Lecture

Operational Amplifier: Frequency-Independent Circuit

Graph Chat

Chat with Graph Search

Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.

DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.

Description

This lecture covers the design of a frequency-independent circuit using an operational amplifier, focusing on the comparison between different configurations and the general case. The instructor explains the voltage follower concept and provides examples with specific resistor values. The lecture also discusses the application of the circuit in electronic systems.

In MOOC

Electronics I

This course is an introduction to the realization of basic linear and non-linear functions using the operational amplifier. Students apply circuit theory, negative and positive feedback to operational amplifiers to realize elementary electronic functions (amplification, filtering, transposition, addition, subtraction, generation of periodic functions, etc.). Explanations are illustrated by laboratory exercises with demonstrations that can be reproduced by students through simulation.

Official source

Related concepts (17)

Amplifier

An amplifier, electronic amplifier or (informally) amp is an electronic device that can increase the magnitude of a signal (a time-varying voltage or current). It is a two-port electronic circuit that uses electric power from a power supply to increase the amplitude (magnitude of the voltage or current) of a signal applied to its input terminals, producing a proportionally greater amplitude signal at its output. The amount of amplification provided by an amplifier is measured by its gain: the ratio of output voltage, current, or power to input.

Operational amplifier

An operational amplifier (often op amp or opamp) is a DC-coupled high-gain electronic voltage amplifier with a differential input and, usually, a single-ended output. In this configuration, an op amp produces an output potential (relative to circuit ground) that is typically 100,000 times larger than the potential difference between its input terminals. The operational amplifier traces its origin and name to analog computers, where they were used to perform mathematical operations in linear, non-linear, and frequency-dependent circuits.

Resistor

A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to divide voltages, bias active elements, and terminate transmission lines, among other uses. High-power resistors that can dissipate many watts of electrical power as heat may be used as part of motor controls, in power distribution systems, or as test loads for generators.

Instrumentation amplifier

An instrumentation amplifier (sometimes shorthanded as in-amp or InAmp) is a type of differential amplifier that has been outfitted with input buffer amplifiers, which eliminate the need for input impedance matching and thus make the amplifier particularly suitable for use in measurement and test equipment. Additional characteristics include very low DC offset, low drift, low noise, very high open-loop gain, very high common-mode rejection ratio, and very high input impedances.

RLC circuit

An RLC circuit is an electrical circuit consisting of a resistor (R), an inductor (L), and a capacitor (C), connected in series or in parallel. The name of the circuit is derived from the letters that are used to denote the constituent components of this circuit, where the sequence of the components may vary from RLC. The circuit forms a harmonic oscillator for current, and resonates in a manner similar to an LC circuit. Introducing the resistor increases the decay of these oscillations, which is also known as damping.

Related lectures (36)

Analysis of Circuits with Dependent Sources

Explores the analysis of circuits with dependent sources, node-voltage analysis, Thévenin equivalent circuits, and OPAMP fundamentals.

Transistors: Understanding Behavior and Circuits

Explores transistors, from basic concepts to circuit applications, including current sources, amplifiers, followers, and switches.

The Frequency Response of RLC Circuits

Explores the frequency response of RLC circuits, operational amplifiers, and linear dependent sources, highlighting the historical significance of operational amplifiers.

Chopper Amplifier: Noise Reduction Techniques

Explores noise reduction techniques using chopper amplifiers in operational circuits.

Feedback and Stability