Publications related to Experimental DSC-based method to determine glass transition temperature during curing of structural adhesives

Related publications (31)

Absolute Temperature Sensing in the 67-350 K Range Using Brillouin Scattering in Gases

This paper proposes a novel temperature sensing method using stimulated Brillouin scattering in a hollow-core fiber filled with gas. Compared to classical Brillouin sensors, the Brillouin response of gases shows a higher sensitivity at cryogenic temperatur ...

SPIE2025

Decomposition method to evaluate district heating/cooling network potential at urban scale

Ana Catarina Gouveia Braz, François Maréchal, Luc Girardin, Bingqian Liu

In this work, a tool to design district heating networks (DHN) is presented and applied to the city of Lausanne as a case study. The evaluation of the buildings’ heat/cooling demand is performed using a Geographic Information System (GIS) database, built f ...

Associazione Italiana Di Ingegneria Chimica2024

Flash Melting Amorphous Ice

Marcel Drabbels, Ulrich Lorenz, Gabriele Bongiovanni, Constantin Richard Krüger, Nathan Junior Mowry

Water can be vitrified if it is cooled at high rates, which makes it possible to outrun crystallization in so-called no man’s land, a range of deeply supercooled temperatures where water crystallizes rapidly. Here, we study the reverse process in pure wate ...

2024

Shaped Laser Pulses for Microsecond Time-Resolved Cryo-EM: Outrunning Crystallization during Flash Melting

Marcel Drabbels, Ulrich Lorenz, Constantin Richard Krüger, Nathan Junior Mowry

Water vitrifies if cooled at rates above 3 × 105 K/s. In contrast, when the resulting amorphous ice is flash heated, crystallization occurs even at a more than 10 times higher heating rate, as we have recently shown. This may present an issue for microseco ...

2024

Design and assessment of an evaporating water-cooled methanation reactor for a SOE-based power-to-methane system

Philippe Aubin

The transition towards clean renewable energy sources, where wind and solar are prone to variation, requires adequate energy storage. Power-to-methane (PtM) systems can be part of the solution. Specifically, solid-oxide-electrolyser (SOE) based PtM systems ...

EPFL2024

Enabling simultaneous reprocessability and fire protection via incorporation of phosphine oxide monomer in epoxy vitrimer

Véronique Michaud, Valentin Rougier

The conception of epoxy thermosets with both reprocessability and flame retardancy delineates a new horizon in polymer science, offering a material solution that is not only superior in fire safety but is also environment friendly. Herein, a flame-retardan ...

Journal Mater Sci Technol2024

Self-catalysed frontal polymerisation enables fast and low-energy processing of fibre reinforced polymer composites

Véronique Michaud, Baris Çaglar, Jacobus Gerardus Rudolph Staal

Frontal polymerisation has the potential to bring unprecedented reductions in energy demand and process time to produce fibre reinforced polymer composites. Production of epoxy-based fibre reinforced polymer parts with high fibre volume content, commonly e ...

2024

Experiments and gyrokinetic simulations of TCV plasmas with negative triangularity in view of DTT operations

Olivier Sauter, Stefano Coda, Alberto Mariani, Justin Richard Ball, Matteo Vallar, Filippo Bagnato

Negative triangularity (NT) scenarios in TCV have been compared to positive triangularity (PT) scenarios using the same plasma shapes foreseen for divertor tokamak test tokamak operations. The experiments provided a NT/PT L-mode pair and a PT H-mode with d ...

Iop Publishing Ltd2024

Unearthing the foundational role of anharmonicity in heat transport in glasses

Paolo Pegolo

The time-honored Allen -Feldman theory of heat transport in glasses is generally assumed to predict a finite value for the thermal conductivity, even if it neglects the anharmonic broadening of vibrational normal modes. We demonstrate that the harmonic app ...

Amer Physical Soc2024

High-order geometric integrators for the variational Gaussian wavepacket dynamics and application to vibronic spectra at finite temperature

Roya Moghaddasi Fereidani

Molecular quantum dynamics simulations are essential for understanding many fundamental phenomena in physics and chemistry. They often require solving the time-dependent Schrödinger equation for molecular nuclei, which is challenging even for medium-sized ...

