Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Lecture

Operational Transconductance Amplifiers: Evolution and Frequency Analysis

In course

EE-423: Low power electronics: analog mixed signal design

This course deals with the analyze, design and optimization of CMOS analog circuits, emphasizing low-power solutions required in a broad range of applications (e.g. IoT, wearables, Biosensors ...). Some examples of mixed-signal design are also addressed. ...

Description

This lecture covers the evolution of Operational Transconductance Amplifiers (OTAs) from general-purpose to specific-purpose designs, discussing the trade-offs between gain, bandwidth, and stability. It also delves into the frequency analysis of OTAs, including the impact of feedback on gain and bandwidth, as well as the Miller effect. The stability of multipole systems and the simulation of open-loop transfer functions are also explored.

This video is available exclusively on Mediaspace for a restricted audience. Please log in to MediaSpace to access it if you have the necessary permissions.

Watch on Mediaspace

Instructor

Adil Koukab

Official source

Related concepts (32)

Operational amplifier

An operational amplifier (often op amp or opamp) is a DC-coupled high-gain electronic voltage amplifier with a differential input and, usually, a single-ended output. In this configuration, an op amp produces an output potential (relative to circuit ground) that is typically 100,000 times larger than the potential difference between its input terminals. The operational amplifier traces its origin and name to analog computers, where they were used to perform mathematical operations in linear, non-linear, and frequency-dependent circuits.

Gain (electronics)

In electronics, gain is a measure of the ability of a two-port circuit (often an amplifier) to increase the power or amplitude of a signal from the input to the output port by adding energy converted from some power supply to the signal. It is usually defined as the mean ratio of the signal amplitude or power at the output port to the amplitude or power at the input port. It is often expressed using the logarithmic decibel (dB) units ("dB gain").

Negative-feedback amplifier

A negative-feedback amplifier (or feedback amplifier) is an electronic amplifier that subtracts a fraction of its output from its input, so that negative feedback opposes the original signal. The applied negative feedback can improve its performance (gain stability, linearity, frequency response, step response) and reduces sensitivity to parameter variations due to manufacturing or environment. Because of these advantages, many amplifiers and control systems use negative feedback.

Open-loop controller

In control theory, an open-loop controller, also called a non-feedback controller, is a control loop part of a control system in which the control action is independent of the "process output", which is the process variable that is being controlled. It does not use feedback to determine if its output has achieved the desired goal of the input command or process setpoint. There are many open-loop controls, such as on/off switching of valves, machinery, lights, motors or heaters, where the control result is known to be approximately sufficient under normal conditions without the need for feedback.

Simulation

A simulation is the imitation of the operation of a real-world process or system over time. Simulations require the use of models; the model represents the key characteristics or behaviors of the selected system or process, whereas the simulation represents the evolution of the model over time. Often, computers are used to execute the simulation. Simulation is used in many contexts, such as simulation of technology for performance tuning or optimizing, safety engineering, testing, training, education, and video games.

Related lectures (55)

Nyquist Stability Criteria

Explains Nyquist stability criteria and loop shaping for system performance and robustness.

Differential Amplifier Design

Covers the design of a differential amplifier with key parameters like gain and bias current.

Nyquist Introduction

Introduces the Nyquist criterion to determine system stability and covers BIBO stability and stability conditions.

Measuring Systems and Op-Amps: Applications in ECG and PPG

Explores voltage amplifiers, op-amp characteristics, and applications in ECG and PPG.

Multivariable Control: Design and Analysis