Influence of Large Relative Tip Clearances for a Micro Radial Fan and Design Guidelines for Increased Efficiency

Chat with Graph Search

Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.

DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.

Wind tunnel experiments are performed to investigate the effect of nacelle-to-rotor size on the wake of a wind turbine under different Reynolds numbers. Four different turbine configurations are tested, which vary in the rotor diameter and nacelle length a ...

Coupling a biomass gasifier with a solid oxide fuel cell system through a high-temperature syngas compressor holds great promise to achieve low-emission, small-scale combined heat and power, since it reduces the number of heat exchangers and increases the ...

We investigate the effect of pressure gradient on the cumulative wake of multiple turbines in wind tunnel experiments spanning across a range of adverse pressure gradient (APG), zero pressure gradient (ZPG), and favorable pressure gradient (FPG). Compared ...

Static axial induction control and tilt control are two strategies that have the potential to increase power production in wind farms, mitigating wake effects and increasing the available power for downstream turbines. In this study, wind tunnel experiment ...

In this thesis, we explore the best practice of simulating the wakes of the turbines under active yaw control (AYC) using large-eddy simulation (LES). In the first study, we validate the blade-element actuator disk model (ADM-BE) for a yawed wind turbine. ...

Large Eddy Simulations (LES) of atmospheric boundary layer (ABL) flow with the actuator disc (AD) for turbine modelling is a widely used method of simulating wind farm flows. Hence, it is important to understand the requirements for achieving a good compar ...

According to the International Energy Agency, the global net-zero emissions objective requires the installed wind power capacity to increase 11-fold between 2020 and 2050. The scientific community has recently voiced concerns about the logistic feasibility ...

The presence of aerodynamic vortices is widespread in nature. They can be found at small scales near the wing tip of flying insects or at bigger scale in the form of hurricanes, cyclones or even galaxies. They are identified as coherent regions of high vor ...

Numerical simulation of tip vortex cavitation (TVC) remains a challenging task in a variety of applica-tions, such as axial turbines and pumps as well as marine propellers. Although it is well known that TVC is highly sensitive to gas content, be it dissol ...

The hydropower sector has recently raised the interest in pump as turbine (PaT) that can be a valid trade-off between capital cost and performance in micro-scale installations. Nevertheless, the modest efficiency of PaTs often restricts their exploitation. ...

Shell elements derived from the Kirchhoff-Love theory have experienced a renaissance in the Finite Element community since the advent of isogeometric analysis. Despite numerous promising advancements in the field, several questions need to be addressed to ...

This thesis presents the results of the design and experimental investigation of a patented 10 kWel solid oxide fuel cell (SOFC) system with a thermally-driven anode off-gas recirculation (AOR) fan, the so-called fan-turbine unit (FTU). The system has the ...

Reduced-scale refrigeration compressors supported on gas-lubricated bearings have been identified as a key technology for domestic heat pump applications, in order to improve both the system efficiency and the reliability. Unfortunately, reduced-scale mach ...

A micro steam turbine with a tip diameter of 15 mm was designed and experimentally characterized. At the nominal mass flow rate and total-to-total pressure ratio of 2.3 kg/h and 2, respectively, the turbine yields a power of 34 W and a total-to-static isen ...

This work is part of a project aiming at dimensioning a fishway for a hydroelectric power plant on the Rhine River. Here we only focus on the design of the fishway entrances, for which a physical model of the draft tubes and tailrace of the powerplant was ...

A micro steam turbine with a tip diameter of 15mm was designed and experimentally characterized. At the nominal mass flow rate and total-to-total pressure ratio of 2.3 kgh-1 and 2, respectively, the turbine yields a power of 34W and a total-to-static isent ...

In this work, an experimental investigation of the grounding system behavior of tall wind turbines in both time and frequency domains is presented. Two scenarios were considered: in the first one, measurements were carried out on the grounding system embed ...

The Laboratory for Applied Mechanical Design (LAMD) designed, manufactured, and experimentally tested a novel recirculation fan for a 10 kWe solid oxide fuel cell (SOFC). The fan uses oil-free bearings, more specifically herringbone-grooved journal and spi ...

A numerical framework for the aerodynamic characterization of wind turbine airfoils is developed and applied to the miniature wind turbine WiRE-01. The framework is based on a coupling between wall-resolved large eddy simulation (LES) and application of th ...

The present study concerns the numerical homogenization of second order hyperbolic equations in non-divergence form, where the model problem includes a rapidly oscillating coefficient function. These small scales influence the large scale behavior, hence t ...

Influence of Large Relative Tip Clearances for a Micro Radial Fan and Design Guidelines for Increased Efficiency

Chat with Graph Search

The effect of nacelle-to-rotor size on the wake of a miniature wind turbine

A High-Speed, High-Temperature Micro-Cantilever Steam Turbine for Hot Syngas Compression in Small-Scale Combined Heat and Power

Wind turbine wake superposition under pressure gradient

Enhancing Wind Farm Performance through Axial Induction and Tilt Control: Insights from Wind Tunnel Experiments

Wind Turbine Wakes in Active Yaw Control: Numerical and Theoretical Studies

Cross-code verification of non-neutral ABL and single wind turbine wake modelling in LES

Dynamic stall characterisation and control for vertical-axis wind turbines

Growth, timing, & trajectory of vortices behind a rotating plate

A new Euler-Lagrangian cavitation model for tip-vortex cavitation with the effect of non-condensable gas

Numerical investigation on the volute cutwater for pumps running in turbine mode

Accurate isogeometric methods for trimmed shell structures

Integrated Design, Optimization, and Experimental Realization of a Steam-Driven Micro Recirculation Fan for Solid Oxide Fuel Cell Systems

Mitigation of tip leakage induced phenomena in a low Reynolds number centrifugal compressor via blade loading distribution

Theoretical and Experimental Investigation of a 34 Watt Radial-Inflow Steam Turbine with Partial-Admission

Physical and 3D Numerical Simulations of the Flow in the Tailrace of a Hydroelectric Power Plant to Design Fishway Entries

Theoretical and Experimental Investigation of a 34 Watt Radial-Inflow Steam Turbine with Partial-Admission

An experimental field study of the grounding system response of tall wind turbines to impulse surges

Theoretical and Experimental Investigation of a Small-scale, High-speed, and Oil-free Radial Anode Off-gas Recirculation Fan for Solid Oxide Fuel Cell Systems

Numerical Framework for Aerodynamic Characterization of Wind Turbine Airfoils: Application to Miniature Wind Turbine WiRE-01

An Equation-Free Approach For Second Order Multiscale Hyperbolic Problems In Non-Divergence Form