to outrun crystallization in so-called no man’s land, a range of deeply supercooled temperatures where water crystallizes rapidly. Here, we study the reverse process in pure wate ...

2024

Self-catalysed frontal polymerisation enables fast and low-energy processing of fibre reinforced polymer composites

Véronique Michaud, Baris Çaglar, Jacobus Gerardus Rudolph Staal

Frontal polymerisation has the potential to bring unprecedented reductions in energy demand and process time to produce fibre reinforced polymer composites. Production of epoxy-based fibre reinforced polymer parts with high fibre volume content, commonly e ...

2024

Modeling and optimization of PCB coils for inductive power transfer systems

Xiaotong Du

The auxiliary power supply for medium voltage converters requires high insulation capability between the source and the load. Inductive power transfer technology, with an air gap between the primary and secondary coil, offers such high insulation capabilit ...

EPFL2024

Turbulence and Heat exchange in the Near-Surface Boundary Layer over Patchy Snow

Michael Haugeneder

The atmospheric layer adjacent to the earth's surface is of crucial importance for weather models due to the exchange of energy between the surface and the atmosphere. This exchange is dependent on the various surface properties and influences the state of ...

EPFL2024

Optimizing Atomic Layer Deposition Processes with Nanowire-Assisted TEM Analysis

Ivo Utke, Johann Michler, Xavier Maeder

Atomic layer deposition (ALD) is one of the premier methods to synthesize ultra-thin materials on complex surfaces. The technique allows for precise control of the thickness down to single atomic layers, while at the same time providing uniform coverage ev ...

Wiley2024

High-Resolution Modeling Without Computation Slowdown for PETALE in CROCUS

Andreas Pautz, Vincent Pierre Lamirand, Axel Guy Marie Laureau, Thomas Jean-François Ligonnet

In a collaboration between Ecole Polytechnique Fédérale de Lausanne (EPFL) and CEA, in the fall of 2020, the experimental Programme d’Étude en Transmission de l’Acier Lourd et ses Eléments (PETALE) was successfully carried out in the CROCUS reactor of EPFL ...

2024

Identification and Mitigation of Degradation Mechanisms Induced by Heat and Light in NiOx-based Perovskite Solar Cells

Marion Solange Madeleine Dussouillez

Perovskite solar cells (PSCs) offer an attractive solution to increase the efficiency of PV panels via perovskite/silicon tandems thanks to their potential cost-effectiveness and high efficiency. In inverted PSC architecture (p-i-n), commonly used hole con ...

EPFL2024

Gyrokinetic turbulence modeling of a high performance scenario in JT-60SA

Stefano Coda, Stephan Brunner, Aylwin Iantchenko

Local gyrokinetic simulations are used to model turbulent transport for the first time in a representative high-performance plasma discharge projected for the new JT-60SA tokamak. The discharge features a double-null separatrix, 41 MW of combined neutral b ...

IOP Publishing Ltd2024

Multiscale enhancement of refrigerant falling film boiling by combining commercially enhanced tubes with nanostructures

John Richard Thome

Multiscale surface structures offer the opportunity to combine the heat transfer enhancement provided by microscale structures with the dryout benefits provided by some nanostructures, which is particularly attractive for falling film evaporators, who have ...

Pergamon-Elsevier Science Ltd2023

Experimental study of the hydrodynamic and thermal performances of ventilated wall structures

Dolaana Khovalyg, Mohammad Rahiminejad

The presence of a ventilated air gap behind the external cladding in a building envelope is known to have a tangible contribution to the overall performance of the wall assembly. In the present study, the hydrodynamic and thermal performances of ventilated ...

2023