Numerical modeling and neural networks to identify constitutive parameters from in situ tests

This study proposes a new advanced algorithm for determining material parameters based on in situ tests. In situ testing gives an opportunity to perform soil characterization in natural stress conditions on a representative soil mass. Most field techniques reduce soil disturbances to minimum, allowing investigating the response of virgin soil. Self-boring pressuremeter tests (SBPT) and standard piezocone tests (CPTU) are widely used to deduce properties of clayey soils through analytical and empirical correlations between soil properties and experimental measurements. Empirical correlations usually require some tuning based on reference laboratory data because first-order estimates for typical correlation coefficients may give unreliable evaluation of soil properties. Analytical correlations are mostly based on cavity expansion methods which are restricted to either fully drained or perfectly undrained problems, so that inverse closed-form solutions for relatively simple constitutive models can be derived. In practice, however, depending on physical and consolidation properties of the soil, partially drained conditions may occur during field testing, leading to an erroneous estimation of clay characteristics. Therefore, elaborating a generic parameter identification framework, which is based on the artificial neural network (NN) technique and which may improve the reliability of soil properties derived from in situ testing, is the main goal of this research. This study explores the possibility of using NNs to solve complex inverse problems including partially drained conditions. In other words, NNs are used to map experimental measurements onto set of soil properties. The development of NN-based inverse models is based on a training data sets which consists of pseudo-experimental measurements derived from numerical simulations of both the SBPT and the CPTU test in normally- and lightly overconsolidated clay type material. The study presents a generic two-level procedure designed for the calibration of constitutive models of soils. It is demonstrated that NN inverse models can be easily integrated into the classical back-analysis. At the first level, the NN approach is applied to achieve the first approximation of parameters. This technique is used to avoid potential pitfalls related to the conventional gradient-based optimization (GBO) technique, considered here as a corrector that improves predicted parameters. Trained NNs as parallel operating systems can provide output variables instantly and without a costly GBO iterative scheme. The proposed framework is verified for the elasto-plastic Modified Cam Clay (MCC) model that can be calibrated based on standard triaxial laboratory tests, i.e. the isotropic consolidation test and the consolidated isotropic drained compression test. The study presents formulations of the input data for the NN predictors, enhanced by a dimensional reduction of experimental data using principal component analysis (PCA