Experimental Investigation of Pressure Fluctuations in a High-Energy Centrifugal Pump Stage at Off-Design Conditions

About
Privacy
Disclaimer

Graph Chatbot

Related publications (32)

Page 2 of 2

Ultra-Compact Microscale Heat Exchanger for Advanced Thermal Management in Data Centers

John Richard Thome, Filippo Cataldo

This study is focused on the experimental characterization of two-phase heat transfer performance and pressure drops within an ultracompact heat exchanger (UCHE) suitable for electronics cooling applications. In this specific work, the UCHE prototype is an ...

ASME2022

The Role of Reynolds Number Effect and Tip Leakage in Compressor Geometry Scaling at Low Turbulent Reynolds Numbers

Christoph Schreiber, Jürg Alexander Schiffmann, Markus Diehl

In compressor design, a convenient way to save time is to scale an existing geometry to required specifications, rather than developing a new design. The approach works well when scaling compressors of similar size at high Reynolds numbers but becomes more ...

2020

A point vortex transportation model for yawed wind turbine wakes

Fernando Porté Agel, Haohua Zong

In this study, stereo particle imaging velocimetry measurements are performed at multiple streamwise locations behind a yawed wind turbine to reveal the formation mechanisms of the counter-rotating vortex pair (CVP), and a point vortex transportation (PVT) ...

Cambridge University Press2020

An experimental study on the upper part-load elliptical vortex instability in a Francis turbine

François Avellan, Elena Vagnoni, Andres Müller, Arthur Tristan Favrel, Ali Amini

This paper presents preliminary results of an experimental study on the occurrence and development of the upper part-load instability in a reduced-scale Francis turbine. The study includes draft tube pressure measurements, high-speed flow visualization, an ...

IOP Publishing2021

Theoretical and Experimental Investigation of a Small-scale, High-speed, and Oil-free Radial Anode Off-gas Recirculation Fan for Solid Oxide Fuel Cell Systems

Jan Van Herle, Jürg Alexander Schiffmann, Patrick Hubert Wagner

The Laboratory for Applied Mechanical Design (LAMD) designed, manufactured, and experimentally tested a novel recirculation fan for a 10 kWe solid oxide fuel cell (SOFC). The fan uses oil-free bearings, more specifically herringbone-grooved journal and spi ...

2020

The effects of the tip clearance on the performance of small-scale turbopumps for ORC applications; analysis and modeling

Jürg Alexander Schiffmann, Sajjad Zakeralhoseini

In this paper, the influence of tip clearance on the performance of small-scale turbopumps is studied numerically on extensive parameter ranges suitable for organic Rankine cycle applications. A novel and fully parameterized design model is developed and u ...

Technical University of Munich2021

Unsteady Flow Numerical Simulations on Internal Energy Dissipation for a Low-Head Centrifugal Pump at Part-Load Operating Conditions

François Avellan, Xiaoran Zhao

Dredge pumps are usually operated at part-load conditions, in which the low-solidity centrifugal impeller could experience large internal energy dissipation, related to flow separation and vortices. In this study, SST k- and SAS-SST turbulence models were ...

2019

Experimental assessment of an active (acoustic) liner prototype in an acoustic flow duct facility

Hervé Lissek, Maxime Volery

In this paper, experimental results of broadband noise reduction in an acoustic flow duct are presented. An active liner composed of an array of electroacoustic absorbers is used. The control law is based on the pressure-based, current driven digital archi ...

SPIE2021

Oxygen diffusion through air–water free surfaces in a pump–turbine operating in condenser mode

François Avellan, Elena Vagnoni, Loïc Andolfatto

The present research aims at understanding the mass transfer of air into water in a reversible pump turbine operating in condenser mode. In particular, the diffusion of oxygen through the water free-surface both in the vaneless gap between the impeller bla ...

2019

Investigation of the Time Resolution Set Up Used to Compute the Full Load Vortex Rope in a Francis Turbine

François Avellan, Arthur Tristan Favrel, Cécile Münch-Alligné, Andres Müller

The flow in a Francis turbine at full load is characterised by the development of an axial vortex rope in the draft tube. The vortex rope often promotes cavitation if the turbine is operated at a sufficiently low Thoma number. Furthermore, the vortex rope ...

2021

Coherent Structure Interaction During Unsteady Separation

Karen Ann J Mulleners

Unsteady flow separation in rotationally augmented flow fields plays a significant role in the aerodynamic performance of industrial rotors, including wind turbines. Current computational models underestimate the aerodynamic loads due to the inaccurate pre ...

2019

Large-Eddy Simulation of Wind Turbine Flows: A New Evaluation of Actuator Disk Models

Fernando Porté Agel, Tristan Revaz

Large-eddy simulation (LES) with actuator models has become the state-of-the-art numerical tool to study the complex interaction between the atmospheric boundary layer (ABL) and wind turbines. In this paper, a new evaluation of actuator disk models (ADMs) ...

2021