Publication
Nowadays, the interest in 2D materials has gone far beyond graphene. Specially, monolayers of transition metal dichalcogenides (TMDs) offer a broad spectrum of electronic and optical properties, and show the potential to revolutionize the electronics industry. The promising electronic properties of 2D semiconductors combined with their mechanical strength and flexibility, makes them ideal candidates for nanoelectromechanical systems (NEMS). This thesis focuses on realizing NEMS based on graphene and MoS2, which is one of the most appealing TMDs. First, we present the realization of graphene NEMS by fabricating single and bilayer graphene transistors featuring a doubly clamped suspended channel. The electromechanical response of monolayer graphene nanoribbons show a strain-induced increase in their electrical resistance, making it possible to estimate an upper limit for the piezoresistive gauge factor. Surprisingly, we observe oscillations in the electromechanical response of bilayer graphene. Our numerical simulations indicate that these oscillations arise from quantum mechanical interference in the transition region induced by sliding of the two graphene layers with respect to each other. Our results report on the rare observation of room temperature electronic interference in bilayer graphene. Next, we investigate the static electromechanical response of atomically thin MoS2. MoS2 exhibits high youngâ s modulus and fracture strength. Furthermore, the bandgap of MoS2 is highly strain-tunable. This coupling between electrical and mechanical properties makes MoS2 a promising material for NEMS. Here we incorporate monolayer, bilayer and trilayer MoS2 in a suspended membrane configuration with the electrodes acting as mechanical clamps. Strain-induced bandgap tuning is detected via electrical conductivity measurements and the emergence of the piezoresistive effect in MoS2 is demonstrated. We observe a reversible bandgap modulation in atomically thin MoS2 membranes with a thickness dependent modulation rate. Finite element method (FEM) simulations are used to obtain the spatially varying bandgap profile on the membrane and to quantify the rate of bandgap change. The piezoresistive gauge factor is calculated for single layer, bilayer and trilayer MoS2. Our results reveal that monolayer and bilayer MoS2 show a piezoresistive effect which is comparable to the state-of-the-art silicon strain sensors and two orders of magnitude higher than in graphene. Finally, we present the investigation of MoS2 NEMS resonators working in the VHF range and featuring piezoresistive transduction. The atomic thickness of monolayer MoS2 places it as a promising candidate for miniaturization of electromechanical devices to the limits of vertical scaling. While the small mass of MoS2 leads to an increased resonant frequency and a higher mass sensitivity, the presence of piezoresistivity offers a transduction mechanism in addition to the traditional capacitive transduction.