Publications related to Understanding of the factors slowing down metakaolin reaction in limestone calcined clay cement (LC3) at late ages

Related publications (32)

Water weakening and the compressive brittle strength of carbonates: Influence of fracture toughness and static friction

Marie Estelle Solange Violay, Corentin Jean-Marie Rémi Noël, Barnaby Padraig Fryer

Water is ubiquitous within the pore space of rocks and has been shown to affect their physical and mechanical behaviour. Indeed, water can act on the rock strength via mechanical (i.e., reducing the effective stresses) or chemical effects (e.g., mineral di ...

2024

Multiscale Porosity Microfluidics to Study Bacterial Transport in Heterogeneous Chemical Landscapes

Francesco Carrara, Jiande Zhou

Microfluidic models are proving to be powerful systems to study fundamental processes in porous media, due to their ability to replicate topologically complex environments while allowing detailed, quantitative observations at the pore scale. Yet, while por ...

Wiley2024

Influence of Low- to Medium-Kaolinite Clay on the Durability of Limestone Calcined Clay Cement (LC3) Concrete

Karen Scrivener

The kaolinite content is principally responsible for the durability performance of Limestone Calcined Clay Cement (LC3), which calls into question its global applicability. The clay supply has a significant impact on the LC3 system's reduced carbon footpri ...

MDPI2023

Temperature and relative humidity in 10 min time resolution measured in the total inlet of the Swiss container during MOSAiC 2019/2020

Julia Schmale, Ivo Fabio Beck, Benjamin Jérémy Laurent Heutte

This dataset contains the temperature and relative humidity in a bypass to the total inlet, measured during the MOSAiC expedition from October 2019 to September 2020. The measurements were performed in the bypass interstitial inlet of the Swiss container o ...

Zenodo2023

Going Below 50% Clinker Factor in Limestone Calcined Clay Cements (LC3): A Comparison with Pozzolanic Cements from the South American Market

Karen Scrivener, Franco Alberto Zunino Sommariva

Limestone calcined clays are a promising technology as they offer similar performance to OPC from 7 days onwards, while enabling a reduction of the clinker content of 50%. In some regions of the world like South America, pozzolanic cements (i.e., blended c ...

SPRINGER INTERNATIONAL PUBLISHING AG2023

Durability Challenges of Low-Grade Calcined Clay Opposed to High-Volume Fly Ash in General Purpose Concrete

Karen Scrivener

With the decrease in availability of common supplementary cementitious materials (SCMs) such as fly ash in Europe, the search for appropriate SCMs should be dealt with locally. A com-bination of abundant low-grade calcined clay and limestone powder has pro ...

AMER SOC TESTING MATERIALS2023

Visualization and modelling of dynamic flow in fibrous preforms for liquid composite molding

Helena Luisa Teixido Pedarros

Nowadays, Liquid Composite Molding techniques are often used to manufacture high quality fiber reinforced composite parts at a relatively low cost. These involve an infiltration process, in which a liquid resin is forced to ingress into a dry fibrous porou ...

EPFL2023

Unsupervised Electrofacies Clustering Based on Parameterization of Petrophysical Properties: A Dynamic Programming Approach

François Fleuret

Electrofacies using well logs play a vital role in reservoir characterization. Often, they are sorted into clusters according to the self-similarity of input logs and do not capture the known underlying physical process. In this paper, we propose an unsupe ...

SOC PETROPHYSICISTS & WELL LOG ANALYSTS-SPWLA2023

Influence of temperature on phase assemblages of belite-ye'elimite cement

Karen Scrivener, Diana Londoño Zuluaga, Natechanok Chitvoranund

This paper studies the effect of temperature on the phase assemblages of belite-ye'elimite cement. A comparison is made between thermodynamic modelling and experimental data at 28 and 180 days of hydration at 5, 20, 40, and 60 degrees C. The fast reaction ...

Pergamon-Elsevier Science Ltd2023

Pore-pressure coefficients for unsaturated soils: generalized effective stress approach

Lyesse Laloui, Alessio Ferrari, Angelica Tuttolomondo

Geotechnical problems with total stress changes occurring rapidly relative to the soil consolidation time can be conveniently addressed using an effective stress-based approach. For saturated states, analytical formulations of pore-pressure coefficients ad ...

