Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Concept

Phenol formaldehyde resin

Related publications (28)

VUV/UV light inducing accelerated phenol degradation with a low electric input

Juan Kiwi

This study presents the first evidence for the accelerated degradation of phenol by Fenton's reagent in a minifluidic VUV/UV photoreaction system (MVPS). A low-pressure mercury lamp used in the MVPS led to a complete degradation of phenol within 4-6 min. T ...

RSC Publishing2017

Adhesion and interfacial healing between supramolecular hybrid networks and glass substrates

Véronique Michaud, Federica Sordo

Adhesion towards glass and interfacial healing of partially supramolecular hybrid polymer networks featuring a range of H-bdnds content were investigated through two dedicated adhesion test methods. In a first series of tests, adhesion strength was measure ...

Elsevier2017

3D Printing of Polymers with Hierarchical Continuous Porosity

Dominique Pioletti, Pierre-Etienne Bourban, Matteo Gregorio Modesto Marascio, Jens Antons

Cellular thermoplastic structures with multiscale porosity (1–300 µm microporosity to 0.3–10 mm macroporosity) are produced from an integrated approach of 3D printing by Fused Deposition Modeling printing and Supercritical CO2 Foaming. Porous strands and r ...

Wiley2017

Influence of Ablation on Vacuum-Ultraviolet Radiation in a Plasma Wind Tunnel Flow

Pénélope Leyland

Plasma wind tunnel experiments have been performed simulating a Hayabusa reentry trajectory point at 78.8km altitude with a velocity of 11.7km/s corresponding to a local mass-specific enthalpy of 68.4MJ/kg and a stagnation pressure of 2.44kPa. Ablation-rad ...

American Institute of Aeronautics and Astronautics2017

Curing kinetics and thermomechanical properties of latent epoxy/carbon fiber composites

Jan-Anders Edvin Maansson, Véronique Michaud, Pierre-Etienne Bourban, Sara Dalle Vacche

In this work, resins based on diglycidyl ether of bisphenol A (DGEBA) epoxy and a latent hardener, dicyandiamide (DICY), as well as carbon fiber (CF) composites based on them, were prepared with three commercial accelerators: a methylene bis (phenyl dimeth ...

Iop Publishing Ltd2016

Mode I interlaminar fracture of carbon epoxy laminates: Effects of ply thickness

John Botsis, Joël Cugnoni, Thomas Gmür, Guillaume Frossard

In this work, the influence of ply thickness on strain energy release rate (ERR) in delamination of carbon epoxy laminates is addressed. Specimens with three ply thicknesses: 0.030, 0.075 and 0.150 mm are tested. While the ERR at onset of crack propagation ...

Elsevier2016

Design of Self-Healing Supramolecular Rubbers with a Tunable Number of Chemical Cross-Links

Véronique Michaud, Federica Sordo

Supramolecular rubbers incorporating a large number of physical cross-links through cooperative hydrogen bonds display high self-healing properties but limited solvent and creep resistance due to the lack of chemical cross-links. Increasing both chemical c ...

American Chemical Society2015

The effectiveness of resin-based repairs on the inert strength recovery of glass

Pieter Christian Louter

Glass used in buildings is often exposed to sources of surface damage which can have a significant effect on its strength. Existing research suggests that the flaws in glass can successfully be repaired by transparent polymeric resins, but the reasons for ...

Elsevier2015