Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Lecture

Differential Amplifiers & Darlington Configuration: Principles and Analysis

Description

This lecture covers the principles and analysis of differential amplifiers, including the characteristics of large signals and the unilateral exit. It also delves into the Montage Darlington and pseudo-Darlington configurations.

In MOOC

Electronics II

Official source

Related concepts (32)

Operational amplifier

An operational amplifier (often op amp or opamp) is a DC-coupled high-gain electronic voltage amplifier with a differential input and, usually, a single-ended output. In this configuration, an op amp produces an output potential (relative to circuit ground) that is typically 100,000 times larger than the potential difference between its input terminals. The operational amplifier traces its origin and name to analog computers, where they were used to perform mathematical operations in linear, non-linear, and frequency-dependent circuits.

Differential amplifier

A differential amplifier is a type of electronic amplifier that amplifies the difference between two input voltages but suppresses any voltage common to the two inputs. It is an analog circuit with two inputs and and one output , in which the output is ideally proportional to the difference between the two voltages: where is the gain of the amplifier. Single amplifiers are usually implemented by either adding the appropriate feedback resistors to a standard op-amp, or with a dedicated integrated circuit containing internal feedback resistors.

Amplifier

An amplifier, electronic amplifier or (informally) amp is an electronic device that can increase the magnitude of a signal (a time-varying voltage or current). It is a two-port electronic circuit that uses electric power from a power supply to increase the amplitude (magnitude of the voltage or current) of a signal applied to its input terminals, producing a proportionally greater amplitude signal at its output. The amount of amplification provided by an amplifier is measured by its gain: the ratio of output voltage, current, or power to input.

Differential signalling

Differential signalling is a method for electrically transmitting information using two complementary signals. The technique sends the same electrical signal as a differential pair of signals, each in its own conductor. The pair of conductors can be wires in a twisted-pair or ribbon cable or traces on a printed circuit board. Electrically, the two conductors carry voltage signals which are equal in magnitude, but of opposite polarity. The receiving circuit responds to the difference between the two signals, which results in a signal with a magnitude twice as large.

Instrumentation amplifier

An instrumentation amplifier (sometimes shorthanded as in-amp or InAmp) is a type of differential amplifier that has been outfitted with input buffer amplifiers, which eliminate the need for input impedance matching and thus make the amplifier particularly suitable for use in measurement and test equipment. Additional characteristics include very low DC offset, low drift, low noise, very high open-loop gain, very high common-mode rejection ratio, and very high input impedances.

Related lectures (32)

Cascode and Follower Amplifiers: Transistor Basics MOOC: Electronics II

Covers the principles of cascode amplifiers, push-pull amplifiers, and amplifier design.

Differential Amplifier for Noise Reduction

Covers the design and operation of a differential amplifier for noise reduction in biomedical instrumentation.

Imperfections of Operational Amplifiers: Imperfections MOOC: Electronics I

Explores the imperfections of operational amplifiers and their impact on performance.

Applications of Operational Amplifiers: Linear Applications MOOC: Electronics I

Explores the applications of operational amplifiers in linear circuits, emphasizing the benefits of using variants with high CMRR.

Operational Amplifier: Negative Feedback MOOC: Electronics I