Publications by Ke Huang | EPFL Graph Search

Related publications (24)

Effect of recrystallization on hot deformation mechanism of TA15 titanium alloy under uniaxial tension and biaxial gas bulging conditions

To investigate the effect of recrystallization on hot deformation mechanism of TA15 titanium alloy, rolled sheet and laser-welded tubes before and after recrystallization annealing were tested by uniaxial tensile tests and biaxial gas bulging respectively. ...

Elsevier2017

Factors affecting the strength of P{011}〈566〉-texture after annealing of a cold-rolled Al–Mn–Fe–Si alloy

Ke Huang

Elongated coarse P{011}-oriented grains are frequently observed after annealing of cold-rolled Al–Mn alloys with a highly supersaturated solid solution level. In this study, important factors affecting the strength of the P-texture component after ann ...

Springer2015

The double-edge effect of second-phase particles on the recrystallization behaviour and associated mechanical properties of metallic materials

Roland Logé, Ke Huang

Most industrial alloys contain a matrix phase and dispersed second-phase particles. Several thermomechanical processing (TMP) steps are usually needed to produce a final product, during which recrystallization and its related phenomena may take place. Seco ...

Elsevier2018

Study on the mixed dynamic recrystallization mechanism during the globularization process of laser-welded TA15 Ti-alloy joint under hot tensile deformation

Ke Huang

In this article, the hot deformation mechanism of a laser-welded near a TA15 Ti-alloy joint was studied by hot tensile tests conducted at temperatures ranging from 800 degrees C to 900 degrees C with strain rates ranging from 1.0 x 10(-1) s(-1) to 1.0 x 10 ...

Elsevier2017

The effect of heating rate on the softening behaviour of a deformed Al–Mn alloy with strong and weak concurrent precipitation

Ke Huang

The interaction between recrystallization and concurrent precipitation is strongly dependent on the heating rate during annealing. In this study, the effects of heating rate on the grain structure, recrystallization texture and resulting mechanical propert ...

Elsevier Science Inc2015

The flow stress evolution and grain refinement mechanisms during hot deformation of Al-Mg alloy

Roland Logé, Ke Huang

In this study, the hot deformation behavior of an Al-1% Mg alloy with very coarse initial grain size was investigated in terms of flow stress evolution and grain refinement mechanism. The large grain size was employed to study the traditional continuous dy ...

2017

Simultaneous strength and ductility enhancement of wire-arc directed energy deposited Al-Cu alloy by interlayer laser shock peening

Ke Huang, Yandong Jing

Wire-arc directed energy deposition (wire-arc DED), recognized for its ability to produce large-scale parts, has gained considerable attention. However, a critical issue with this method is the high prevalence of internal porosity defects found in the manu ...

Elsevier Science Sa2023

On the sluggish recrystallization of a cold-rolled Al–Mn–Fe–Si alloy

Roland Logé, Ke Huang

Annealing of supersaturated AA3xxx alloys at low temperatures usually results in sluggish recrystallization kinetics. This is due to the joint effect of the following factors: low nucleation rate, reduced grain boundary mobility, and large amount of fine p ...

Springer Verlag2016

A critical assessment of experimental investigation of dynamic recrystallization of metallic materials

Roland Logé, Ke Huang

Dynamic recrystallization (DRX) often takes place during hot deformation of metallic materials, which then exerts significant influence on the final microstructures and mechanical properties of the formed components. A considerable number of published pape ...

2020

Effect of heterogeneously distributed pre-existing dispersoids on the recrystallization behavior of a cold-rolled Al–Mn–Fe–Si alloy

Ke Huang

It is well known that strong concurrent precipitation, mainly located along grain/subgrain boundaries, results in a coarse and elongated grain structure, and unusual sharp P {011} and/or M {113} texture components during annealing of supersatur ...

Elsevier2015

Laser shock peening: A promising tool for tailoring metallic microstructures in selective laser melting

Manuel Ortega Varela De Seijas, Roland Logé, Ke Huang, Nikola Kalentics

Metallic parts made by Selective Laser Melting (SLM) are known for their heterogeneous microstructures in the as-built (AB) state. In this paper, Laser Shock Peening (ISP) was performed on a 316 L stainless steel part fabricated by SLM. The LSP treatment i ...

