Publications related to DC and quench performance assessment from the EUROfusion HTS Quench Experiment campaign and projection to magnet operation

Related publications (10)

First measurements of velocity-space resolved intra-ELM fast-ion losses on the TCV tokamak

Ambrogio Fasoli, Basil Duval, Benoît Labit, Alexander Karpushov, Mario Ludovico Podesta, Jesús Poley Sanjuán, Umesh Kumar

Edge Localised Modes (ELMs) induced fast-ion losses have been characterised in the energy, E, and pitch, λ = v ∥ / v , space using a unique Fast Ion Loss Detector (FILD) on the tokamak à configuration variable. The FILD is equipped with a 128 Avalanche Pho ...

IOP Publishing Ltd2025

Effects of reflected electrons on the efficiency of high-power gyrotrons

Jean-Philippe Hogge, Jérémy Genoud

Efficiency is a key factor for high-power gyrotrons, particularly in future fusion power plants, where a large number of gyrotron units will be required for plasma heating. A single-stage depressed collector enhances efficiency from approximately 35% to 50 ...

2025

Electromagnetic instability and turbulence in plasmas with positive and negative triangularity

Olivier Sauter, Justin Richard Ball, Matteo Vallar, Reinart Andreas J. Coosemans

While a number of studies exist comparing positive triangularity (PT) and negative triangularity (NT) δ, the nature of how the normalized electron pressure β affects microinstabilities and turbulence in fusion devices with substantial δ has not been studie ...

AIP Publishing2025

Plasmoid drift and first wall heat deposition during ITER H-mode dual-SPIs in JOREK simulations

Mengdi Kong

The heat flux mitigation during the thermal quench (TQ) by the shattered pellet injection (SPI) is one of the major elements of disruption mitigation strategy for ITER. It's efficiency greatly depends on the SPI and the target plasma parameters, and is ult ...

IOP Publishing Ltd2024

Modeling, Optimization and Design of High Power Medium Frequency Transformers

Nikolina Djekanovic

Nowadays, direct current (DC) technology is increasing its presence in alternating current (AC) power systems. This trend is enabled by the progress in energy conversion through semiconductor devices and power electronics. Therefore, it is possible to imag ...

EPFL2023

Gyrokinetic moment-based simulations of the Dimits shift

Paolo Ricci, Baptiste Jimmy Frei, Antoine Cyril David Hoffmann

We present a convergence study of the gyromoment (GM) approach, which is based on projecting the gyrokinetic distribution function onto a Hermite–Laguerre polynomial basis, focused on the cyclone base case (CBC) (Lin et al., Phys. Rev. Lett., vol. 83, no. ...

Cambridge University Press2023

Design status of the double Closure Plate Sub-Plate concept for the ITER Electron Cyclotron Upper Launcher

Timothy Goodman, René Chavan, Jean-Daniel Landis, Avelino Mas Sanchez, Matteo Vagnoni, Phillip Miguel Santos Silva, Florian Ramseyer

The Closure Plate Sub-Plate (CPSP), which defines the border between ex-vessel and in-vessel components of the Electron Cyclotron Upper Launcher (EC UL), bundles the waveguides into a sub-assembly which can be manipulated separately from the UL Port Plug ( ...

Elsevier2018

Power requirements for electron cyclotron current drive and ion cyclotron resonance heating for sawtooth control in ITER

Olivier Sauter, Jonathan Graves, Stefano Coda, Timothy Goodman, Costanza Zucca, Martin Jucker

13 MW of electron cyclotron current drive (ECCD) power deposited inside the q = 1 surface is likely to reduce the sawtooth period in ITER baseline scenario below the level empirically predicted to trigger neoclassical tearing modes (NTMs). However, since t ...

IOP Publishing Ltd2013

Exploring a small sawtooth regime in Joint European Torus plasmas with counterinjected neutral beams

Stefano Coda, Jonathan Graves

During a recent reversed toroidal field (B-T) campaign at the Joint European Torus (JET), experiments were performed to investigate the effect on sawteeth of neutral beam injection (NBI)-driven toroidal plasma rotation counter to the direction of the toroi ...

2006

Collisionality and shear dependences of density peaking in JET and extrapolation to ITER

Henri Weisen, Ivo Furno, Alexey Zabolotskiy

Results from an extensive database analysis of JET density profiles in stationary conditions show that the density peaking factor n(e0)/< n(e)> in JET H modes increases from near 1.2 at high collisionality to around 1.5 as the plasma collisionality decreas ...

IOP Publishing Ltd2005