Publications related to Air Side Contamination in Solid Oxide Fuel Cell Stack Testing

Related publications (29)

Electrochemical devices and computer science: water/thermal management of proton exchange membrane fuel cells and electrolyzers in different scales

The current restrictions on the registration of combustion engines in different countries and the harmful impacts of fossil fuels on the environment and human health have motivated decision-makers to use batteries and/or fuel cells as alternatives for comb ...

EPFL2023

Reversible photo-electrochemical device for solar hydrogen and power generation

Sophia Haussener, Saurabh Yuvraj Tembhurne, Alexandre Dominique M. Cattry, Matthieu Jonin, Mahendra Patel

A reversible photo-electrochemical device operating under concentrated irradiation could offer a stand-alone solution for producing solar fuel (in photo-driven electrolysis mode) and power (in fuel cell mode). This strategy would present the advantage of h ...

2024

Spinel Protective Coatings for Solid Oxide Cell (SOC) Interconnects (ICs)

Samaneh Daviran

Abstract The degradation of metal interconnects (ICs) in Solid Oxide Cells (SOCs) primarily results from chromium (Cr) oxide scale growth on stainless-steel substrates, causing ohmic loss and air-side electrode poisoning by Cr. This thesis addresses these ...

EPFL2024

Quantifying mass transport limitations in a microfluidic CO2 electrolyzer with a gas diffusion cathode

Sophia Haussener, Venu Gopal Agarwal

A gas diffusion electrode (GDE) based CO2 electrolyzer shows enhanced CO2 transport to the catalyst surface, significantly increasing current density compared to traditional planar immersed electrodes. A two-dimensional model for the cathode side of a micr ...

2024

Membrane electrode assembly simulation of anion exchange membrane water electrolysis

Zoé Mury, Jan Van Herle, Suhas Nuggehalli Sampathkumar, Khaled Lawand

Anion exchange membrane water electrolysis (AEMWE) offers a green hydrogen production method that eliminates the need for platinum group metals (PGM) as electrocatalysts. This study employs a COMSOL (R) 6.0 model to simulate a 1x1 cm(2) Ni fibre - Raney (R ...

Elsevier2024

Design and assessment of an evaporating water-cooled methanation reactor for a SOE-based power-to-methane system

Philippe Aubin

The transition towards clean renewable energy sources, where wind and solar are prone to variation, requires adequate energy storage. Power-to-methane (PtM) systems can be part of the solution. Specifically, solid-oxide-electrolyser (SOE) based PtM systems ...

EPFL2024

Green hydrogen production using Shewanella oneidensis MR-1 bioanode and cuprous oxide-based photocathode

Michele Morgante

In recent years, many efforts have been made to find alternative renewable energy sources that can ideally replace the use of fossil fuels in all aspects. One of the new emerging energy technologies is the bioelectrochemical system, of which two types are ...

EPFL2024

Multiscale Spatiotemporal Characterization of Embodied Environmental Performance of Building Structures in Geneva from 1850 to 2018

Corentin Jean Dominique Fivet, Catherine Elvire L. De Wolf

Load-bearing systems in buildings, significant in material use and embodied greenhouse gas emissions (EGHGE), have lacked detailed analysis on their environmental and functional relationships over time and space. This study evaluates the environmental impa ...

2024

Advancing Cell-Free Synthetic Biology: From sustained PURE protein synthesis to an isothermal one-pot DNA replication system

Laura Sophie Grasemann

One of the goals of synthetic biology is the development of an artificial cell. Building an artificial cell from scratch will provide a deeper understanding of fundamental mechanisms and models in biology and promises to contribute towards building novel p ...

EPFL2024

Atomic level insight into irradiation effects in nuclear fuel materials

Shaileyee Bhattacharya

Microstructural evolution during in-pile irradiation, radiation damage effects and fission products behavior in UO2 nuclear fuel are key issues in understanding and for the modeling of the performance as well as safety characteristics of nuclear fuels in t ...

