Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Lecture

Mask Fabrication Process

Description

This lecture demonstrates the practical steps involved in mask fabrication for UV lithography, starting from loading the mask blank into the laser writer, writing the pattern, developing the resist, etching the chrome, and stripping the unexposed resist, all leading to the final mask ready for UV photolithography.

Official source

Related concepts (11)

Photolithography

In integrated circuit manufacturing, photolithography or optical lithography is a general term used for techniques that use light to produce minutely patterned thin films of suitable materials over a substrate, such as a silicon wafer, to protect selected areas of it during subsequent etching, deposition, or implantation operations. Typically, ultraviolet light is used to transfer a geometric design from an optical mask to a light-sensitive chemical (photoresist) coated on the substrate.

Photoresist

A photoresist (also known simply as a resist) is a light-sensitive material used in several processes, such as photolithography and photoengraving, to form a patterned coating on a surface. This process is crucial in the electronics industry. The process begins by coating a substrate with a light-sensitive organic material. A patterned mask is then applied to the surface to block light, so that only unmasked regions of the material will be exposed to light. A solvent, called a developer, is then applied to the surface.

Chrome plating

Chrome plating (less commonly chromium plating) is a technique of electroplating a thin layer of chromium onto a metal object. A chrome plated part is called chrome, or is said to have been chromed. The chromium layer can be decorative, provide corrosion resistance, facilitate cleaning, or increase surface hardness. Sometimes, a less expensive substitute for chrome such as nickel may be used for aesthetic purposes. Chromium compounds used in electroplating are toxic. In most countries, their disposal is tightly regulated.

Photomask

A photomask is an opaque plate with transparent areas that allow light to shine through in a defined pattern. Photomasks are commonly used in photolithography for the production of integrated circuits (ICs or "chips") to produce a pattern on a thin wafer of material (usually silicon). Several masks are used in turn, each one reproducing a layer of the completed design, and together known as a mask set. For IC production in the 1960s and early 1970s, an opaque rubylith film laminated onto a transparent mylar sheet was used.

Extreme ultraviolet lithography

Extreme ultraviolet lithography (also known as EUV or EUVL) is an optical lithography technology used in semiconductor device fabrication to make integrated circuits (ICs). It uses extreme ultraviolet (EUV) wavelengths near 13.5 nm, using a laser-pulsed tin (Sn) droplet plasma (Sn ions in the ionic states from Sn IX to Sn XIV give photon emission spectral peaks around 13.5 nm from 4p64dn - 4p54dn+1 + 4dn-14f ionic state transitions.), to produce a pattern by using a reflective photomask to expose a substrate covered by photoresist.

Related lectures (32)

Lithography: Microfabrication Technologies

Explores lithography in microfabrication technologies, covering thin film deposition, print resolution, process flow, and limitations imposed by diffraction.

Lithography: General Concepts and Mask Fabrication MOOC: Micro and Nanofabrication (MEMS)

Covers lithography concepts, mask fabrication, UV lithography, and emerging techniques.

Clip Mask Fabrication MOOC: Micro and Nanofabrication (MEMS)

Showcases the practical steps of fabricating a mask for UV lithography.

Microfabrication Technologies

Explores microfabrication technologies, lithography, MEMS, cleanroom processes, resolution enhancement, phase shift masks, and chip manufacturing complexity.

Lithography: Tools and Techniques MOOC: Micro and Nanofabrication (MEMS)