Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Concept

Formwork

Related publications (29)

A concrete answer for circular construction: three prototypes reusing saw-cut elements

Corentin Jean Dominique Fivet, Maléna Bastien Masse, Célia Marine Küpfer

Existing concrete buildings should be retained for as long as possible to reduce the environmental burden of demolition and new construction. However, when urban pressure makes demolition unavoidable, salvaging and reusing concrete elements elsewhere in ne ...

2024

FLO:RE – A new floor system made of reused reinforced concrete and steel elements

Corentin Jean Dominique Fivet, Numa Joy Bertola, Maléna Bastien Masse, Célia Marine Küpfer

Carefully extracting reinforced concrete (RC) elements from soon-to-be demolished structures and reusing them as load-bearing components is an emerging circular low-carbon alternative to building new structures. As floor construction typically accounts for ...

IABSE2024

Estimation of the bar stress based on crack width measurements in reinforced concrete structures

Aurelio Muttoni, Enrique Corres Sojo

Estimating the stress of reinforcing bars and its variations in service conditions can be useful to determine the reserve capacity of structures or to assess the risk of fatigue in the reinforcement. This paper investigates the use crack width measurements ...

Ernst & Sohn2024

Contributions to rebar-to-concrete interaction and its structural implications for design and monitoring applications

Enrique Corres Sojo

Bond between reinforcing bars and concrete has been the focus of extensive research over the last century. This is well-justified as the functioning of reinforced concrete intimately depends on the interaction between rebar and concrete, as for example cra ...

EPFL2024

Experimental investigation of dowel action in reinforcing bars using refined measurements

Aurelio Muttoni, Marko Pejatovic

In typical reinforced concrete design, reinforcement is designed to carry axial forces, but it can also resist transversal forces by dowel action. This is usually neglected for simplicity's sake in the design phase, but it can be accounted for either expli ...

Ernst & Sohn2024

Structural component reuse of precast and cast-in-place reinforced concrete in architecture since the late 1960s in Europe

Corentin Jean Dominique Fivet, Célia Marine Küpfer

The reuse of concrete pieces salvaged from structures undergoing transformation or demolition into new architectural projects has gained a sudden and visible interest over the past five years. However, the practice of reusing concrete pieces in new structu ...

vdf Hochschulverlag AG2024

Experimental and analytical investigation of shear-reinforced concrete and dowel action

Marko Pejatovic

Codes of practice can be overly conservative, particularly for the shear resistance of reinforced concrete beams with shear reinforcement when large loads act close to supports. This thesis addresses the topic by proposing a refined design approach based o ...

EPFL2024

Experimental testing and structural analysis of composite tile – reinforced concrete domes

Savvas Saloustros

Conventional formworks for concrete curved shells either are expensive, complex and wasteful or have formal restrictions. Using tile vaults (also known as timbrel, Guastavino, thin-tile or Catalan vaults) as stay-in-place formwork for concrete shells could ...

2023

Panorama of approaches to reuse concrete pieces: identification and critical comparison

Corentin Jean Dominique Fivet, Célia Marine Küpfer

Practices that reuse concrete pieces in new building or infrastructure projects are currently diversifying as concrete reuse gains more and more relevance for sustainability. The present research provides a yet missing identification of the main approaches ...

IOP Publishing2023

Environmental and Life-Cycle Cost Evaluation of a Composite Timber-UHPFRC Bridge

Eugen Brühwiler, Numa Joy Bertola

Ultra-High-Performance Fibre Reinforced Cementitious Composite (UHPFRC) has recently been used to design lightweight structures and strengthen existing ones, with more than 300 applications in Switzerland. Several composite timber-UHPFRC bridges have been ...

2023

Low-tech methods for the reuse of reinforced concrete structural elements

Corentin Jean Dominique Fivet, Maléna Bastien Masse, Julie Rachel Devènes, Nicole Widmer

Most of existing buildings are made of concrete, new buildings are being built with it and others are demolished when still in good structural condition. This drives increased demands for raw materials, greenhouse gas emissions, and an accumulation of demo ...

2023

Design of New Low-Carbon Floor Systems by Reusing Cut Cast-in-Place Concrete Pieces

Corentin Jean Dominique Fivet, Numa Joy Bertola, Célia Marine Küpfer

As floors typically account for the largest share of a building embodied carbon footprint, new strategies to build low-carbon floors must be developed and implemented. Among these strategies, the reuse of existing components is a promising circular approac ...

Novus Press2023

Validation of bond models for the crack width estimation based on detailed measurements

Aurelio Muttoni, Enrique Corres Sojo

Crack formation and development in reinforced concrete structures is a complex mechanism affected by a large number of factors. Typically, the estimation of the crack width as a function of the reinforce-ment stress state is based on simplified assumptions ...

2022

Re:Crete – reuse of concrete elements in new structures: A footbridge prototype

Corentin Jean Dominique Fivet, Maléna Bastien Masse, Jan Friedrich Georg Brütting, Célia Marine Küpfer, Julie Rachel Devènes

Concrete accounts for the largest share of worldwide building material use and waste generation, with cement production being responsible for approximately 9% of global anthropogenic CO2 emissions. A currently untapped strategy to significantly reduce thes ...

CRC Press2022

Environmental and economic analysis of new construction techniques reusing existing concrete elements: two case studies

Corentin Jean Dominique Fivet, Maléna Bastien Masse, Célia Marine Küpfer, Julie Rachel Devènes

As the most widely used construction material worldwide, concrete is the main cause of greenhouse gas emissions, material depletion, and waste generation by the construction industry. Typically, concrete waste is crushed and, at best, reclaimed into recycl ...

2022

Fire performance evaluation of GFRP-balsa sandwich bridge decks

Niloufar Vahedi

Bridges are a critical component of national infrastructures and economies. A significant percentage of bridges built all around the world are made of reinforced concrete which according to building codes have a life span between 80-100 years. However, str ...

EPFL2022

A consistent safety format and design approach for brittle systems and application to textile reinforced concrete structures

Aurelio Muttoni, Miguel Fernández Ruiz, Patrick Lorenzo Valeri, Qianhui Yu

Design and verification of structures in modern codes of practice account for a safety format, ensuring that the probability of failure does not exceed a given threshold. Although specific safety formats are proposed in some cases for special types of stru ...

2021

Flexural behaviour of post-tensioned glass beams: Experimental and analytical study of three beam typologies

Alain Nussbaumer, Pieter Christian Louter, Jagoda Cupac

The concept of post-tensioned glass beams builds on the concrete analogy of the reinforced glass beams. By additionally prestressing the reinforcement in a post-tensioned system, a compressive pre-stress is applied on the glass, enhancing the initial fract ...

2021

RC U-shaped walls subjected to in-plane, diagonal, and torsional loading: New experimental findings

Katrin Beyer

Although reinforced concrete U-shaped walls are popular in construction practice internationally, there is a paucity of experimental research investigating the seismic performance of such salient elements. The present paper summarizes an experimental campa ...

2021

An Analytical Method to Predict the Structural Behavior of Timber-Concrete Structures With Brittle-to-Ductile Shear Connector Laws

Eugen Brühwiler

Timber-Concrete Composite (TCC) structures allow taking synergistic advantage of the properties of both materials to optimize the overall performances in terms of lightness, slenderness, acoustic insulation, vibrational behaviour and environmental footprin ...

ELSEVIER SCI LTD2020