Publications related to Ultra-High Performance Fibre Reinforced Concrete for advanced rehabilitation of Bridges

Related publications (29)

Defining myocardial fiber bundle architecture in atrial digital twins

A key component in developing atrial digital twins (ADT) - virtual representations of patients’ atria — is the accurate prescription of myocardial fibers which are essential for the tissue characterization. Due to the difficulty of reconstructing atrial fi ...

2025

Shear and steel-fibre reinforcement for the punching resistance of flat slabs at internal and edge columns

Diego Hernández Fraile

Reinforced concrete flat slabs consist of a continuous, thin concrete plate that rests on a grid of columns. The supporting surface of the columns is very small compared to the floor plan dimensions, leading to concentrations of shear forces near the colum ...

EPFL2024

Experimental and numerical investigation of an additively manufactured sandwich composite bridge deck utilizing gyroid building blocks

Anastasios Vassilopoulos

This work investigates the integration of Additive Manufacturing (AM) techniques with cellular metamaterials integrated into composite sandwich beam systems. The study proposes an approach that combines composite materials for the face sheets with cellular ...

2024

Highly anisotropic carbon fiber electrodes for DEAs and their dynamic non-monotonic conductive properties

Yves Perriard, Stefania Maria Aliki Konstantinidi

A common method for creating compliant electrodes for dielectric elastomer actuators (DEAs) and soft sensors is to incorporate electrically conductive carbon particles into a polymer matrix. However, using unidirectional aligned carbon fibers instead not o ...

Society of Photo-Optical Instrumentation Engineers (SPIE)2024

Pultruded carbon fibre reinforced polymer strips produced with a novel bio-based thermoset polyester for structural strengthening

Mateus De Assunção Hofmann

This paper presents the development and industrial manufacturing of a pultruded high-performance carbon fibre (CF) reinforced polymer (CFRP) composite strip using a bio-based unsaturated polyester (UP) resin containing more than 50% of its weight derived f ...

ELSEVIER SCI LTD2023

Capillary flow in UHPFRC with synthetic fibers, under high tensile stresses

Emmanuel Denarié, Amir Hajiesmaeili

A novel Ultra High-Performance Fiber Reinforced Concrete (UHPFRC) mix with synthetic fibers and a low clinker matrix, henceforth referred to as PE-UHPFRC, has been developed for structural applications. It exhibits a high tensile elastic limit above 7 MPa, ...

Pergamon-Elsevier Science Ltd2021

Variations on R-curves and traction-separation relations in DCB specimens loaded under end opening forces or pure moments

John Botsis, Georgios Pappas

In this work the differences in R-curve response and traction-separation relations due to a finite damage zone or large-scale bridging (LSB) in mode I fracture on double cantilever beams (DCB) were investigated under end opening forces (EOF) and pure momen ...

PERGAMON-ELSEVIER SCIENCE LTD2020

Load transfer mechanisms in CFRP ground anchors with multi-strap ends

Thomas Keller, Anastasios Vassilopoulos, Haifeng Fan

An investigation of the load-transfer mechanism in carbon fiber-reinforced polymer (CFRP) ground anchors with multi-strap ends was conducted based on experimental and numerical studies of one- and two-strap anchors. Differences in the strap geometry, i.e. ...

Elsevier2018

Electrospun nanofibrous interleaves for improved low velocity impact resistance of glass fibre reinforced composite laminates

Véronique Michaud, Amaël Maximilien Cohades

This study analyses the damage tolerance of nanofibre interleaved composites when subjected to low velocity impact. Cross-ply glass/epoxy composite laminates are produced. Drop-weight impact and residual compressive strength measurements are performed on t ...

2018

Towards aerospace grade thin-ply composites: Effect of ply thickness, fibre, matrix and interlayer toughening on strength and damage tolerance

John Botsis, Joël Cugnoni, Larissa Sorensen, Robin Amacher, Sébastien Kohler

Thin-ply composites represent a promising approach to further improve the performance of carbon fibre composite structures thanks to their ability to delay the onset of matrix cracking and delamination up to the point of fibre dominated failure. However, t ...