EPFL2024

Near-Room-Temperature Detection of Aromatic Compounds with Inkjet-Printed Plasticized Polymer Composites

Jürgen Brugger, Thomas Maeder, Mohammadmahdi Kiaee

Chemiresistive gas sensors composed of a thermoplastic polymer matrix and conductive fillers offer various advantages for detecting volatile organic compounds (VOCs), including low power consumption due to near-room-temperature operation, high sensitivity, ...

Amer Chemical Soc2024

Computational fluid dynamics simulations of the heat transfer properties of graphene-based nanolubricants and application to hydrodynamic lubrication

Roberto Guarino

In this paper, we consider experimental data available for graphene-based nanolubricants to evaluate their convective heat transfer performance by means of computational fluid dynamics (CFD) simulations. Single-phase models with temperature-dependent prope ...

Aip Publishing2024

Performance of energy piles foundation in hot-dominated climate: A case study in Dubai

Lyesse Laloui, Elena Ravera, Sofie Elaine ten Bosch

Energy piles represent an innovative technology that can help provide sustainable geothermal heating or cooling energy for thermal conditioning purposes. In hot-dominated climates, the interest is to inject heat in the ground and extract energy for space-c ...

Pergamon-Elsevier Science Ltd2024

Thermal conductivity of Li 3 PS 4 solid electrolytes with ab initio accuracy

Michele Ceriotti, Federico Grasselli, Davide Tisi, Lorenzo Gigli

The vast amount of computational studies on electrical conduction in solid-state electrolytes is not mirrored by comparable efforts addressing thermal conduction, which has been scarcely investigated despite its relevance to thermal management and (over)he ...

Amer Physical Soc2024

Plasmoid drift and first wall heat deposition during ITER H-mode dual-SPIs in JOREK simulations

Mengdi Kong

The heat flux mitigation during the thermal quench (TQ) by the shattered pellet injection (SPI) is one of the major elements of disruption mitigation strategy for ITER. It's efficiency greatly depends on the SPI and the target plasma parameters, and is ult ...

IOP Publishing Ltd2024

Local vs. cooperative: Unraveling glass transition mechanisms with SEER

Matthieu Wyart, Wencheng Ji

Which phenomenon slows down the dynamics in supercooled liquids and turns them into glasses is a long-standing question of condensed matter. Most popular theories posit that as the temperature decreases, many events must occur in a coordinated fashion on a ...

National Academy of Sciences2024

Models implemented in the methodological approach to design the initial STEP first wall contour

Kevin Henricus Annemarie Verhaegh, Davide Galassi, Filippo Bagnato, Dario Vaccaro

The official Spherical Tokamak for Energy Production mission aims to demonstrate the ability to generate net electricity from fusion with the STEP Prototype Power plant. One of the key technological and engineering challenges in fusion power plants is mana ...

Elsevier Science Sa2024

Frustrated magnets in the limit of infinite dimensions: Dynamics and disorder-free glass transition

Achille Mauri

We study the statistical mechanics and the equilibrium dynamics of a system of classical Heisenberg spins with frustrated interactions on a d -dimensional simple hypercubic lattice, in the limit of infinite dimensionality d -> infinity . In the analysis we ...

Amer Physical Soc2024

Multi-machine benchmark of the self-consistent 1D scrape-off layer model DIV1D from stagnation point to target with SOLPS-ITER

Holger Reimerdes

This paper extends a 1D dynamic physics-based model of the scrape-off layer (SOL) plasma, DIV1D, to include the core SOL and possibly a second target. The extended model is benchmarked on 1D mapped SOLPS-ITER simulations to find input settings for DIV1D th ...

Iop Publishing Ltd2024

Hydration and phase assemblage of limestone calcined clay cements (LC3) with clinker content below 50 %

Jinfeng Sun, Karen Scrivener, Franco Alberto Zunino Sommariva

Limestone calcined clay cement (LC3) is a promising material for producing cement with low CO2 emissions and properties similar to, or superior to, those of Portland cement (PC), but at 50 % clinker content (LC3-50). In many applications, lower strengths t ...

Pergamon-Elsevier Science Ltd2024