Publications related to Stress changes in H2-loaded SMF optical fibers induced by cw-Ar+ 244 nm irradiation

Related publications (29)

Quench Detection and Temperature Measurement With Fiber Optic Sensors

For the EU DEMO conductor testing, a temperature sensor based on Fiber Bragg Grating (FBG) optical fiber is studied at the EPFL Swiss Plasma Center. The SULTAN test facility has been upgraded to use fiber optic sensor for temperature monitoring and quench ...

IEEE Institute of Electrical and Electronics Engineers2024

Filiform Variable Stiffness Technologies for Medical Robotics

Yegor Piskarev

In recent years, soft robotics has surged in applications like wearables, drones, smart fabrics, and medical instruments. Due to their compliance, these devices excel in tasks demanding dexterity and adaptability, such as manipulation, locomotion, crash re ...

EPFL2024

Two-dimensional quasi-static delamination in composite laminates under Mode-I and Mode-II conditions

Congzhe Wang

Fiber-polymer composites consist of a polymer matrix and reinforcing fibers made of various materials. These composites exhibit exceptional properties, such as a high strength-to-weight ratio and excellent corrosion resistance, which has led to their incre ...

EPFL2024

Proliferation-driven mechanical compression induces signalling centre formation during mammalian organ development

Sangwoo Kim

Localized sources of morphogens, called signalling centres, play a fundamental role in coordinating tissue growth and cell fate specification during organogenesis. However, how these signalling centres are established in tissues during embryonic developmen ...

Nature Portfolio2024

Strain engineering and strain measurement by spring tethers on suspended epitaxial GaN-on-Si photonic crystal devices

Romuald Houdré, Jun Wang

Suspended epitaxial gallium nitride (GaN) on silicon (Si) photonic crystal devices suffer from large residual tensile strain, especially for long waveguides, because fine structures tend to crack due to large stress. By introducing spring-like tethers, des ...

Iop Publishing Ltd2024

Frictional weakening leads to unconventional singularities during dynamic rupture propagation

Marie Estelle Solange Violay, François Xavier Thibault Passelègue, Mathias Alexandre David Lebihain, Federica Paglialunga

Earthquakes i.e. frictional ruptures, are commonly described by singular solutions of shear crack motions. These solutions assume a square root singularity order around the rupture tip and a constant shear stress value behind it, implying scale-independent ...

2024

All-Dielectric Nanophotonic via Glass Fluid Instabilities

Pierre-Luc Eloi Piveteau

In this thesis work, we propose to exploit an innovative micro/nano-fabrication process, based on controlled fluid instabilities of a thin viscous film of chalcogenide glass. Amorphous selenium and arsenic triselenide were used in this thesis work, and com ...

EPFL2024

Soft Multimaterial Magnetic Fibers and Textiles

Fabien Sorin, Andreas Leber, Chaoqun Dong, Hritwick Banerjee, Stella Andréa Françoise Laperrousaz, Rémi Andréa La Polla

Magnetically responsive soft materials are promising building blocks for the next generation of soft robotics, prosthesis, surgical tools, and smart textiles. To date, however, the fabrication of highly integrated magnetic fibers with extreme aspect ratios ...

Wiley-V C H Verlag Gmbh2023

Process development of pre-impregnated hybrid thin-ply composites

Alexios Argyropoulos

Thin-ply composites, obtained with recently developed fiber spreading techniques, rapidly gained industrial interest because they offer a large composite design freedom, and lead to a composite tensile strength that is close to that of the individual fiber ...

EPFL2023

Multi-scale characterization and modeling of notched strength and translaminar fracture in hybrid thin-ply composites based on different carbon fiber grades

Guillaume Clément Broggi

Owing to their high specific stiffness and strength, Carbon Fiber Reinforced Composites (CFRP) are ideal candidates for the development of lightweight high-performance structures. Within this family, thin-ply composites allow for wider design freedom and p ...

EPFL2023

Single-Well Pore Pressure Preconditioning for Enhanced Geothermal System Stimulation

Marie Estelle Solange Violay, Barnaby Padraig Fryer, Mathias Alexandre David Lebihain

The stress state is an important parameter in terms of both earthquake nucleation and rupture. Here, a new stimulation technique is proposed for Enhanced Geothermal Systems (EGSs), which have previously been burdened with a number of high-profile incidence ...

2023

Drained Clay-Pipe Interface Resistance at Low Normal Stresses and Elevated Temperatures

Roba Houhou

Offshore pipelines that transport hydrocarbons under high pressure and high temperature are usually thermally insulated to maintain an elevated temperature and prevent any heat loss to the surroundings. However, the temperatures at the outer-wall of the pi ...

AMER SOC CIVIL ENGINEERS2023

Evaluation of neutron dose rates at the TCV tokamak facility

Henri Weisen, Patrick Blanchard, Matteo Vallar

A detailed MCNP neutronics model of the building housing the TCV tokamak has been developed. Predicted dose rates have been compared to neutron dose measurements at 12 locations in the building obtained during neutral beam injection into TCV plasmas. This ...

2023

Thermally Drawn Elastomer Nanocomposites for Soft Mechanical Sensors

Fabien Sorin, Yunpeng Qu, Andreas Leber, Inès Richard, Chaoqun Dong, Stella Andréa Françoise Laperrousaz

Stretchable and conductive nanocomposites are emerging as important constituents of soft mechanical sensors for health monitoring, human-machine interactions, and soft robotics. However, tuning the materials' properties and sensor structures to the targete ...

WILEY2023

Psychosomatic response to acute emotional stress in healthy students

Adriana Arza Valdes

The multidimensionality of the stress response has shown the complexity of this phenomenon and therefore the impossibility of finding a unique biomarker among the physiological variables related to stress. An experimental study was designed and performed t ...

FRONTIERS MEDIA SA2023

Electrospun zein incorporating phycocyanin and Spirulina extract: Fabrication, characterization, and potential application

Niloufar Sharif

Electrospinning was used to develop zein fibers containing phycocyanin and aqueous-ethanolic extract of Spirulina (AEES) for elucidating the potent packaging properties of phycocyanin and AEES on walnut samples. Morphological results revealed that using th ...

Elsevier2023

Soft Bending Actuator With Fiber-Jamming Variable Stiffness and Fiber-Optic Proprioception

Sudong Lee

Soft actuators with a function of variable stiffness are beneficial to the improvement of the adaptability of robots, expanding the application areas and environments. We propose a tendon-driven soft bending actuator that can change its stiffness using fib ...

Ieee-Inst Electrical Electronics Engineers Inc2023

Cotton yarns decorated with hydrothermally reduced graphene oxide for flexible supercapacitors

Dou Du

Cotton fibers, a natural cellulose, have played a critical role in the development of wearable energy storage, owning to their wearability, integrability, eco-benignity, and cost effectiveness. Graphene, a two-dimensional carbon material, possesses excelle ...

Elsevier2023

Nanoscale local modification of PMMA refractive index by tip-enhanced femtosecond pulsed laser irradiation

Mihai Adrian Ionescu

Tip-enhanced optical effects have enabled a wide palette of nanoscale investigation techniques and recently they were successfully used to modify and manipulate matter with nanoscale spatial resolution. We contribute to this latter area by reporting a viab ...

ELSEVIER2023

Hydro-mechanichal characterisation of bentonite/steel interfaces

Alessio Ferrari, Eleni Stavropoulou

The hydromechanical response of a Wyoming-type bentonite (MX-80) and its interface with steel was studied in terms of shear resistance under different hydration levels. A series of shear tests under constant normal stress were performed in total suction co ...

2023