Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Lecture

Neural Amplifiers: Design and Analysis

Description

This lecture covers the design and analysis of neural amplifiers, focusing on common source CMOS amplifiers, small-signal models, DC voltages, source followers, and OTA architectures. It also delves into noise basics, input-referred noise, and noise efficiency factors.

Official source

Ontological neighbourhood

Physics

Electromagnetism: Electrical networks

Related concepts (32)

Current source

A current source is an electronic circuit that delivers or absorbs an electric current which is independent of the voltage across it. A current source is the dual of a voltage source. The term current sink is sometimes used for sources fed from a negative voltage supply. Figure 1 shows the schematic symbol for an ideal current source driving a resistive load. There are two types. An independent current source (or sink) delivers a constant current. A dependent current source delivers a current which is proportional to some other voltage or current in the circuit.

Amplifier

An amplifier, electronic amplifier or (informally) amp is an electronic device that can increase the magnitude of a signal (a time-varying voltage or current). It is a two-port electronic circuit that uses electric power from a power supply to increase the amplitude (magnitude of the voltage or current) of a signal applied to its input terminals, producing a proportionally greater amplitude signal at its output. The amount of amplification provided by an amplifier is measured by its gain: the ratio of output voltage, current, or power to input.

Signal-to-noise ratio

Signal-to-noise ratio (SNR or S/N) is a measure used in science and engineering that compares the level of a desired signal to the level of background noise. SNR is defined as the ratio of signal power to noise power, often expressed in decibels. A ratio higher than 1:1 (greater than 0 dB) indicates more signal than noise. SNR is an important parameter that affects the performance and quality of systems that process or transmit signals, such as communication systems, audio systems, radar systems, imaging systems, and data acquisition systems.

Noise figure

Noise figure (NF) and noise factor (F) are figures of merit that indicate degradation of the signal-to-noise ratio (SNR) that is caused by components in a signal chain. These figures of merit are used to evaluate the performance of an amplifier or a radio receiver, with lower values indicating better performance. The noise factor is defined as the ratio of the output noise power of a device to the portion thereof attributable to thermal noise in the input termination at standard noise temperature T0 (usually 290 K).

Preamplifier

A preamplifier, also known as a preamp, is an electronic amplifier that converts a weak electrical signal into an output signal strong enough to be noise-tolerant and strong enough for further processing, or for sending to a power amplifier and a loudspeaker. Without this, the final signal would be noisy or distorted. They are typically used to amplify signals from analog sensors such as microphones and pickups. Because of this, the preamplifier is often placed close to the sensor to reduce the effects of noise and interference.

Related lectures (52)

Understanding Noise in Electrical Systems

Explores noise sources, Fluctuation-Dissipation Theorem, amplifier noise, interference effects, and quantization error in electrical systems.

Noise Reduction Techniques

Explores noise reduction techniques in electrical systems, covering concepts like Fourier transform, impedance matching, and dithering.

Electronics: Transistors

Explores the basics of transistors, resistors, and their applications in microcontrollers.

Noise in Data Acquisition

Explores noise sources in data acquisition, including thermal, shot, and amplifier noise, as well as the effects of ADC noise.

Cascode: Output Impedance and Gain Analysis