Indium and Silver Recovery from Perovskite Thin Film Solar Cell Waste by Means of Nanofiltration

Due to minimal material use and low-cost processing, next-generation thin film solar cells represent a promising alternative to traditional crystalline silicon solar cells. Among these, metal-halide perovskite solar cells have seen significant improvements in power conversion efficiency and are now on the verge of market entry. However, most efficient and stable perovskite solar cells contain lead in the perovskite absorber layer, along with indium and silver in their electrodes. This study demonstrates an environmentally benign recycling process for recovering all three elements from end-of-life perovskite solar cells. In short, the process consists of mechanical dismantling (milling), aqueous extraction/purification of PbI 2 , and acid extraction and purification of indium and silver by nanofiltration. After the quantitative recovery of lead as PbI 2 (95 ± 5%), indium and silver were dissolved using nitric acid with recovery rates of 87 ± 7% for both metals. Life cycle assessment calculations were used to determine optimal conditions in terms of minimal environmental impact per gram of extracted element. After acid extraction, nanofiltration was employed using both custom-made layer-by-layer membranes and commercially available acid-resistant flat sheet membranes to separate indium from silver. Using an optimized membrane design, indium was almost entirely retained (96.9 ± 0.4%) using a layer-by-layer membrane at 50% permeate recovery. Hence, a twofold concentration of indium was achieved over the course of the filtration. In contrast, silver was not retained (retention of −7.6 ± 6.3%), resulting in a dilute Ag permeate. Using the commercial flat sheet membrane resulted in similar retention rates, with 98.5 ± 0.4% for indium and 5.8 ± 11.6% for silver. However, this came at the expense of considerably higher operating pressure (25 bar vs 5 bar) and lower flux (6 L/m 2 h vs 30 L/m 2 h), resulting in higher energy demand (72 Wh/L vs 9 Wh/ L). Therefore, layer-by-layer membrane filtration proved to be the superior method for element recovery from perovskite photovoltaic devices. This study has shown that combining hydrometallurgical processing (aqueous and acidic extraction) with layerby-layer membrane filtration offers an efficient and environmentally benign approach for metal recovery from end-of-life solar cells. Since indium and silver are also key elements for other thin film photovoltaic applications, layer-by-layer membrane filtration may represent a platform technology for future photovoltaic panel recycling.