CANADIAN SCIENCE PUBLISHING2023

Characterisation and hydration kinetics of beta-C2S synthesised with K2SO4 as dopant

Karen Scrivener, Franco Alberto Zunino Sommariva

In this study, a protocol for synthesising beta-C2S using K2SO4 as a dopant has been reported. Quantitative X-Ray diffraction was used to characterise synthesised samples. It was observed that it is possible to synthesise beta-C2S with high purity (>96 wt% ...

Pergamon-Elsevier Science Ltd2023

Addressing the challenges of homogeneity, quality control and waste handling in soil bio-cementation: A large-scale experiment

Lyesse Laloui, Dimitrios Terzis, Ray Harran

In an attempt to go beyond the conventional laboratory experiments widely reported in literature around the emerging technique of soil bio-cementation, this work addresses key challenges related to its large-scale application. Precisely, a state-of-the-art ...

JAPANESE GEOTECHNICAL SOC2023

The effect of pore microstructure on strength and chloride ingress in blended cement based on low kaolin clay

Karen Scrivener, Diana Londoño Zuluaga

The objective of this study is to analyse the mechanical and durability properties of a high-performance mortars based on low grade kaolin clay and the effect of electrical conductivity and pore microstructure on the chloride penetration resistance. A tota ...

ELSEVIER2022

Hydration and durability of fast hardening binders incorporating supplementary cementitious materials

Sarra El Housseini

The use of supplementary cementitious materials (SCMs) is widely considered the most promis-ing approach to reduce CO2 emissions relative to cement production. SCMs are not commonly present in binders used for special applications. On the other hand, due t ...

EPFL2022

Hydration and mixture design of calcined clay blended cements: review by the RILEM TC 282-CCL

Karen Scrivener, Franco Alberto Zunino Sommariva, Mohsen Ben Haha, François Henri Avet

The RILEM technical committee 282-CCL: Calcined Clays as Supplementary Cementitious Materials, investigates all the aspects related to calcined clays, from clay exploration and characterization to calcination process, hydration reactions and concrete prope ...

SPRINGER2022

Nanoscale modelling of ionic transport in the porous C-S-H network

Khalil Ferjaoui

To reduce the CO2 footprint of construction materials, concrete producers blend their cement with Supplementary Cementitious Materials (SCMs). SCMs such as fly ash or blast furnace slag are mostly the byproducts of other industries. And while SCMs are chos ...

EPFL2022

Microstructural developments of limestone calcined clay cement (LC3) pastes after long-term (3 years) hydration

Karen Scrivener, Franco Alberto Zunino Sommariva

LC3 is one of the most promising alternatives for a high-performance blended cement with a significantly lower clinker content and with potential for worldwide adoption. For this reason, understanding its long-term performance is relevant to ensure service ...

Pergamon-Elsevier Science Ltd2022

Reactive dicalcium silicate binders: Microstructure and transport properties

Adrian-Alexandru Pîrvan

The calcium silicate hydrates (C-S-H) are without doubt one of the most important hydration products in a hardened cement paste. Giving the complexity of the microstructure that forms by hydration of ordinary Portland cement (OPC) and the more recently use ...

EPFL2022

Resistance of cementitious materials to sulfate attack: quantifying performance with a reliable unidirectional approach

Qiao Wang

Depending on the environmental conditions, concrete materials can come into contact with sulfate ions which are widely present in rivers, underground water, sewers, seawater and soil. Sulfates can react with the cement paste in concrete and cause damage wh ...

EPFL2022

Properties and occurrence of clay resources for use as supplementary cementitious materials: a paper of RILEM TC 282-CCL

Franco Alberto Zunino Sommariva, Ruben Anton Snellings, Alastair Thomas Matthew Marsh

The use of clays as resource of supplementary cementitious materials (SCMs) for a new generation of low-carbon cements and concretes is currently the subject of intense research efforts. To this purpose, a large number of clay resources have been explored, ...

SPRINGER2022