EPFL2024

Contrasting Views of the Electric Double Layer in Electrochemical CO2 Reduction: Continuum Models vs Molecular Dynamics

Sophia Haussener, Evan Fair Johnson

In the field of electrochemical CO2 reduction, both continuum models and molecular dynamics (MD) models have been used to understand the electric double layer (EDL). MD often focuses on the region within a few nm of the electrode, while continuum models ca ...

Amer Chemical Soc2024

Quantitative characterization of the inorganic phosphate gene regulatory networks in S. cerevisiae and bottom up engineering an orthogonal gene network

Shiyu Cheng

Gene regulatory networks (GRNs) play a crucial role in an organism's response to changing environmental conditions. Cellular behaviors typically result from the integration of multiple gene outputs, and their regulation often demands precise control of num ...

EPFL2024

In Situ Synthesis of CuxO/N Doped Graphdiyne with Pyridine N Configuration for Ammonia Production via Nitrate Reduction

Sophia Haussener, Jian Li, Roberto Valenza

Electroreduction of nitrate to ammonia provides an interesting pathway for wastewater treatment and valorization. Cu-based catalysts are active for the conversion of NO3− to NO2− but suffer from an inefficient hydrogenation process of NO2−. Herein, CuxO/N- ...

2024

Readiness evaluation of SOFC-MGT hybrid systems with carbon capture for distributed combined heat and power

Jan Van Herle, Jürg Alexander Schiffmann, Michele Gaffuri, Victoria Xu Hong He

The aggravation of climate change calls for the timely development and implementation of highly efficient, renewable, zero- or negative-emission energy solutions with high technological readiness and feasibility levels. Solid oxide fuel cells (SOFC) consti ...

Elsevier2023

The thermodynamic and life-cycle assessments of a novel charging station for electric vehicles in dynamic and steady-state conditions

Jan Van Herle, Hossein Pourrahmani

The current study performs the thermodynamic and life-cycle assessments (LCA) of a novel charging station in two system designs. The goal is to design an efficient charging station for electric vehicles with high efficiencies and low environmental impacts ...

Nature Portfolio2023

The design and development of anion exchange membranes for hydrogen fuel cells

Xingyu Wu

Hydrogen fuel cells are an essential component of hydrogen economy, which have been advocated as a major path towards the decarbonization of the energy sector. Within the two main types of low-temperature hydrogen fuel cells, anion-exchange membrane fuel c ...

EPFL2023

Expansion Work Recovery of Hydrogen for a FC-Truck-Tentative Design of an Expansion Machine

Alfred Rufer

Hydrogen powered vehicles use high-pressure reservoirs from which the gas is transferred to the low-pressure fuel-cell via a classical pressure reduction valve. In these systems no expansion work is recovered and the question is addressed of the potential ...

MDPI2023

Hybridisation Scenarios of Solid Oxide Fuel Cells, Batteries, and Internal Combustion Engines for Waterborne Transportation

François Maréchal, Daniel Alexander Florez Orrego, Eduardo Antonio Pina

The shipping industry was responsible for about 3% of global greenhouse gas (GHG) emissions in 2018. In this context, the International Maritime Organisation (IMO) has established stringent targets to reduce GHG emissions by at least 50% by 2050 compared t ...

Universidad de Las Palmas de Gran Canaria2023

Three-dimensional nanoimaging of fuel cell catalyst layers

Vasiliki Tileli, Robin Pierre Alain Girod

Catalyst layers in proton exchange membrane fuel cells consist of platinum-group-metal nanocatalysts supported on carbon aggregates, forming a porous structure through which an ionomer network percolates. The local structural character of these heterogeneo ...

NATURE PORTFOLIO2023

Fast online diagnosis for solid oxide fuel cells: Optimisation of total harmonic distortion tool for real-system application and reactants starvation identification

Jan Van Herle, Hamza Moussaoui

This study investigates the potential application of total harmonic distortion (THD), as a fast online monitoring tool, to identify the early signs of failure modes in solid oxide fuel cells (SOFC). Indeed, the timely detection and identification of faults ...

ELSEVIER2023