Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Lecture

Permanent Memories: EEPROM and Flash

Description

This lecture covers the types of memories found in microcontrollers, focusing on EEPROM and Flash memories. It explains how to program EEPROM, access and manage Flash memory, and the limitations of write cycles. Additionally, it discusses the possibility of adding external non-volatile memories like RAM, serial EEPROM, and SD cards, as well as the complexities of managing data on SD cards and the benefits of using a file system like FAT 32.

Official source

Related concepts (32)

Flash memory

Flash memory is an electronic non-volatile computer memory storage medium that can be electrically erased and reprogrammed. The two main types of flash memory, NOR flash and NAND flash, are named for the NOR and NAND logic gates. Both use the same cell design, consisting of floating gate MOSFETs. They differ at the circuit level depending on whether the state of the bit line or word lines is pulled high or low: in NAND flash, the relationship between the bit line and the word lines resembles a NAND gate; in NOR flash, it resembles a NOR gate.

EEPROM

EEPROM (also called E2PROM) stands for electrically erasable programmable read-only memory and is a type of non-volatile memory used in computers, usually integrated in microcontrollers such as smart cards and remote keyless systems, or as a separate chip device to store relatively small amounts of data by allowing individual bytes to be erased and reprogrammed. EEPROMs are organized as arrays of floating-gate transistors. EEPROMs can be programmed and erased in-circuit, by applying special programming signals.

Memory card

A memory card is an electronic data storage device used for storing digital information, typically using flash memory. These are commonly used in digital portable electronic devices. They allow adding memory to such devices using a card in a socket instead of a protruding USB flash drives. The basis for memory card technology is flash memory. It was invented by Fujio Masuoka at Toshiba in 1980 and commercialized by Toshiba in 1987.

Computer memory

Computer memory stores information, such as data and programs for immediate use in the computer. The term memory is often synonymous with the term primary storage or main memory. An archaic synonym for memory is store. Computer memory operates at a high speed compared to storage which is slower but less expensive and higher in capacity. Besides storing opened programs, computer memory serves as disk cache and write buffer to improve both reading and writing performance.

Flash file system

A flash file system is a designed for storing on flash memory–based storage devices. While flash file systems are closely related to file systems in general, they are optimized for the nature and characteristics of flash memory (such as to avoid write amplification), and for use in particular operating systems. While a block device layer can emulate a disk drive so that a general-purpose file system can be used on a flash-based storage device, this is suboptimal for several reasons: Erasing blocks: flash memory blocks have to be explicitly erased before they can be written to.

Related lectures (31)

Memory Hierarchies: Introduction and Technological Constraints

Introduces memory storage technologies, hierarchies, and their impact on performance.

Direct Memory Access (DMA)

Explores Direct Memory Access (DMA) in microcontrollers, emphasizing efficient data transfer and clock signal generation for LED displays.

LED Displays: Microcontroller

Explores LED displays, microcontrollers, system architecture, programming, and examples like the MSP430G2553.

Untitled

Memory Cache Principles