Publications related to Duct modes damping through an adjustable electroacoustic liner under grazing incidence

Related publications (31)

A Two-Wired High Input Impedance and High CMRR Active Electrode Insensitive to Component Mismatch

This article proposes a new two-wired amplifying active electrode (AE), presenting a high input impedance and a high common-mode rejection ratio (CMRR). In the proposed structure, the input impedance and the CMRR of the system are considerably increased by ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Smart Acoustic Lining for UHBR Technologies Engine Part 1: Design of an Electroacoustic Liner and Experimental Characterization Under Flow in Rectangular Cross-Section Ducts

Hervé Lissek, Maxime Volery

The new generation of Ultra-High-By-Pass-Ratio (UHBR) turbofan engine while considerably reducing fuel consumption, threatens higher noise levels at low frequencies because of its larger diameter, lower number of blades and rotational speed. This is accomp ...

American Institute of Aeronautics and Astronautics2024

The Advection Boundary Law in presence of mean-flow and spinning modes

In the attempt to reduce fuel consumption, a new generation of Ultra-High-By-Pass-Ratio (UHBR) turbofans have been introduced in the aeronautic industry which are structurally noisier especially at lower frequencies, because of their larger diameter, lower ...

SPIE2024

Impact of beam-coupling impedance on the Schottky spectrum of bunched beam

Tatiana Pieloni, Nicolas Frank Mounet, Christophe Emmanuel R. Lannoy

The Schottky monitors of the Large Hadron Collider (LHC) can be used for non-invasive beam diagnostics to estimate various bunch characteristics, such as tune, chromaticity, bunch profile or synchrotron frequency distribution. However, collective effects, ...

Iop Publishing Ltd2024

A Cavity-Microscope for Quantum Simulations with Locally-Controllable All-to-All Interactions

Nick Jacob Sauerwein

This thesis presents the development, construction, and benchmark of an experimental platform that combines cold fermionic 6Li atoms with locally controllable light-matter interactions. To enable local control, a new device, the cavity-microscope, was crea ...

EPFL2024

Robust tunable acoustic impedance control on electroacoustic resonators for aircraft noise reduction

Maxime Volery

Air traffic noise emissions are responsible for a significant part of the overall environmental noise, especially in the vicinity of airports. Exposure to environmental noise is known to negatively impact health and to be associated with cardiovascular dis ...

EPFL2023

Lightning interaction with the ionosphere

Farhad Rachidi-Haeri, Marcos Rubinstein

Lightning discharges, including cloud-to-ground (CG) and intracloud (IC) lightning, are known to emit electromagnetic pulses (EMPs) in a wide frequency band ranging from few Hz up to hundreds MHz [1]. During the breakdown and ionization processes (mostly f ...

IET2023

Toward Band n78 Shear Bulk Acoustic Resonators Using Crystalline Y-Cut Lithium Niobate Films With Spurious Suppression

Luis Guillermo Villanueva Torrijo, Soumya Yandrapalli

This work presents the study of suspended Y-cut Lithium Niobate shear bulk acoustic resonators for wide band filter applications in the frequency range of 3.5-4.5GHz. The resonators consist of a Lithium Niobate film with Aluminum top interdigitated electro ...

Institute of Electrical and Electronics Engineers2023

Resonators with tailored optical path by cascaded-mode conversions

Ileana-Cristina Benea-Chelmus

Optical resonators enable the generation, manipulation, and storage of electromagnetic waves. The physics underlying their operation is determined by the interference of electromagnetic waves, giving rise to the resonance spectrum. This mechanism causes th ...

Nature Portfolio2023

First developments towards producing inductive magnetic sensors using state-of-the-art photolithography techniques

Ambrine Douhane, Marcus Cemes, Duccio Testa

Inductive magnetic sensors are needed for tokamak operation to provide the low-frequency (LF) measurements leading to the equilibrium reconstruction and to monitor the higher frequency (HF) instabilities; the HF magnetic sensors are often also used as a ba ...

