Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Concept

Drilling fluid

Related publications (23)

Computational fluid dynamics simulations of the heat transfer properties of graphene-based nanolubricants and application to hydrodynamic lubrication

Roberto Guarino

In this paper, we consider experimental data available for graphene-based nanolubricants to evaluate their convective heat transfer performance by means of computational fluid dynamics (CFD) simulations. Single-phase models with temperature-dependent prope ...

Aip Publishing2024

Propagation of planar three-dimensional buoyant hydraulic fractures

Andreas Möri

Hydraulic fractures are driven by an internal fluid pressure exceeding the minimum compressive stress, propagating in a direction perpendicular to the latter. This class of tensile fractures has gained interest over the last fifty years due to the developm ...

EPFL2023

Measurement and modelling of dynamic fluid saturation in carbon reinforcements

Véronique Michaud, Baris Çaglar, Guillaume Clément Broggi, Helena Luisa Teixido Pedarros

We propose a methodology to monitor the progressive saturation of a non-translucent unidirectional carbon fabric stack through its thickness by means of X-ray radiography and extract the dynamic saturation curves using image analysis. Four constant flow ra ...

2023

Influence of Viscous Lubricant on Nucleation and Propagation of Frictional Ruptures

Marie Estelle Solange Violay, François Xavier Thibault Passelègue, Federica Paglialunga

Fluids are pervasive in the Earth's crust and saturate fractures and faults. The combination of fluids and gouge layers developing along faults can generate fluids of different viscosities. Such viscous fluids were found to influence the reactivation, fric ...

2023

Visualization and modelling of dynamic flow in fibrous preforms for liquid composite molding

Helena Luisa Teixido Pedarros

Nowadays, Liquid Composite Molding techniques are often used to manufacture high quality fiber reinforced composite parts at a relatively low cost. These involve an infiltration process, in which a liquid resin is forced to ingress into a dry fibrous porou ...

EPFL2023

Hydro-mechanichal characterisation of bentonite/steel interfaces

Alessio Ferrari, Eleni Stavropoulou

The hydromechanical response of a Wyoming-type bentonite (MX-80) and its interface with steel was studied in terms of shear resistance under different hydration levels. A series of shear tests under constant normal stress were performed in total suction co ...

2023

Permeability sets the linear path instability of buoyancy-driven disks

François Gallaire, Pier Giuseppe Ledda, Giuseppe Antonio Zampogna

The prediction of trajectories of buoyancy-driven objects immersed in a viscous fluid is a key problem in fluid dynamics. Simple-shaped objects, such as disks, present a great variety of trajectories, ranging from zig-zag to tumbling and chaotic motions. Y ...

Cambridge University Press2023

Stress induced delamination of suspended MoS2 in aqueous environments

Aleksandra Radenovic, Michal Daniel Macha, Sanjin Marion, Mukeshchand Thakur

Applying hydrostatic pressure with suspended 2D material thin membranes allows probing the effects of lateral strain on the ion and fluid transport through nanopores. We demonstrate how both permanent and temporary delamination of 2D materials can be induc ...

ROYAL SOC CHEMISTRY2022

Flow pattern observations and flow pattern map for adiabatic two-phase flow of carbon dioxide in vertical upward and downward direction

Jürg Alexander Schiffmann, Rémi Revellin, David Schmid

A test facility to investigate flow pattern transitions of vertical two-phase flow of CO2 has been built within the scope of the high-luminosity detector upgrades at the European Organization for Nuclear Research (CERN). Adiabatic flow pattern observations ...

2022

A new insight into the dynamic impact between geophysical flow and rigid barrier

Xingyue Li

Understanding the interaction between complicated geophysical flows and barriers remains a critical challenge for hazards countermeasures in engineering design. In this study, the impact of geophysical flows on a rigid barrier is studied numerically using ...

ELSEVIER SCI LTD2022

Improving the Accuracy of Fracture Toughness Measurement in Burst Experiments

Guanyi Lu

Experimental studies suggest that the fracture toughness of rocks increases with the confining pressure. Among many methods to quantify this dependency, a so-called burst experiment (Abou-Sayed, 1978) may be the most widely applied in practice. Its thick w ...

SPRINGER WIEN2022

Experimental Investigation of Hydraulic Fracture Closure in a Porous Sandstone

Brice Tanguy Alphonse Lecampion, Seyyedmaalek Momeni, Guanyi Lu, Mohsen Talebkeikhah

Depending on the type of fracture propagation regime when the injection stops, the closure of the fracture may occur exactly after the injection ceases, in the case where the fracturing process is dominated by fracture energy, or the fracture propagate for ...

Onepetro2022

Quantifying the transition of impact mechanisms of geophysical flows against flexible barrier

Xingyue Li

Flexible barriers have been increasingly used worldwide for mitigating natural hazards involving various geophysical flows. The analysis and design of flexible barriers need to distinguish two major impact mechanisms, runup and pile-up, which remain poorly ...

ELSEVIER2021

On the effects of fluid pressure variations on rock-mass and fault mechanical behaviour

Corentin Jean-Marie Rémi Noël

In the past 20 years, the growing interest in deep geo-reservoirs for purposes such as carbon storage, waste water disposal, or geothermal energy exploitation have led to large-volume fluid injections into the upper continental crust. These fluid injection ...

EPFL2021

Effect of Fluid Viscosity on Earthquake Nucleation

Marie Estelle Solange Violay, Chiara Cornelio

Injection of fluids in geo-reservoirs can reduce the effective stresses at depth, lubricating the nearby faults, promoting slip and, potentially, earthquakes. High-viscous fluids are often used during hydraulic fracturing and production phases in geo-reser ...

2020

Experimental studies of hydro-mechanical couplings in Enhanced Geothermal Reservoirs

Mateo Alejandro Acosta

Enhanced Geothermal Systems (EGS) allow for worldwide geothermal electricity production. They target deep (3-5 km), fractured rock reservoirs whose permeability is artificially increased through hydraulic stimulations (fluid injections). The injections mod ...

EPFL2020

Modeling snow and avalanches with the Material Point Method and finite strain elastoplasticity

Johan Alexandre Philippe Gaume, Xingyue Li, Lars Kristoffer Uhlen Blatny, Bertil Trottet

Snow is a complex and fascinating material which can sustain stresses like a solid or flow like a fluid depending upon the load it is subjected to. The transition from solid to fluid state can lead to catastrophic snow slab avalanches. Modeling large defor ...

The Alliance of Laboratories in Europe for Education, Research and Technology2020

Modeling turbulent stream flows over rough permeable beds

Christophe Ancey, Ivan Pascal, Gauthier Paul Daniel Marie Rousseau

In steep streams, turbulent flows run over coarse sediments that are similar in size to flow depth. Under these conditions, a significant part of the flow may seep through the permeable bed. Based on experimental data, this paper presents a model able to r ...

CRC Press2020

Hydraulic Transport Through Calcite Bearing Faults With Customized Roughness: Effects of Normal and Shear Loading

Marie Estelle Solange Violay, Mateo Alejandro Acosta

Understanding fluid flow in rough fractures is of high importance to large scale geologic processes and to most anthropogenic geo‐energy activities. Here we conducted fluid transport experiments on Carrara marble fractures with a novel customized surface t ...

2020

Microfluidics of binary liquid mixtures with temperature-dependent miscibility

Esther Amstad, Stefan Guldin

Liquid-liquid microfluidic systems rely on the intricate control over the fluid properties of either miscible or immiscible mixtures. Herein, we report on the use of partially miscible binary liquid mixtures that lend their microfluidic properties from a h ...

ROYAL SOC CHEMISTRY2020