ELSEVIER SCI LTD2018

Pull-out behavior of CFRP ground anchors with two-strap ends

Thomas Keller, Anastasios Vassilopoulos, Haifeng Fan

Pull-out experiments were performed on three carbon fiber-reinforced polymer (CFRP) ground anchors simulating their applications in different rock types which provided different confinement levels. The CFRP tendons comprised, on the ground side, a prefabri ...

2017

Bond Behavior of CFRP Sheets Attached to Concrete through EBR and EBROG Joints Subject to Mixed-Mode I/II Loading

Ardalan Hosseini

The bond behavior of carbon fiber–reinforced polymer (CFRP) sheets attached to concrete surface subject to mixed-mode I/II loading through single lap-shear tests is assessed. A 63 concrete prism specimens of 150 × 150 × 330 mm were prepared through externa ...

American Society of Civil Engineers2017

Creep of Sandwich Panels with Longitudinal Reinforcement Ribs for Civil Engineering Applications: Experiments and Composite Creep Modeling

Thomas Keller

Composite sandwich panels with reinforcement ribs or webs are being increasingly considered for structural applications in civil engineering. Such panels are prone to creep when subjected to significant permanent loads and therefore the effects of this phe ...

American Society of Civil Engineers2017

Local structural effects in fiber-reinforced polymer web-core sandwich structures

Sonia Yanes Armas

Glass fiber-reinforced polymer (GFRP) pultruded decks and sandwich panels currently represent two of the most extensive applications of FRP materials for load-bearing structural components in the bridge and building domains. Based on the state of the art, ...

EPFL2017

Efficiency Factors for Plastic Design in Concrete: Influence of Brittleness in Compression, High Tech Concrete: Where Technology and Engineering Meet

Aurelio Muttoni, Miguel Fernández Ruiz, Francesco Rafael Alberto Moccia

A large number of design approaches for structural concrete rely on the applicability of limit analysis. This is for instance the case of bending and shear design in members with transverse reinforcement, where it is assumed that plastic compression fields ...

2017

Stress fields for the interaction of in-plane and out-of-plane forces in reinforced concrete shell elements

Marie-Rose Backes

Plane reinforced concrete (RC) elements are used in a large variety of structures. Their principal function is to carry forces that act in the plane of the element, but external actions and connections to other structural elements generally introduce addit ...

EPFL2017

Aramid/glass fiber-reinforced thermal break - thermal and structural performance

Thomas Keller, Julia De Castro San Roman Fest, Kyriaki Goulouti

Energetically weak points in thermally insulated building envelopes are formed by thermal breaks that are implemented to structurally connect external balconies to internal slabs. Current thermal breaks comprise stainless steel bars that penetrate the insu ...

Elsevier2016

Pull-out behavior of CFRP ground anchors with two-strap ends

Thomas Keller, Anastasios Vassilopoulos, Haifeng Fan

Pull-out experiments were performed on three carbon fiber-reinforced polymer (CFRP) ground anchors simulating their applications in different rock types which provided different confinement levels. The CFRP tendons comprised, on the ground side, a prefabri ...

The Hong Kong Polytechnic University2016

Intralaminar fracture of unidirectional carbon/epoxy composite: experimental results and numerical analysis

John Botsis, Georgios Pappas

Fracture of carbon fiber reinforced polymers (CFRPs) is dominated by large scale fiber bridging which acts as a very important toughening mechanism. The objective of this paper is to investigate the intralaminar Mode I fracture in a unidirectional CFRP com ...

Elsevier2016

FRP sandwich structures in bridge and building construction

Thomas Keller

Selected applications of fiber-reinforced polymer (FRP) sandwich structural elements in building and bridge construction are discussed. It is shown how in building construction this technology enables the integration of functions such as load-bearing capac ...

2016