2023

Robust direct acoustic impedance control using two microphones for mixed feedforward-feedback controller

Hervé Lissek, Maxime Volery, Xinxin Guo

This paper presents an acoustic impedance control architecture for an electroacoustic absorber combining both feedforward and feedback microphone-based strategies on a current-driven loudspeaker. Feedforward systems enable good performance for direct imped ...

EDP SCIENCES S A2023

Dynamic behavior of exposed geomembrane systems in pressure waterways

Giovanni De Cesare, Samuel Luke Vorlet

Geomembrane systems have been used in dams and reservoirs as rehabilitation technology since several decades and are now used worldwide. They act as impervious layer to prevent and mitigate water leakage and damage to structures. They meet the needs of man ...

CRC Press/Balkema2023

NbN films with high kinetic inductance for high-quality compact superconducting resonators

Edoardo Charbon, Pasquale Scarlino, Fabrizio Minganti, Simone Frasca, Marco Scigliuzzo, Fabian Oppliger, Vincent Jean Yves Jouanny

Niobium nitride (NbN) is a particularly promising material for quantum technology applications, as it shows the degree of reproducibility necessary for large-scale superconducting circuits. We demonstrate that resonators based on NbN thin films present a o ...

American Physical Society (APS)2023

Self-Synchronized Grid Impedance Estimation Unit using Interpolated DFT Technique

Drazen Dujic, Andrea Cervone, Jules Christian Georges Macé

Estimating the impedance of a grid-connected device or of a grid at the point of common coupling is important for evaluating the interaction between them. Impedance measurement involves a perturbation injection device, that perturbs the system, and a measu ...

2023

Nanomechanical resonators with low dissipation for quantum optomechanics

Alberto Beccari

Fields of technology as diverse as microwave filter construction, characterization of material interfaces with atomic precision, and detection of gravitational waves from astronomical sources employ mechanical resonators at their core. The utility of mecha ...

EPFL2023

Damping of flexure blades based on bi-material additive manufacturing

Simon Nessim Henein, Florent Cosandier, Loïc Benoît Tissot-Daguette, Nikola Kalentics, Florent Alexandre Boudoire, Elias Sebastian Klauser

Flexure-based mechanisms have become state-of-the-art solutions for the design of high-precision mechanisms, free from friction wear, backlash, and lubrication. These properties which are necessary for applications in ultraclean or harsh environments, neve ...

2023

WINC: A Wireless IoT Network for Multi-Noise Source Cancellation

Haitham Al Hassanieh, Junfeng Guan

This paper introduces Wireless IoT-based Noise Cancellation (WINC) which defines a framework for leveraging a wireless network of IoT microphones to enhance active noise cancellation in noise-canceling headphones. The IoT microphones forward ambient noise ...

Assoc Computing Machinery2023

Plasma-based Electroacoustic Actuator for Broadband Sound Absorption

Stanislav Sergeev

Environmental noise, mostly related to human activities, has an immense impact on public health. The development of noise reduction technologies is paramount in addressing this problem. Because of practical and economic reasons, a compact, broadband, light ...

EPFL2022

PID-like active impedance control for electroacoustic resonators to design tunable single-degree-of-freedom sound absorbers

Hervé Lissek, Maxime Volery, Xinxin Guo

Sound absorption at low frequencies still remains a challenge in both scientific research and engineering practice. Natural porous materials are ineffective in this frequency range, as well as acoustic resonators which present too narrow bandwidth of absor ...

2022

Corona discharge actuator as an active sound absorber under normal and oblique incidence

Hervé Lissek, Stanislav Sergeev

In the majority of active sound absorbing systems, a conventional electrodynamic loudspeaker is used as a controlled source. However, particular situations may require an actuator that is more resistant to harsh environments, adjustable in shape, and light ...

2022