Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Concept

Dilatancy (granular material)

Related publications (28)

Modeling the mechanics and rheology of porous and granular media: an elastoplastic continuum approach

Lars Kristoffer Uhlen Blatny

The complex mechanics of porous and granular media play a significant role in various industrial processes and natural phenomena. As an example, understanding the mechanics of how failure occurs, localizes and propagates in porous brittle solids under vari ...

EPFL2023

The effects of a spur dike location in a 90° sharp channel bend on flow field: Focus on anisotropy degree and anisotropy nature

Anton Schleiss

In this research, the flow features around a spur dike located in a 90˚ sharp channel bend have been studied experimentally in detail. Results showed that the effects of the spur dike on upstream sections increased by increasing α (spur dike location from ...

2023

Exploring the potential of the critical shear crack theory for reinforced and post-tensioned glass beams: Initial analysis and experiments

Alain Nussbaumer, Pieter Christian Louter, Jagoda Cupac

In the evolution of structural glass beam elements, the requirements for post-fracture load bearing capacity and safe failure behaviour have led to the development of reinforced and post-tensioned beams. Maximum bending capacity in the post-fracture state ...

2023

Investigation of the effect of mineral dissolution on the geomechanical behaviour of geomaterials

Taeheon Kim

Geotechnical engineering scenarios engaged in internal erosion or mineral dissolution were found worldwide, from CO2 sequestration projects to internal erosion of earth dams. Materials subjected to loss of solid phase from their internal fabric vary from s ...

EPFL2022

Influence of depositional fabric on mechanical properties of naturally deposited sands

Edward Carlo Giorgio Andò

Fabric characteristics and shear deformation behaviour were analysed in four intact small-scale samples, including two disturbed and two undisturbed samples of naturally deposited sand from a shoal in the San Francisco Bay. Triaxial compression tests were ...

ICE PUBLISHING2022

Swelling and shrinkage of partially saturated gas shales: from laboratory tests to an effective stress framework

Jinwoo Kim

Gas shale swelling during hydraulic stimulation is one of the major challenges in unconventional gas development. It is hypothesized that the large volumetric strain upon water imbibition is a consequence of dramatic changes in capillary pressure and disjo ...

EPFL2022

Experimental quantification of 3D deformations in sensitive clay during stress-probing

Edward Carlo Giorgio Andò

Unique four-dimensional (4D) deformation data are collected during drained triaxial tests on intact specimens of a natural sensitive clay. This requires the development of a miniature triaxial cell for advanced stress path testing, specifically designed fo ...

ICE PUBLISHING2022

Particle-size segregation and rheology coupling in dense granular flows

Tomás Alfredo Trewhela Palacios

Dense granular flows -debris or pyroclastic flows, avalanches, granular flows in heaps, silos or rotating drums-are ubiquitous to many natural and industrial processes. Their grain composition is often polydisperse, with particles differing in shape, size ...

EPFL2021

On the effects of fluid pressure variations on rock-mass and fault mechanical behaviour

Corentin Jean-Marie Rémi Noël

In the past 20 years, the growing interest in deep geo-reservoirs for purposes such as carbon storage, waste water disposal, or geothermal energy exploitation have led to large-volume fluid injections into the upper continental crust. These fluid injection ...

EPFL2021

Shear Response of Wet Weak Carbonate Rock/Grout Interfaces Under Cyclic Loading

Eleni Stavropoulou

The development and construction of offshore wind farms requires the correct estimation of the friction that can be mobilised at the rock/grout interface. In conventional studies, the shear behaviour of a joint is usually investigated with laboratory tests ...

2021

Hydro-mechanical behaviour of a sandy silt from a river embankment

Alessio Ferrari

The paper presents the results of an experimental campaign aimed at characterizing the hydro mechanical behaviour of a sandy silt from a river embankment Due to continuous river level fluctuations and changing climatic and environmental conditions, flood e ...

E D P SCIENCES2020

A numerical study on the coupled hydro-mechanical behaviour of compacted bentonite

Lyesse Laloui, Alessio Ferrari, Jose Antonio Bosch Llufriu

Understanding the mechanical behaviour of compacted bentonite upon re-saturation is of outmost importance in most designs of nuclear waste disposal repositories. The behaviour of bentonite is characterized by its stress-path dependency and it is typically ...

EDP SCIENCES2020

The shear strength of Opalinus Clay shale in the remoulded state

Alessio Ferrari

The Opalinus Clay shale formation is considered as a potential host geomaterial for the Swiss deep geological repository for radioactive waste. It presents different facies and it is characterised by a multi-scale heterogeneous composition, by a typical fi ...

2020

Hydraulic stimulation of pre-existing discontinuities in tight rocks

Federico Ciardo

Hydraulic stimulation is an engineering technique whose aim is to enhance the permeability of fractured rock masses at depths ranging from one to five kilometers. It consists in the injection of fluid at sufficiently high pressure in order to shear pre-exi ...

EPFL2020

Interparticle Friction Leads to Nonmonotonic Flow Curves and Hysteresis in Viscous Suspensions

Matthieu Wyart, Hugo Robin Louis Perrin

Hysteresis is a major feature of the solid-liquid transition in granular materials. This property, by allowing metastable states, can potentially yield catastrophic phenomena such as earthquakes or aerial landslides. The origin of hysteresis in granular fl ...

American Physical Society2019

Out-of-equilibrium dynamical equations of infinite-dimensional particle systems I. The isotropic case

Elisabeth Agoritsas

We consider the Langevin dynamics of a many-body system of interacting particles in d dimensions, in a very general setting suitable to model several out-of-equilibrium situations, such as liquid and glass rheology, active self-propelled particles, and gla ...

2019

Anisotropic behaviour of Opalinus Clay through consolidated and drained triaxial testing in saturated conditions

Lyesse Laloui, Alessio Ferrari, Valentina Favero

This paper investigates the anisotropic hydro-mechanical behaviour of Opalinus Clay shale, the host material currently being considered for the construction of a nuclear waste repository in Switzerland. Consolidated and drained triaxial tests on Opalinus C ...

2018

Segregation of large particles in dense granular flows suggests a granular Saffman effect

Christophe Ancey, Kasper van der Vaart

We report on the scaling between the lift force and the velocity lag experienced by a single particle of different size in a monodisperse dense granular chute flow. The similarity of this scaling to the Saffman lift force in (micro-) fluids, suggests an in ...

2018

Micro-mechanical finite element modeling for in-plane behavior of historical masonry

Shenghan Zhang

Seismic assessment of unreinforced masonry structures remains a challenge. This dissertation investigates the in-plane behavior of historical masonry elements and proposes an advanced simulation method based on the cohesive zone model (CZM) in a finite ele ...

EPFL2018

Kinetics, Mechanics and Micro-structure of Bio-cemented Soils

Dimitrios Terzis

The quest for novel, performant materials and methods in the engineering practice is driven nowadays by the need to offer solutions to complex problems by coupling technical innovation with environmental responsibility. Such problems emerge in the geo-tech ...

EPFL2017