Concept
The Laird LC-EW was a six seat cabin sesquiplane designed for the industrialist George Horton. It first flew in 1934. Many Laird aircraft were designated as LC (Laird Commercial). In most cases this was followed by an airframe code, here E and an engine code, here W for Wasp. The LC-EW was designed to an order from the industrialist George Horton, who had previously owned the sole Laird LC-AA, first flown in 1928. It was a true sesquiplane, with a lower wingspan slightly less than half that of the upper. Both wings were essentially rectangular in plan out to rounded tips. The upper wing was built around spruce spars with plywood ribs and fabric covered. Upper and lower wings were braced together with parallel pairs of wide spread, transverse, streamlined V-struts on each side. Their apices on the lower wing were immediately above the landing legs. Between the fuselage and the legs the lower wing was constructed of Cr/Mo steel tubing and aluminium alloy-skinned; beyond, its structure was the same as that of the upper wing. Aluminium alloy ailerons were hinged only on the upper wings, filling about half the span. The inner lower wing carried flaps of similar construction. Both upper and lower wings contained fuel tanks. The LC-EW was powered by a , nine cylinder Pratt & Whitney Wasp C radial engine driving a two-bladed propeller and tightly enclosed under a long chord, NACA cowling, though bumped out over the rocker boxes to reduce its diameter. Aft, the fuselage was an all-metal aluminium alloy structure with multiple frames, stiffeners and metal skin. The pilots, or pilot and fifth passenger, sat side by side at the front of the cabin and had dual controls, including a central Y-type control column. Radio was fitted, with an external aerial. The ventilated, heated cabin had three windows on each side and was entered by a starboard-side door; its four passenger seats had safety belts. There was a baggage compartment and toilet at the rear. At the rear the tail was conventional with its cantilever tailplane at mid-fuselage.
