Publication

An Analysis of Flicker Noise Rejection in Low-Power and Low-Voltage CMOS Mixers

Christian Enz, Eric Vittoz
2001
Journal Articles

Abstract

The sensitivity of RF CMOS receivers using a direct conversion or a low-IF architecture is strongly affected by flicker noise. This paper gives theoretical guidelines to predict the flicker noise in Gilbert-cell mixers. The conversion gain, the equivalent input and output noise, and the effect of the pole at the single internal RF node are discussed. For the first time, results which are valid in all modes of operation are given. Such complete results are required for some ultra low-power and low-voltage applications, since the transistors might be operated in moderate or even weak inversion region. The theoretical gains are found to remain within a 2-dB margin with respect to the measurements of a UHF downconverter built in a 0.5-μm process, for a large range of bias conditions and local oscillator swing.

Official source

https://infoscience.epfl.ch/entities/publication/699e0f54-8fba-49ca-99a6-ef03ae05f167

About this result

This page is automatically generated and may contain information that is not correct, complete, up-to-date, or relevant to your search query. The same applies to every other page on this website. Please make sure to verify the information with EPFL's official sources.

Graph Chat

Chat with Graph Search

Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.

DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.

Christian Enz, Eric Vittoz
2001
Journal Articles

Abstract

Official source

https://infoscience.epfl.ch/entities/publication/699e0f54-8fba-49ca-99a6-ef03ae05f167

About this result

Related concepts (32)

Noise (electronics)

In electronics, noise is an unwanted disturbance in an electrical signal. Noise generated by electronic devices varies greatly as it is produced by several different effects. In particular, noise is inherent in physics and central to thermodynamics. Any conductor with electrical resistance will generate thermal noise inherently. The final elimination of thermal noise in electronics can only be achieved cryogenically, and even then quantum noise would remain inherent. Electronic noise is a common component of noise in signal processing.

Low-power electronics

Low-power electronics are electronics, such as notebook processors, that have been designed to use less electric power than usual, often at some expense. In the case of notebook processors, this expense is processing power; notebook processors usually consume less power than their desktop counterparts, at the expense of lower processing power. watch The earliest attempts to reduce the amount of power required by an electronic device were related to the development of the wristwatch.

MOSFET

The metal-oxide-semiconductor field-effect transistor (MOSFET, MOS-FET, or MOS FET) is a type of field-effect transistor (FET), most commonly fabricated by the controlled oxidation of silicon. It has an insulated gate, the voltage of which determines the conductivity of the device. This ability to change conductivity with the amount of applied voltage can be used for amplifying or switching electronic signals. A metal-insulator-semiconductor field-effect transistor (MISFET) is a term almost synonymous with MOSFET.

Related publications (32)

An Analysis of Flicker Noise Rejection in Low-Power and Low-Voltage CMOS Mixers

Chat with Graph Search

Frame Rate Enhancement Architectures for SPAD Image Sensors

Mitigating errors in state preparation and measurement with noncomputational states

MOSS 2: Mid-Frequency radio catalogue of the Saraswati core region