2019

Azimuthal asymmetries of back-to-back pi(+/-) - (pi(0), eta, pi(+/-)) pairs in e(+) e(-) annihilation

Olivier Schneider, Sun Hee Kim, Mingkui Wang, Chao Wang, Ke Huang, Ho Ling Li, Yiming Li

This work reports the first observation of azimuthal asymmetries around the thrust axis in e(+)e(-) annihilation of pairs of back-to-back charged pions in one hemisphere, and pi(0) and eta mesons in the opposite hemisphere. These results are complemented b ...

American Physical Society2019

Microstructure and flow stress evolution during hot deformation of 304L austenitic stainless steel in variable thermomechanical conditions

Roland Logé, Ke Huang

Most of industrial hot deformation processes are performed in variable conditions where the strain rate and/or deformation temperature are not constant. In this work, hot compression tests in both constant and varying strain rate conditions were performed ...

Elsevier2018

Observation of tau(-) -> pi(-)nu(tau)e(+)e(-) and search for tau(-) -> pi(-)nu(tau)mu(+)mu(-)

Olivier Schneider, Sun Hee Kim, Mingkui Wang, Chao Wang, Ke Huang, Yiming Li

We present the first measurements of branching fractions of rare tau-lepton decays, tau(-) -> pi(-)nu(tau)l(+)l(-) (l = e or mu), using a data sample corresponding to 562 fb(-1) collected at a center-of-mass energy of 10.58 GeV with the Belle detector at t ...

American Physical Society2019

Controlling grain structure and texture in Al-Mn from the competition between precipitation and recrystallization

Roland Logé, Ke Huang

The recrystallization behaviour of Al-Mn alloys (AA3xxx series alloys) is affected by randomly distributed dispersoids present before annealing, by dispersoids precipitated at grain/subgrain boundaries before the onset of recrystallization, and by disperso ...

Elsevier2017

Update of inclusive cross sections of single and pairs of identified light charged hadrons

Olivier Schneider, Sun Hee Kim, Mingkui Wang, Chao Wang, Ke Huang, Yiming Li

We report new measurements of the production cross sections of pairs of charged pions and kaons as a function of their fractional energies using various fractional-energy definitions. Two different fractional-energy definitions were used and compared to th ...

American Physical Society2020

Search for Omega(2012) -> K Xi(1530) -> K pi Xi at Belle

Olivier Schneider, Sun Hee Kim, Mingkui Wang, Chao Wang, Ke Huang, Yiming Li

Using data samples of e(+)e(-) collisions collected at the Upsilon(1S), Upsilon(2S), and Upsilon(3S) resonances with the Belle detector, we search for the three-body decay of the Omega(2012) baryon to K pi Xi. This decay is predicted to dominate for models ...

American Physical Society2019

The Influence of Processing Conditions on Microchemistry and the Softening Behavior of Cold Rolled Al-Mn-Fe-Si Alloys

Ke Huang

Using different homogenization treatments, different initial microchemistry conditions in terms of solid solution levels of Mn, and number densities and sizes of constituents and dispersoids were achieved in an Al-Mn-Fe-Si model alloy. For each homogenized ...

2016

Orientation Preference of Recrystallization in Supersaturated Aluminum Alloys Influenced by Concurrent Precipitation

Ke Huang

The influence of concurrent precipitation on recrystallization is analyzed by comparing the nucleation and growth behavior of P ({011} 〈566〉), Cube ({001} 〈100〉), and 20 deg ND-rotated Cube ({001} 〈310〉, NDcube)-oriented grains in Al-xMn-Fe-Si (x = 0, 0.4, ...

Springer Verlag2016

Search for a Light CP-odd Higgs Boson and Low-Mass Dark Matter at the Belle Experiment

Roberto Gargiani, Olivier Schneider, Sun Hee Kim, Chao Wang, Hiroyasu Yamamoto, Wondwossen Wubie Eshetu, Yong Chan Choi, Seyed Sina Mirrazavi Salehian, Arnaud Michel Gelb, Ke Huang, Gaétan Charles Antoine Giriat, Jun Yong Kim, Johannes Julius Thomas Marinus Swartjes, Mithilesh Nayak, Linlin Cao, Jiayun Shen, Tara Nanut, Martin Lubej, Chang-Hyun Park, Yiming Li

We report on the first Belle search for a light CP-odd Higgs boson, A(0), that decays into low mass dark matter, chi, in final states with a single photon and missing energy. We search for events produced via the dipion transition (sic)(2S) -> (sic)(1S)pi( ...

2019