Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Lecture

Analysis of an RLC circuit: Damped Oscillator with Forced Excitation

In course

PHYS-201(d): General physics: electromagnetism

The topics covered by the course are concepts of electromagnetism, properties of waves, and fluid mechanics. ...

Description

This lecture covers the analysis of RLC circuits with AC emf, focusing on damped oscillators with forced excitation and resonant behavior. Students will learn to calculate current, voltages, and phase shifts in RLC circuits, as well as impedance analysis and frequency-dependent current amplitudes. The rotating vector diagram at resonance and examples with absolute values are also discussed, emphasizing the application of Ohm's law. The lecture concludes with a summary of the key concepts, highlighting the importance of understanding impedance variations with frequency and the resonant behavior of current amplitudes.

This video is available exclusively on Mediaspace for a restricted audience. Please log in to MediaSpace to access it if you have the necessary permissions.

Watch on Mediaspace

Instructor

Dirk Grundler

Official source

Ontological neighbourhood

Physics

Electromagnetism: Electrical networks

Related concepts (32)

Electrical impedance

In electrical engineering, impedance is the opposition to alternating current presented by the combined effect of resistance and reactance in a circuit. Quantitatively, the impedance of a two-terminal circuit element is the ratio of the complex representation of the sinusoidal voltage between its terminals, to the complex representation of the current flowing through it. In general, it depends upon the frequency of the sinusoidal voltage.

Resonance

Resonance describes the phenomenon of increased amplitude that occurs when the frequency of an applied periodic force (or a Fourier component of it) is equal or close to a natural frequency of the system on which it acts. When an oscillating force is applied at a resonant frequency of a dynamic system, the system will oscillate at a higher amplitude than when the same force is applied at other, non-resonant frequencies. Frequencies at which the response amplitude is a relative maximum are also known as resonant frequencies or resonance frequencies of the system.

RLC circuit

An RLC circuit is an electrical circuit consisting of a resistor (R), an inductor (L), and a capacitor (C), connected in series or in parallel. The name of the circuit is derived from the letters that are used to denote the constituent components of this circuit, where the sequence of the components may vary from RLC. The circuit forms a harmonic oscillator for current, and resonates in a manner similar to an LC circuit. Introducing the resistor increases the decay of these oscillations, which is also known as damping.

LC circuit

File:LC parallel simple.svg|LC circuit diagram File:Low cost DCF77 receiver.jpg|LC circuit ''(left)'' consisting of ferrite coil and capacitor used as a tuned circuit in the receiver for a [[radio clock]] File:Tuned circuit of shortwave radio transmitter from 1938.jpg|Output tuned circuit of [[shortwave]] [[radio transmitter]] An LC circuit, also called a resonant circuit, tank circuit, or tuned circuit, is an electric circuit consisting of an inductor, represented by the letter L, and a capacitor, represented by the letter C, connected together.

Impedance matching

In electronics, impedance matching is the practice of designing or adjusting the input impedance or output impedance of an electrical device for a desired value. Often, the desired value is selected to maximize power transfer or minimize signal reflection. For example, impedance matching typically is used to improve power transfer from a radio transmitter via the interconnecting transmission line to the antenna. Signals on a transmission line will be transmitted without reflections if the transmission line is terminated with a matching impedance.

Related lectures (34)

Circuit RLC Analysis

Explores RLC circuit analysis, impedance calculation, damping, and mechanical analogies.

Electroacoustics: Electrical Systems

Covers fundamental concepts of electrical systems, including components, circuits, complex notations, quadrupoles, impedance, RLC circuits, and transformers.

Sinusoidal Circuits: Examples and Impedances MOOC: Electrical engineering I

Covers examples in electrical engineering, impedance properties, and circuit components like resistance and reactance.

Resonant Circuits: Frequency Behavior and Equivalent Dipoles MOOC: Electrical engineering I

Explores the frequency behavior of resonant circuits and equivalent dipoles.

Circuits: LC Oscillator and Filters