Publications related to Simulation of water column separation in Francis pump-turbine draft tube

Related publications (28)

Enhancing Wind Farm Performance through Axial Induction and Tilt Control: Insights from Wind Tunnel Experiments

Fernando Porté Agel, Guillem Armengol Barcos

Static axial induction control and tilt control are two strategies that have the potential to increase power production in wind farms, mitigating wake effects and increasing the available power for downstream turbines. In this study, wind tunnel experiment ...

MDPI2024

The effect of nacelle-to-rotor size on the wake of a miniature wind turbine

Fernando Porté Agel, Arslan Salim Dar

Wind tunnel experiments are performed to investigate the effect of nacelle-to-rotor size on the wake of a wind turbine under different Reynolds numbers. Four different turbine configurations are tested, which vary in the rotor diameter and nacelle length a ...

IOP Science2024

Wind turbine wake superposition under pressure gradient

Fernando Porté Agel, Arslan Salim Dar

We investigate the effect of pressure gradient on the cumulative wake of multiple turbines in wind tunnel experiments spanning across a range of adverse pressure gradient (APG), zero pressure gradient (ZPG), and favorable pressure gradient (FPG). Compared ...

2024

Power performance of a model floating wind turbine subjected to cyclic pitch motion: A wind tunnel study

Fernando Porté Agel, Guiyue Duan, Daniele Gattari

Wind tunnel experiments were performed with a miniature floating wind turbine model to study the effects of cyclic pitch motion on its power performance. The cyclic pitch motion was prescribed by two key parameters: pitch frequency and amplitude. The power ...

IOPscience2024

Towards an improved understanding of wind turbine wakes in complex terrain

Arslan Salim Dar

In this thesis, we explored the effect of certain terrain-induced flow phenomena on the development of wind turbines sited in complex terrain. A combined experimental and analytical approach is used to study wind turbine wakes in different types of complex ...

EPFL2024

Optimal blade pitch control for enhanced vertical-axis wind turbine performance

Karen Ann J Mulleners, Sébastien Le Fouest

Vertical-axis wind turbines are great candidates to enable wind power extraction in urban and off-shore applications. Currently, concerns around turbine efficiency and structural integrity limit their industrial deployment. Flow control can mitigate these ...

Nature Research2024

Non-contact sensing for anomaly detection in wind turbine blades: A focus-SVDD with complex-valued auto-encoder approach

Olga Fink, Gaëtan Michel Frusque

The occurrence of manufacturing defects in wind turbine blade (WTB) production can result in significant increases in operation and maintenance costs of WTBs, reduce capacity factors of wind farms, and occasionally lead to severe and disastrous consequence ...

2024

Study of flexible operating conditions in variable-speed hydraulic turbines : advanced models and experimental validation

Martin Seydoux

The global imperative to transition from fossil fuel-based energy sources to renewable alternatives has become increasingly urgent in the pursuit of sustainable and renewable power generation. This paradigm shift necessitates innovative approaches to manag ...

EPFL2024

On the prediction of the induced damage by the start-up sequence of Francis turbines: On operational resilience framework

Mario Paolone, Christophe Nicolet, Elena Vagnoni, Martin Seydoux

The number of transient operations in hydraulic machinery connected to power grid, notably start-ups and shut-downs, has observed a substantial increase in recent decades, primarily driven by the global shift toward intermittent renewable energy sources. S ...

Pergamon-Elsevier Science Ltd2024

Mode I fracture of thick adhesively bonded GFRP composite joints for wind turbine rotor blades

Véronique Michaud, Anastasios Vassilopoulos, Jialiang Fan

This article investigates the effects of voids, joint geometry, and test conditions on the quasi-static Mode I fracture performance of thick adhesive Double Cantilever Beam (DCB) joints such as those prevailing in wind industry and shipbuilding. The specim ...

2024

Wind farm power density optimization according to the area size using a novel self-adaptive genetic algorithm

Fernando Porté Agel, Nicolas Otto Kirchner Bossi

This work studies the power density (PD) optimization in wind farms, and its sensitivity to the available area size. A novel genetic algorithm (PDGA) is introduced, which optimizes PD and the turbine layout, by self-adapting to the PD and to the solutions ...

Pergamon-Elsevier Science Ltd2023

Dynamic stall characterisation and control for vertical-axis wind turbines

Sébastien Le Fouest

According to the International Energy Agency, the global net-zero emissions objective requires the installed wind power capacity to increase 11-fold between 2020 and 2050. The scientific community has recently voiced concerns about the logistic feasibility ...

EPFL2023

Wind Turbine Wakes in Active Yaw Control: Numerical and Theoretical Studies

Mou Lin

In this thesis, we explore the best practice of simulating the wakes of the turbines under active yaw control (AYC) using large-eddy simulation (LES). In the first study, we validate the blade-element actuator disk model (ADM-BE) for a yawed wind turbine. ...

EPFL2023

Cross-code verification of non-neutral ABL and single wind turbine wake modelling in LES

Fernando Porté Agel, Marwa Souaiby

Large Eddy Simulations (LES) of atmospheric boundary layer (ABL) flow with the actuator disc (AD) for turbine modelling is a widely used method of simulating wind farm flows. Hence, it is important to understand the requirements for achieving a good compar ...

IOP PUBLISHING LTD2023

A wind tunnel study on cyclic yaw control: Power performance and wake characteristics

Fernando Porté Agel, Arslan Salim Dar, Guiyue Duan

In this study, wind-tunnel experiments are used to investigate cyclic yaw control as a wake mitigation strategy aiming to improve wind farm power production. The control strategy is applied to a single wind turbine and a wind farm comprising of a column of ...

Elsevier2023

Time scales of dynamic stall development on a vertical-axis wind turbine blade

Daniel Marie Fernex, Karen Ann J Mulleners, Sébastien Le Fouest

Vertical-axis wind turbines are excellent candidates to diversify wind energy technology, but their aerodynamic complexity limits industrial deployment. To improve the efficiency and lifespan of vertical-axis wind turbines, we desire data-driven models and ...

2023

Structural impact of the start-up sequence on Pelton turbines lifetime: Analytical prediction and polynomial optimization

Mario Paolone, Elena Vagnoni, Aldo Leonardo Alerci

Hydropower plants play a crucial role in the power system facing ambitious renewable energy targets. Due to their inherent controllability, they are well suited to provide flexibility to the grid. However, an increased flexibility provision leads to a prol ...

Pergamon-Elsevier Science Ltd2023

Fatigue behavior and life prediction of wind turbine blade composite materials

Anastasios Vassilopoulos

Fatigue life prediction of wind turbine rotor blades is a very challenging task, as their failure is led by different failure types that act synergistically. Inherent defects like wrinkles, fiber misalignments, and voids that can be introduced during fabri ...

Woodhead Publishing (Elsevier)2023

Characterization of wind turbine flow through nacelle-mounted lidars: a review

Fernando Porté Agel, Peter Andreas Brugger

This article provides a comprehensive review of the most recent advances in the planning, execution, and analysis of inflow and wake measurements from nacelle-mounted wind Doppler lidars. Lidars installed on top of wind turbines provide a holistic view of ...

2023

Small-scale turbopumps for waste heat recovery applications based on an organic Rankine cycle: a study from pre-design to experimental validation

Sajjad Zakeralhoseini

The organic Rankine cycle (ORC) system is among the technologies applied to exploit waste heat in vehicles. Since common organic fluids have lower latent heat than water, higher mass flow rates are required to convert the same waste heat, considerably incr ...

EPFL2023