Publication

A Hall Sensor-Based Current Measurement Microsystem with Continuous Gain Calibration

Maher Kayal, Marc Pastre
2005
Conference Papers

Abstract

A novel technique for the continuous calibration of the sensitivity of Hall sensors is presented. Using an integrated coil and a new modulation/demodulation scheme, the sensitivity is measured and its drift eliminated. The obtained thermal drift is 50 ppm/degrees C, which corresponds to a reduction by a factor of 6-10 compared to the previous state of the art. The sensitivity drift due to purely mechanical stresses and ageing is also cancelled.

Official source

https://infoscience.epfl.ch/entities/publication/6a41dad3-3201-4173-8fd3-40b353c44439

About this result

This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.

Maher Kayal, Marc Pastre
2005
Conference Papers

Abstract

Official source

https://infoscience.epfl.ch/entities/publication/6a41dad3-3201-4173-8fd3-40b353c44439

About this result

Related concepts (16)

Modulation

In electronics and telecommunications, modulation is the process of varying one or more properties of a periodic waveform, called the carrier signal, with a separate signal called the modulation signal that typically contains information to be transmitted. For example, the modulation signal might be an audio signal representing sound from a microphone, a video signal representing moving images from a video camera, or a digital signal representing a sequence of binary digits, a bitstream from a computer.

Amplitude modulation

Amplitude modulation (AM) is a modulation technique used in electronic communication, most commonly for transmitting messages with a radio wave. In amplitude modulation, the amplitude (signal strength) of the wave is varied in proportion to that of the message signal, such as an audio signal. This technique contrasts with angle modulation, in which either the frequency of the carrier wave is varied, as in frequency modulation, or its phase, as in phase modulation.

Stress (mechanics)

In continuum mechanics, stress is a physical quantity that describes forces present during deformation. An object being pulled apart, such as a stretched elastic band, is subject to tensile stress and may undergo elongation. An object being pushed together, such as a crumpled sponge, is subject to compressive stress and may undergo shortening. The greater the force and the smaller the cross-sectional area of the body on which it acts, the greater the stress. Stress has units of force per area, such as newtons per square meter (N/m2) or pascal (Pa).

Related publications (31)

A 0.14-nJ/b 200-Mb/s 2.7-3.5-GHz Quasi-Balanced FSK Transceiver With PLL-Based Modulation and Sideband Energy Detection

Cong Ding, Bowen Wang

This paper describes a balanced frequency shift keying (FSK) modulation, namely quasi-balanced FSK (QB-FSK), for energy-efficient high-data-rate communication. Not suffering from data-pattern dependency, the proposed modulation method enables frequency mod ...

2024

Integrated Wireless Power, Data Communication, and Thermal Sensing System for Autonomous Multisite Brain Implants

Implanted medical devices (IMDs) have been widely developed to support the monitoring and recording of biological data inside the body or brain. Wirelessly powered IMDs, a subset of implantable electronics, have been proposed to eliminate the limitations r ...

EPFL2024

Influence of model uncertainty and long term deformations in action effects calculation in reinforced concrete structures

Xhemsi Malja

Most codes of practice adopt a semi probabilistic design approach for the dimensioning and assessment of structures. Accordingly, structural safety is ensured by performing limit state verifications using design values determined with adequately calibrated ...

EPFL2024